Peripheral Electronics PXAMG Manual de usuario

Peripheral Electronics®,

a division of AAMP of America™

13160 56th Court Clearwater, Florida 33760

Ph. 866-788-4237

[email protected]

add iPod®

(if equipped)

HD RadioTM Tuner

HDRT

HD RadioTM Tuner

Owner’s

Manual

Installation and

Operation

Peripheral Electronics®

a division of AAMP of America™

13160 56th Court Clearwater, Florida 33760

Ph. 866-788-4237

[email protected]

Table of Contents

Pages

1. Introduction 1

2. Precautions 1

3. Compatibility Notes 2

4. Programming the

Media Gateway (PXAMG) 2

5. Installation 3-4

6. HD Radio Operation 5

6.1 Selecting HD Radio 5

7. iPod Operation 6

7.1 Selecting the iPod (if equipped) 6

Controls 6-7

Browse by Artist 7

Browse by Album 8

Browse by Genre 9

Browse by Playlist 10

8. Selecting Factory Satellite 10

(if equipped)

9. Troubleshooting/Warranty 11-12

Peripheral Electronics®

a division of AAMP of America™

13160 56th Court Clearwater, Florida 33760

Ph. 866-788-4237

[email protected]

iPod

Not Included

Media Gateway & Optional Add-ons

HD Radio

Tuner

HDRT

Automotive Media Gateway

PXAMG

Media Gateway Harness

Part #: PGHFD1

LCD Retention Harness

Part #: PGHFD1A*

Factory Radio

Not Included

iPod

Not Included

Media Gateway

Part #: PXAMG

3Ft. HD Radio Cable

11Ft. iPod Cable

HD RadioTM Tuner

Part #: HDRT

Antena Adapter

* Required for 2008 Escape, Mariner and Focus.

1. Introduction

Thank you for purchasing the Peripheral Electronics®Media Gateway.

The Media Gateway is designed to provide endless hours of listening

pleasure from your factory radio. To ensure that your HD Radio tuner

or iPod performs correctly with your radio, we recommend that you

read this entire manual before attempting installation of the Media

Gateway.

The Media Gateway allows connectivity for HD Radio and iPod,

enabling full control of these devices from the factory installed radio.

It also retains original system features such as satellite radio and

rear seat entertainment (if equipped).

Application Guide

* www.peripheralelectronics.com (Click on “Application Guide” link.)

2. Precautions

UPDATING iPod FIRMWARE

For proper operation of the Media Gateway, your iPod must be updated

with the most recent version of rmware from Apple. This is done on your

computer. To update the software on the iPod go to:

http://www.apple.com/ipod/download/.

Follow the directions on the website to complete the download. There is

no charge for this update.

PREVENTING DAMAGE TO YOUR VEHICLE OR IPOD.

Some installations require you to make wiring connections. To eliminate

the risk of an electrical short, we recommend disconnecting the

vehicle’s battery prior to installation. If you do not feel comfortable

making these connections, we suggest you seek professional

installation. We recommend that the iPod be disconnected from the

interface when the vehicle is not in use.

PROPER MOUNTING LOCATION

Securely install the interface in a location free from; heat, humidity,

moving parts, sharp metal edges or direct sunlight. We recommend

securing the interface to a suitable location using; double sided tape,

VelcroTM or zip-ties.

Dip Switch Conguration Chart

Fig. 1 Side view of interface with dip switches in correct position

Features 1 2 3 4

IPOD, HD RADIO, SAT off off off off

3. Compatibility Notes

This section will inform you of the specic requirements for your

factory radio to be compatible with the Media Gateway. These

notes will inform you of any issues or circumstances that can affect

the compatibility of our product with your radio, audio system, or

accessories. Not all Factory radios are compatible with the Media

Gateway. The Media Gateway will only work on models equipped

with the specications listed below. Please read and understand

these notes before proceeding:

Radio Requirements

Radios must be “can-bus”, satellite ready, and may have “MP3”

printed on the face plate of the radio. This indicates that the required

connection is present on the rear of the head unit and that the radio

has the necessary functionality to operate the Media Gateway.

Refer to www.peripheralelectronics.com/apps

for most updated application guide.

4. Programming the Media

Gateway (PXAMG)

The Media Gateway may need to be programmed before installation.

To program the interface you will need to set the dip switches

located on the side of the interface (see Fig. 1 below) to the proper

conguration listed below. Prior to installation the switches are in

their default setting of “off” in the up position and are turned “on”

when switched down. Refer to the chart below.

OFF

PORT 1 PORT 2

5. Installation

1. When making electrical connections it is always recommended

that the vehicle’s battery be disconnected from the electrical

system before performing the installation.

2. Carefully remove the trim panels covering the 7mm bolts that

secure the radio into the dash cavity. Remove these bolts, and

carefully pull the radio from the dash of the vehicle. This will

provide access to the factory radio connectors where you will

connect the Media Gateway harness.

3. Disconnect the factory 24-Pin harness and 16-Pin harness

(if present) from the back of the radio. Disconnect the antenna

adaptor from the radio.

4. Plug in the male connectors on the PGHFD1 harness into the

24-pin port and 16-pin port on the back of the radio. Next,

connect the factory 24-pin and 16-pin harness (if present)

into the female connectors on the PGHFD1 harness. Be sure

to make a rm connection but do not force it. Plug the black

micro-t 24-pin connector on the PGFD1 harness into the

PXAMG Media Gateway box.

5. IMPORTANT NOTES for installation in 2008 Mercury Mariner,

Ford Focus, or Ford Escape

**** 2008 Mercury Mariner, 2008 Ford Focus, and 2008 Ford

Escape will require the PGHFD1A harness. This harness

will connect to the 4-Pin plug on the PGHFD1 harness. This

harness will replace the current 12-pin harness connected

to the LCD mounted above the radio. Disconnect the factory

12-Pin harness and do not reconnect. Plug the 12-Pin

connector of the PGHFD1A harness into the LCD display.

Again make a rm connection, but do not force.

6. Plug the 3 foot HD Radio Cable (8-Pin mini-din to 8-Pin mini-

din) cable into the rst port (furthest to the dipswitches) on the

Media Gateway. Connect the other end of this cable into the HD

Radio tuner. Connect the factory antenna cable into the antenna

connection on the HD Radio tuner (HDRT) Using the supplied

antenna adaptor if needed to make this connection.

7. If connecting an iPod, connect the 8-Pin mini-din iPod cable

into the second port on the Media Gateway (closest to the

dipswitches). Carefully run the 11 foot iPod cable behind the

dash to the location where the iPod will be mounted or stored (for

example the glove box or center console). This location will

vary based on the vehicle, and the customer’s prefrence.

When running this cable through the dash be sure to secure

it away from moving parts or sharp metal edges that may

damage the cable.

8. To complete the installation secure the Media Gateway

(PXAMG) and HD Radio tuner (HDRT) into the cavity in the

dash behind the radio. Be sure that the cables and interface

modules are not near moving parts or sharp metal edges as

they may damage the cables. To prevent rattling noises inside

the dash, use zip ties, or electrical tape, or other fasteners to

mount the interfaces to the factory wiring or installed audio

components (for example under the factory Satellite tuner

(if present).

9. With all connections made, reconnect the vehicle’s battery, insert

the key into the ignition, and turn the vehicle on. Check for proper

operation of the Media Gateway and HD Radio tuner before

reinstalling the factory dash panels.

Sample Mounting Locations: You can Secure your Media

Gateway and HD Radio tuner in the shaded areas shown below.

Mounting location for Media Gateway

or HD Radio tuner

Mounting location for Media Gateway

or HD Radio tuner

6. HD Radio Operation

6.1 Selecting HD Radio

Simply press and release the AUX or SAT button until “HD Radio” is

displayed on the screen.

**When you press the AUX or SAT

button, you will see the corresponding

SAT mode (for example SAT 1), a

slight delay, and then the current

Media Gateway mode will be

displayed (HD Radio/iPod/Sat1 - Sat

2 - Sat 3/Line In).

Tune Up / Seek Up

Press the SEEK► button to advance one station or to seek to next

broadcasting station.

Tune Down / Seek Down

Press the ◄SEEK button to move back one station or to seek back to

previous broadcasting station.

Changing from auto seek to manual tuning:

Press and hold SEEK► button for

longer than two seconds to toggle

between manual tune and auto tune

modes. Either “MANUAL” or “AUTO”

will be displayed on the screen to verify

which mode is selected.

Changing Bands

Press and release the AUX button to

cycle through FM1, FM2, FM3 and AM1.

Storing Radio Stations into Preset Memory

Once you have tuned to a station you wish

to store as a preset you will need to press

and hold one of the preset buttons (1-6)

for longer than two seconds to store it

into that location. The screen will display

“PR SAVED” and your preset has been

stored into memory.

Recall Stored Preset Stations

Press and release the Preset Button(1-6) that represents the station

stored in memory that you wish to recall.

Displaying Text

A. Radios equipped with the text/scan button:

1. Press the TEXT/SCAN button to display artist/song title

information, if available.

B. Radios not equipped with the TEXT/SCAN button:

1. Press the button located in the top right hand corner of

the radio to display artist/song title information, if available.

**Not all stations broadcast the artist and song title information.

***NOTE: If the selected station supports HD RADIO and the signal is

strong enough the radio will auto-lock onto the HD Radio Station.

The letters “HD1, HD2 or HD3” will follow the stations frequency

when locked onto an HD station.

The HD Radio will pick up both

Digital and Analog radio signals.

Multicast HD2 and HD3 stations are

digital only, and will not be available if

the radio signal is too far away, causing

a weak signal.

7. iPod Operation

(if equipped)

Simply press and release the AUX or SAT button until “IPOD” is

displayed on the radio.

**When you press the AUX or SAT button, you will see the corresponding

SAT mode (for example SAT 1), a slight delay, and then the current

Media Gateway mode will be displayed (HD Radio/iPod/Sat1 - Sat 2 -

Sat 3/Line In)

Controls:

Next Track

Press the SEEK► button to advance one song in an Album or Playlist.

Previous Track

Press the ◄SEEK button to move back one song in an Album or Playlist.

Fast Forward

Press and Hold Preset # 6 button to Fast Forward the song that is playing.

Rewind

Press and hold Preset # 5 button to Rewind the song that is playing.

Display Options

Press the Preset # 4 remove button to switch between the song title

information and the play counter. After using the fast-forward or

rewind function, the radio will display the elapsed time of the song

that is currently playing.

Menu Down / Select

Press and release the Preset # 2 remove button to make a selection

or move down one folder in the menu.

Menu UP

Press the Preset # 1 remove button to move up one folder in the menu.

Exit Browse Menu

Press the Preset # 3 remove button to exit the browse menu and

continue playing the current song. “EXIT” will be displayed when button

is pressed.

Browse by Artist

Press and release the Preset #2 to enter the browse menu.

The word ”BROWSE” will appear on the radio. You have entered the

Browse menu.

Press the SEEK► or ◄SEEK button until ARTIST is displayed.

(“F:” in front of the different artists

names indicates that this is the folder

of artists).

Press Preset #2 to select browse by

Artist.

The list of Artists on your iPod will be

displayed one at a time in Alphabetical

order. “AR:” will be displayed in front of

the artist’s name to indicate that you are searching for an artist.

Press the SEEK► or ◄SEEK button to cycle through the artists.

If the artist you are looking for is toward the end of the alphabet you

may use the ◄SEEK to search backwards. When the desired artist

is displayed on the radio,

Press Preset #2 to select the artist and display the albums

by that artist.

The Albums from the selected Artist will be displayed one at a time in

Alphabetical order. “AL:” will be displayed in front of the name of the

album to indicate you are searching for an album.

Press the SEEK► or ◄SEEK button to cycle through the albums.

Tabla de contenidos

Otros manuales de Puerta de Peripheral Electronics

Peripheral Electronics

Peripheral Electronics MEDIA GATEWAY PXAMG PGHNI2 Manual de usuario

Peripheral Electronics

Peripheral Electronics IPOD PGHSB1 Manual de usuario

Peripheral Electronics

Peripheral Electronics PGHGM5 Manual de usuario

Peripheral Electronics

Peripheral Electronics PGHTY1 Manual de usuario

Peripheral Electronics

Peripheral Electronics SIMPLE PGHGM3 Manual de usuario

Peripheral Electronics

Peripheral Electronics PGHGM1 Manual de usuario

Peripheral Electronics

Peripheral Electronics PXAMG/PGHGM1 Manual de usuario

Peripheral Electronics

Peripheral Electronics PGHHD1 Manual de usuario

Manuales populares de Puerta de otras marcas

LST

LST M500RFE-AS Manual de usuario

Kinnex

Kinnex Media Gateway Manual de usuario

2N Telekomunikace

2N Telekomunikace 2N StarGate Manual de usuario

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario

Telsey

Telsey CPVA 500 - SIP Manual de usuario

RTA

RTA 460A-NNA4 Hoja de especificaciones

Shaw

Shaw Gateway HDPVR Manual de usuario

ABB

ABB VSN900 Guía de inicio rápido

Commander

Commander Pulse Manual de usuario

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manual de usuario

NETGEAR

NETGEAR C6300BD Manual de usuario

Amit

Amit CDW531AM Manual de usuario

HMS

HMS Netbiter EasyConnect EC150 Manual de usuario

Huawei

Huawei EchoLife HG620 Manual de usuario

AT&T

AT&T U-verse 3801 Manual de uso y cuidado

Logic IO

Logic IO RTCU MX2 turbo Manual de usuario

Suttle

Suttle MediaMAX MXM-521 Manual de usuario