PDi PD168-059 Manual de usuario

MODEL NUMBER:

PD168-059 Dual Monitor Mount

Document Number:

PD196-399R2

Installation Instructions

Page 1 of 6

PDi Communication Systems, Inc. ▪40 Greenwood Ln ▪Springboro, Ohio 45066 USA ▪www.pdiarm.com and www.mymedTV.com ▪Phone 800.628.9870

INTRODUCTION

This document provides the information to assemble and install a PD168-059 Dual Monitor Mount provided by

PDi Communication Systems. These instructions cover the standard design of the pendant mount and any

customizations that have been included may not be specifically outlined in these instructions.

SAFETY

1. Always wear safety glasses/goggles to prevent injury from debris.

2. Follow the installation/removal instructions for your existing products.

TOOLS REQUIRED

1. Phillips screwdriver

2. 3/16” and 7/16” hex wrenches

3. Safety glasses/goggles

INSTALLATION

Included Hardware:

•8 each; PDIPPHMSM4X710 –Screw, M4 x 10mm Long, Phillips Pan Head

1. Unpack the P19A TV (sold separately) and place on workbench face down. If necessary, place protective

mat on workbench to ensure the viewing surface is not damaged.

2. Place the 15.6” Teguar Tablet (not provided by PDi) facedown next to the P19A TV so that it is on the

right as shown in Figure 1.

FIGURE 1. MONITOR ARRANGEMENT

BOTTOM OF MONITORS

PDI-P19A TV

15.6” Teguar Tablet

MODEL NUMBER:

PD168-059 Dual Monitor Mount

Document Number:

PD196-399R2

Installation Instructions

Page 2 of 6

PDi Communication Systems, Inc. ▪40 Greenwood Ln ▪Springboro, Ohio 45066 USA ▪www.pdiarm.com and www.mymedTV.com ▪Phone 800.628.9870

3. Remove the cover from the Dual Mount Arm as shown in Figure 2. Do not discard any of the parts, as

they will be needed later.

FIGURE 2. DUAL MOUNT ARM

4. With the Dual Mount Arm oriented as shown in Figure 3, feed the cables from the P19A and the tablet

through the 1.25” hole in the VESA mounting bracket for each monitor.

FIGURE 3. CONNECTING THE DUAL MOUNT ARM

Feed cables from

P19A TV through

this opening.

MODEL NUMBER:

PD168-059 Dual Monitor Mount

Document Number:

PD196-399R2

Installation Instructions

Page 3 of 6

PDi Communication Systems, Inc. ▪40 Greenwood Ln ▪Springboro, Ohio 45066 USA ▪www.pdiarm.com and www.mymedTV.com ▪Phone 800.628.9870

5. Place the Dual Mount Arm on the back of each monitor and connect the monitors with the M4 screws,

PDIPPHMSM4X710 (4 per monitor; see Figure 4).

FIGURE 4. SCREW INSTALLATION AND CABLE ROUTING

6. Attach the Dual Mount Arm to the nose of the PDI arm using the socket head cap screw, PD209-002, and

lock washer, PDISLW25, from the Swivel Assembly in the Dual Mount Arm, as shown in Figures 5A &

5B.

Feed the cables from the

arm along this channel.

Feed cables through this hole

to connect to the monitors.

M4 X 10mm Screws

(4 per Monitor)

MODEL NUMBER:

PD168-059 Dual Monitor Mount

Document Number:

PD196-399R2

Installation Instructions

Page 4 of 6

PDi Communication Systems, Inc. ▪40 Greenwood Ln ▪Springboro, Ohio 45066 USA ▪www.pdiarm.com and www.mymedTV.com ▪Phone 800.628.9870

FIGURE 5A. MOUNTING DUAL ARM TO SWING ARM

FIGURE 5B. MOUNTING DUAL ARM TO SWING ARM

7. Route cables through the Dual Mount Arm as specified in Figure 4 and connect the devices according to

their respective installation documents.

8. Confirm the devices are working properly. Reinstall the cover that was removed in Step 3 (see Figure 2).

MODEL NUMBER:

PD168-059 Dual Monitor Mount

Document Number:

PD196-399R2

Installation Instructions

Page 5 of 6

PDi Communication Systems, Inc. ▪40 Greenwood Ln ▪Springboro, Ohio 45066 USA ▪www.pdiarm.com and www.mymedTV.com ▪Phone 800.628.9870

REVERSING THE SWIVEL MOUNT

If the desired direction the TV is facing changes, follow the steps below the switch the direction.

1. Remove the plastic Cap Plug, PDI-271.

2. Using two 7/16” hex wrenches, unscrew the Stover lock nut, PDISLN2520, and hex head bolt,

PDIHHCS2520200, as shown in Figure 6A.

a. NOTE: The hex head bolt is what holds the lower swivel assembly (swivel stem, brake discs,

washers, etc.) together. If not secured, the lower swivel assembly will fall apart and will need to

be reassembled before Step 3.

FIGURE 6A. UNSCREWING THE HEX BOLT

3. Rotate the entire upper swivel assembly one-hundred-eighty degrees. Refer to Figure 6B.

FIGURE 6B. ROTATING THE SWIVEL

MODEL NUMBER:

PD168-059 Dual Monitor Mount

Document Number:

PD196-399R2

Installation Instructions

Page 6 of 6

PDi Communication Systems, Inc. ▪40 Greenwood Ln ▪Springboro, Ohio 45066 USA ▪www.pdiarm.com and www.mymedTV.com ▪Phone 800.628.9870

4. Realign the upper swivel assembly with the lower swivel assembly. Re-install the hex head bolt and

Stover lock nut, tighten to 100in-lbs Torque. Re-assemble the Cap Plugs, as shown in Figure 6C.

FIGURE 6C. REATTACHING THE SWIVEL

5. If the components in the lower swivel move or their alignment is lost, align the components as shown

below to arrange correctly.

WARRANTY

PDi Communication Systems Inc., (“PDi”) standard warranty information is found at pdiarm.com. For information

regarding authorized servicing and all other information pertaining to this warranty, please contact PDi

COMMUNICATION SYSTEMS, INC. at 40 Greenwood Ln, Springboro, Ohio 45066 or phone 800-628-9870 and

ask for the PDi ProServices team.

Tabla de contenidos

Manuales populares de Rack y soporte de otras marcas

Salamander

Salamander Acadia AC/W/L400/WH Manual de usuario

Fohhn

Fohhn VAT-09 Guía del usuario

ricoo

ricoo FS0522 Manual de usuario

AMSOIL

AMSOIL BMK-22 Guía rápida

Kargo Master

Kargo Master 48220 Manual de usuario

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manual de usuario

ricoo

ricoo S1222 Manual de usuario

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manual de usuario

VidaBox

VidaBox VB MNT FFS2 Manual de usuario

Welch Allyn

Welch Allyn 48960 Manual de usuario

Arkon

Arkon CM035-ST-2 Manual de usuario

PROEL

PROEL PLWIN60C Manual de usuario

Agilent Technologies

Agilent Technologies E2609B Manual de usuario

Mustang

Mustang MV-ARM4 Manual de usuario

Mounting Solutions

Mounting Solutions WRM-320 Manual de usuario

Pyle

Pyle PMKSPAD1 Manual de usuario

ShelterIt

ShelterIt 21208 Manual de usuario

SPL

SPL RackPack?4 1040 Manual de usuario