PCL LIMITED WARRANTY
PCL warrants the components of each unit to which this Limited Warranty applies against defects in materials and workmanship for a period of twelve (12)
months from date of sale (as evidenced by bill of sale or equivalent) or for a period of eighteen (18) months from date of shipment from PCL manufacturing
facility (identifiable by the serial number and noted on original bill of lading from the manufacturing facility), whichever period is shorter. During this
warranty period and subject to the conditions set forth in this statement, PCL will, at its option, repair or replace component parts that were defective at the
time of shipment from PCL manufacturing facility, subject, however, to the following specific EXCLUSIONS: hoses and connections.
Repair or replacement will not extend the warranty period.
Customer must give PCL timely notice of any warranty claim by contacting an authorized PCL service centre. Claims must be accompanied by (1) evidence,
by a bill of sale or equivalent, which clearly establishes date of purchase of the unit and (2) the serial number, found on the unit. Customers must properly
pack parts in their original or equivalent packaging, prepay shipping charges, and insure the shipment or accept the risk for loss or damage in shipment.
Return shipment to customer will be freight collect unless otherwise agreed. For service at a customers location, customer will be charged the then
prevailing service rates .
The Limited Warranty applies to PCL manufactured units only. Items listed in the applicable operators manual under routine maintenance are not covered
by this or any other warranty. Failure to complete maintenance as stated in any applicable maintenance schedule will void the Limited Warranty. The
Limited Warranty is expressly conditioned upon proper and normal use and service of the unit and upon strict compliance by customer with all of PCL
instructions and recommendations for installation, operation and maintenance. The Limited Warranty does not apply to the unit or parts that are damaged
or become defective due to improper handling, maintenance, storage, use, or operation, and does not cover ordinary wear and tear, corrosion, or erosion.
THE LIMITED WARRANTY SET FORTH IN THIS STATEMENT CONSTITUTES PCL'S SOLE WARRANTY FOR THE UNIT AND THE REMEDIES SET
FORTH HEREIN CONSTITUTE CUSTOMERS SOLE REMEDIES FOR BREACH OF WARRANTY. THIS LIMITED WARRANTY IS IN LIEU OF ALL
OTHER WARRANTIES, EXPRESS OR IMPLIED, IN FACT OR BY LAW, INCLUDING WITHOUT LIMITING THE GENERALITY OF THE FOREGOING,
ANY WARRANTY OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Determination of the suitability of the unit for the use contemplated by the customer is the sole responsibility of the customer. PCL shall not, under any
circumstances, be liable in contract, tort or otherwise (including negligence and strict liability) for indirect, special, incidental, or consequential damages,
and PCL's total liability shall not exceed the net purchase price for the unit. PCL shall be excused for delay or inability to perform obligations due to events
beyond its reasonable control.
Test Certificate
Each unit, before release, is checked and calibrated on test equipment that has accuracy
traceable to Druck pressure indicator S/N2329290.
The Druck unit is referenced to Certificate 0029346 issued by UKAS Laboratory No. 0221.
This accuracy exceeds and BS EN 12645:2014 (MPE = 0.08 bar).
PART NUMBER
SERIAL NUMBER
SET PURITY (%)
TESTED BY
DATE
Declaration of conformity
• Note : The declaration of conformity is valid for units operating at 230V/50Hz.
• 2014/30/EU (EMC directive) confirmed by report No. TRA-034746-36-02A
• 2014/35/EU (LOW Voltage Directive).
• National regulations EN12645 : 2014, French National Approval LNE-3345—Rev 0, report no. LNE-33471—Rev 0 and
Portugal Approval (IPQ) report no. 245.30.17.3.18
Mark McCaughey
Technical Director on behalf of PCL
