PerkinElmer S20 Series Manual de usuario

S20 Series Autosampler Installation Guide

Unpack and place the autosampler on the bench, as close as

possible to the analytical instrument. To lift, place one hand

under the back of the autosampler. Place the other hand along

the front of the top cover to steady the autosampler. Do not

lift by the removable tray.

Gently tug the front of the removable tray upward to verify

that it is firmly attached to the base of the autosampler.

(Optional) If you need to re-seat the removable tray, lower it

straight down then push it straight back.

Insert the dual rinse station in the holder at the back left

corner of the tray. Press straight down until it is fully seated.

TIP: If you find it difficult

to get a good connection

to the rinse station,

remove the rinse station

and press the tubing firmly

so that it completely covers

the barb of the fitting. It

helps to use your other

hand to apply counter-

pressure.

Connect the RINSE IN

tubing to channels 2 and 3

of the peristaltic pump on

the autosampler (2 mm I.D.

pump tubing).

Connect the WASTE tubing

to channel 1, closest to the

back of the autosampler

(3.2 mm I.D. pump tubing).

Ensure that the drain tubing

is not submerged in the

waste liquid.

A dual-rinse, pumped-drain tubing arrangement is shown. Your application may need a different arrangement—see the

User’s Guide

Carefully press the tubing straight on to the fittings as shown below.

Install the sample probe: Route the sample tubing through the loop on the Z-drive. Raise the slider on the Z-drive to its highest position

and guide the probe straight down until the tip of the probe is level with the bottom of the Y arm. Tighten the two thumbscrews.

Connect the power supply to the back of the autosampler.

Connect the USB cable between the PC and autosampler.

For ICP-MS with HTS, use a serial cable—see the

User’s Guide.

Turn on the autosampler.

Turn the PC off then on to initialize communication.

The autosampler is now ready to use.

See the

S20 Autosampler User’s Guide

(on the included flash

drive) for safety information, maintenance information, and

detailed instructions.

Consultez le « S20 Autosampler User’s Guide » (présent sur

la clé USB fournie) pour les informations de sécurité, les

informations d’entretien et des instructions détaillées.

S23 autosampler after assembly.

Standard Tubes

Y Arm

Z Drive

Sample Tubing

Sample Probe

Sample Probe Holder

Dual Rinse Station

Sample Tubes

Removable Sample Racks

Removable Tray

Part Number 09931598

Release A, February 2020

32-0775-048

Printed in USA

Sample Tubing Loop

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Equipo de laboratorio de PerkinElmer

PerkinElmer

PerkinElmer Raman Micro 200 Series Manual de usuario

PerkinElmer

PerkinElmer QuickSTAR Horizon Manual de usuario

PerkinElmer

PerkinElmer Panthera-Puncher 9 Manual de usuario

PerkinElmer

PerkinElmer Clarus SQ 8 MS Series Instrucciones de instalación

PerkinElmer

PerkinElmer Spotlight 150 Manual de usuario

PerkinElmer

PerkinElmer Clarus 600/560 D MS Instrucciones de instalación

PerkinElmer

PerkinElmer PINAACLE 900 Series Manual de usuario

PerkinElmer

PerkinElmer AVIO 500 Manual de usuario

PerkinElmer

PerkinElmer LED Solutions ACULED Designer Kit Silver Manual de usuario

PerkinElmer

PerkinElmer Clarus SQ 8 MS Series Instrucciones de instalación

PerkinElmer

PerkinElmer OPTIMA 8000 Manual de usuario

PerkinElmer

PerkinElmer OPERA PHENIX PLUS Manual de usuario

PerkinElmer

PerkinElmer OMNI Bead Ruptor Elite Manual de usuario

PerkinElmer

PerkinElmer RamanStation 400 Series Manual de usuario

PerkinElmer

PerkinElmer Lambda 365 Peltier Temp Ctrl Unit Multi Manual de usuario

PerkinElmer

PerkinElmer TGA 8000 Instrucciones de montaje

PerkinElmer

PerkinElmer TORION T-9 Manual de usuario

PerkinElmer

PerkinElmer FL 6500 Manual de usuario

PerkinElmer

PerkinElmer RamanStation 400 Series Manual de usuario

PerkinElmer

PerkinElmer AVIO 200 Instrucciones de instalación

PerkinElmer

PerkinElmer CLARUS 680 GC Manual de usuario

PerkinElmer

PerkinElmer Panthera-Puncher 9 Manual de usuario

PerkinElmer

PerkinElmer TriNEST Manual de usuario

PerkinElmer

PerkinElmer Spectrum 100 Series Manual de usuario

Manuales populares de Equipo de laboratorio de otras marcas

Qiagen

Qiagen DML 3000 Manual de usuario

Queensgate

Queensgate NANOSCAN OP400 Manual de programación

Conviron

Conviron GEN1000-GE Manual de usuario

Parr Instrument

Parr Instrument 4560 Manual de instrucciones

IKA

IKA IC control Manual de usuario

Integra

Integra DOSE IT Manual de usuario

Agilent Technologies

Agilent Technologies 5800 ICP-OES Manual de usuario

Endress+Hauser

Endress+Hauser Cleanfit CPA875 Manual de usuario

NI PXI-5422 Manual

Collomix

Collomix Aqix Manual de usuario

SPEX SamplePrep

SPEX SamplePrep 6875 Freezer/Mill Series Manual de usuario

Ocean Insight

Ocean Insight FLAME-NIR+ Manual de usuario

Parker

Parker ALIGN-MG-NA Manual de usuario

BD 644787 Manual de usuario

DENTAURUM

DENTAURUM Compact Megaplus Manual de usuario

Biuged Laboratory Instruments

Biuged Laboratory Instruments BGD 626 Manual de usuario

VWR

VWR SAS Super IAQ Manual de usuario

illumina

illumina MiSeqDx Manual de usuario