Phaesun SPR Caravan Kit Solar Peak Five 3.0 Manual de usuario
Phaesun GmbH · Brühlweg 9 · 87700 Memmingen · Germany | Telefon +49 (8331)990 42 0 · Telefax +49 (8331)990 42 12 | info@phaesun.com · www.phaesun.com
1
600109 • 05/2014
Manual
SPR Caravan Kit Solar Peak Five 3.0
Step 1
Please observe the manual of
the manufacturer when you
glue the assembly profiles and
fasten the solar module. Please
make sure to keep the module
cable clamps accessible after
glueing.
Glue assembly profiles and fix solar module
Solar module
Module fixture kit
Glue set
For the installation you need well isolated tools:
small screwdriver pliers carpet knife
General safety instructions
Solar modules generate electricity in low incidence of light
too! Cover the solar panel and work carefully!
Make sure that the installation of the solar charge controller
takes place in a stable, flat and dry environment. Please note
to keep a distance of 15 cm around the unit!
Danger of explosion due to improper handling of batteries!
Danger of receiving an acid burn through the battery acid!
Keep children away from batteries and acid!
Please note the operating instructions of the solar charge
controller, the solar module and the battery as well!
When connecting the cables, make sure the polarity is correct!
All work must be carried out in compliance with the national
provisions and the local regulations!
Do not use defective components and keep the intended use
of the system!
Phaesun GmbH · Brühlweg 9 · 87700 Memmingen · Germany | Telefon +49 (8331)990 42 0 · Telefax +49 (8331)990 42 12 | info@phaesun.com · www.phaesun.com
3
56
4
600109 • S. 2
Step 3
Strip the insulation off the
module cable. Carefully cut a
piece of the upper coating and
remove it,so two individual
wires appear.
Step 4
Strip 10 mm of the insulation.
Carefully cut the two wires and
remove the coating..
Step 5
Fix the blade receptacle on the
wires.
Step 6
Identify the contacts for the
solar module on the solar
charge controller. Lead the
positive wire into the positive
contact (+) and the negative
wire (marked in blue) in the
negative contact.
Connect solar module with solar charge controller
Charge controller
Module cable
Step 2
Please find the instructions for
connecting the battery in the
charge controller manual.
Connect battery with solar charge controller
Step 7
Connect the solar module with
the solar charge controller.
7
Otros manuales de Inversor de Phaesun
