Philips HP4666/00 Manual de usuario
2
1
EN
English
Congratulations on your purchase, and welcome to Philips!To fully
benet from the support that Philips offers, register your product at
www.philips.com/welcome.
1 Important
Read this user manual carefully before you use the appliance and keep
it for future reference.
WARNING: Do not use this appliance near bathtubs,
•showers, basins or other vessels containing water.
Before you connect the appliance, ensure that the
•voltage indicated on the appliance corresponds to the local
power voltage.
Do not use the appliance for any other purpose than described
•in this manual.
Only use the appliance on dry hair. Do not use the appliance on
•articial hair.
Keep the hot surfaces of the appliance away from your skin.
•When the appliance is connected to the power, never leave it
•unattended.
Always unplug the appliance after use.
•When the appliance is hot, keep it on a heat-resistant surface
•and never cover the appliance with anything, such as a towel or
clothing.
If you use any accessory or part from other manufactures or that
•Philips does not recommend, your guarantee becomes invalid.
Do not wind the mains cord round the appliance.
•If you use the appliance on color-treated hair, the straightening
•plates may stain.
EN
If the mains cord is damaged, you must have it replaced by
•Philips, a service centre authorised by Philips or similarly qualied
persons in order to avoid a hazard.
This appliance is not intended for use by persons (including
•children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play
•with the appliance.
For additional protection, we advise you to install a residual
•current device (RCD) in the electrical circuit that supplies the
bathroom.This RCD must have a rated residual operating
current not higher than 30mA. Ask your installer for advice.
Electromagnetic elds (EMF)
This applicance complies with all standards regarding
electromagnetic elds (EMF). If handled properly and according to
the instructions in this user manual, the applicance is safe to use
based on scientic evidence available today.
Environment
When you see the crossed-out wheel bin symbol
attached to a product, it means the product is covered
by the European Directive 2002/96/EC:
Never dispose of your product with other household waste. Please
inform yourself about the local rules on the separate collection of
electrical and electronic products. The correct disposal of your old
product helps prevent potentially negative consequences on the
environment and human health.
EN
2 Straighten your hair
Ensure that you select a temperature setting that is suitable for your hair.
Always select a low setting when you use the straightener for the rst
time.
Hair Type Temperature Setting
Coarse, curly,hard-to-straighten Mid to High (170 ºC and above)
Fine, medium-textured or softly
waved
Low to Mid (160 ºC and below)
Pale, blonde, bleached or color-
treated
Low (Below 160 ºC)
1Connect the plug to a power supply socket.
2Press and hold the button (Fig. 1) until the light on the display is
on.
The default temperature setting is displayed.»
The SONIC indication turns on.»
3Press the button to select a suitable temperature
setting for your hair.
When the straightener heats up to the selected temperature»
setting, the READY indication turns on.
The remaining usage time of the straightener is displayed.»
4Comb your hair and take a section that is not wider than 5cm
for straightening.
5Place it between the straightening plates and press the handles
together.
The sonic vibration starts.»
6Slide the straightener down the length of the hair in a single
motion (max. 5 seconds) from root to end.
EN
7After 20 seconds, repeat step 6 until you achieve the desired
look.
8 To straighten the rest of your hair, repeat steps 4 to 7.
To switch sonic vibration off, press the
• button (Fig. 2) until
the SONIC indication turns off.
To resume sonic vibration, press the
• button again.
After you straighten your hair,
1Disconnect the straightener.
2Place it on a heat-resistant surface until it cools down.
3Keep the straightening plates clean and free of dust and dirt.
For storage, you can also hang it with the hanging loop.
•
3 Guarantee and service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care Centre
in your country (you nd its phone number in the worldwide guarantee
leaet).
© Royal Philips Electronics N.V. 2009
All rights reserved.
Specications are subject to change without notice.
Trademarks are the property of Koninklijke Philips
Electronics N.V. or their respective owners.
Printed in China PDCC-2009
3140 035 21441
Tabla de contenidos
Otros manuales de Peinador de cabello de Philips
Philips
Philips HP4640/00 Manual de usuario
Philips
Philips HP8651 Manual de usuario
Philips
Philips Salon Airstylist Pro HP4671 Manual de usuario
Philips
Philips HP4681 Manual de usuario
Philips
Philips HP4698 Manual de usuario
Philips
Philips HP8605/00 Manual de usuario
Philips
Philips HP8361/01 Manual de usuario
Philips
Philips BHS376 Manual de usuario
Philips
Philips HPS940 Manual de usuario
Philips
Philips QS6160 Manual de usuario
Philips
Philips HP 4630 Manual de usuario
Philips
Philips HP8651 Manual de usuario
Philips
Philips Airstylist quattro 600 Manual de usuario
Philips
Philips Salon AirStylist Essential HP4624/00 Manual de usuario
Philips
Philips HP4696/10 Manual de usuario
Philips
Philips HP8665/80 Manual de usuario
Philips
Philips HP4681/17 Manual de usuario
Philips
Philips HP8300 Manual de referencia
Philips
Philips HP4654/00 Manual de usuario
Philips
Philips SalonStraight Petite HP8300/00 Manual de usuario
