PhaseOne iXG Manual
Phase One iXG Camera
Sensor Cleaning Procedure
Ver. 1.2
Phase One 2014-2018 90040957
Phase One iXG Camera Sensor Cleaning Procedure
2
Contents
Phase One iXG Camera .......................................................................................... 1
Sensor Cleaning Procedure .................................................................................... 1
Introduction........................................................................................................... 3
Required tools.................................................................................................... 3
Dismounting a Lens from the iXG Camera.............................................................. 4
Cleaning the Camera’s Sensor................................................................................ 5
Reassembling the Camera Body in Place................................................................ 7
Mounting a Lens .................................................................................................... 7
Phase One iXG Camera Sensor Cleaning Procedure
3
Introduction
This procedure shows how to clean the sensor on iXG camera.
The procedure is done in four steps:
1. Removing the lens
2. Cleaning the camera interior and sensor module
3. Reassembling the camera body
4. Mounting the lens
Required tools
Before you start, make sure that you have the following:
•A clean, dry place to perform the service
•Hex #2.5mm screwdriver
Torque handle set to 70cNm
2.5mm x 100mm Hex head bit
•Phase One cleaning kit
Phase One iXG Camera Sensor Cleaning Procedure
4
Dismounting a Lens from the iXG Camera
Lenses on the iXG series of cameras are easily dismounted.
NOTE: Ensure that you only dismount lenses in a clean environment. Place the detached lens
on a soft cloth on the table to avoid scratching the lens.
To dismount the lens:
Release the lens' locking levers.
Remove the lens by pulling it gently away from the camera.
NOTE: If no lens is being mounted, ensure that the camera is stored in a way that protects it
from dust, moisture and other damage. When the iXG camera is mounted facing down, always
make sure (double check) that the lens is well secured by having the lens locking levers
engaged.
Cover the front of the camera to prevent damage to the sensor.
With a 2.5mm hex screwdriver, release the four camera module screws and lift
the entire camera body, place it on a clean surface.
Note: Make sure that the sensor module is well protected.
Phase One iXG Camera Sensor Cleaning Procedure
5
Cleaning the Camera’s Sensor
Locate the small plastic wiper and identify the size that fits your sensor size.
Fold one cloth and fold this over the wiper so that you have two layers of
cloth.
Apply 2-3 drops of Eclipse fluid to the edge of the folded cloth.
Phase One iXG Camera Sensor Cleaning Procedure
6
In one move, swipe the surface of the sensor in one direction from start to
finish.
Inspect the sensor and check to see if it is clean by holding it near a light. And/
or with a magnifying glass
If necessary, move the cloth layer one centimeter on the wiper and repeat the
process. Never swipe twice with the same area of the cloth.
Phase One iXG Camera Sensor Cleaning Procedure
7
Reassembling the Camera Body in Place
Realign the camera body into place.
Tighten the captive screws with a torque of 70cNm.
Mounting a Lens
NOTE: Before mounting or dismounting a lens, ensure that the power cable is not attached to
the camera.
Place the Lens over the iXG camera body and guide it into position against the
camera body using the two large positioning pins.
Phase One iXG Camera Sensor Cleaning Procedure
8
Close the Lens locking levers.
Note: The Lens is a-symmetrical, and can only be fitted in ONE position.
Replace the lens, take and inspect image. We recommend photographing a
uniform grey or white paper or an image that is diffused by holding an opaque
filter in from of the lens
Repeat the above steps as necessary until the sensor is clean
© Phase One 2014-2017 90040957 - iXG Camera Sensor Cleaning Procedure 1.2
Otros manuales para iXG
1
Tabla de contenidos
Otros manuales de Cámara digital de PhaseOne
PhaseOne
PhaseOne iXR Manual de usuario
PhaseOne
PhaseOne XT Manual de usuario
PhaseOne
PhaseOne iXH Manual de usuario
PhaseOne
PhaseOne DJI M600 Manual de usuario
PhaseOne
PhaseOne 645DF Manual de usuario
PhaseOne
PhaseOne 645 AF Manual de usuario
PhaseOne
PhaseOne P 65+ Manual de usuario
PhaseOne
PhaseOne XF Manual de usuario
PhaseOne
PhaseOne iXM-GS120 Manual de usuario
PhaseOne
PhaseOne iXU-RS Manual de usuario
PhaseOne
PhaseOne P 65+ Manual de usuario
PhaseOne
PhaseOne iXG Manual de usuario
PhaseOne
PhaseOne XF Manual de usuario
PhaseOne
PhaseOne Studiokit Manual de usuario
PhaseOne
PhaseOne XF IQ4 Manual de usuario
PhaseOne
PhaseOne P 25 Manual de usuario
PhaseOne
PhaseOne 645DF Manual de usuario
PhaseOne
PhaseOne 645DF Manual de usuario
PhaseOne
PhaseOne iXU-RS 1900 Manual de usuario
PhaseOne
PhaseOne 645DF Manual de usuario
