pewag bluetrack duo perfekt Manual de usuario
Seite 1 von 2
Welding Instruction
Welding fillers to use:
Recommended rod electrode
►BÖHLER FOX 7018 (or similar)
Recommended wire electrode
►BÖHLER EMK 6 TOP (or similar)
General information:
To avoid cracks in the material, a pre-heating of the base material of min. +80 ° C is
recommended.
The welding area at the pewag bluetrack should be dry and clean before welding the
stub.
The welding seam should not be more than 5 mm.
Instruction:
To avoid excessive heating of the base
material please follow the steps below:
If possible, please always work on two
profiles at the same time.
Please weld only ¼ of a pewag
bluetrack stub at the beginning, see
red marking step 1 –4.
The next step is to weld ¼ of the stub
on the backside, see red marking
step 5 –8.
Seite 2 von 2
Now start to finish the welding on each
side of the stubs, see blue marking.
Start first with step 1 –4 and then
continue with step 5 –8 as shown in
the illustration.
Leave yourself enough time between
the process steps so that the material
is allowed to cool down.
To continue with the next two profiles
please start at the beginning of this
instruction.
Technical changes and misprints excepted.
Este manual sirve para los siguientes modelos
4
Tabla de contenidos
Otros manuales de Accesorios para automóviles de pewag
pewag
pewag FM 73 Guía del usuario
pewag
pewag AUSTRO-S Manual de usuario
pewag
pewag servostar Guía del usuario
pewag
pewag AUSTRO-S Manual de usuario
pewag
pewag snox SXP Series Guía del usuario
pewag
pewag Profilift AOR 10 Manual de usuario
pewag
pewag Universal ED Manual de usuario
pewag
pewag erzberg ED Manual de usuario
pewag
pewag RSC Guía del usuario
pewag
pewag forstgrip Guía del usuario
