Panasonic NN-T704QF Manual de usuario

ORDERNO.SIMMC0407020A3

Microwave Oven

NN-T794AF / NN-T784SF / NN-T704QF / NN-T774SF / NN-

S784BF / NN-S784WF / NN-S754BF / NN-S754WF

QPQ(Australia&New Zealand)

Please fileand use thismanual together with the service manual for

Model NN-S560WF (ORDERNO. SIMMC0006012C3)

SPECIFICATIONS

2004 PanasonicHome Appliances Microwave Oven (Shanghai)

distribution isaviolation of law.

1. SCHEMATIC DIAGRAM

2. CAUTIONS TO BE OBSERVED WHEN

TROUBLESHOOTING

Unlike manyotherappliances, the microwave ovenis a high voltage, high current device. It is

free fromdangerinordinaryuse, though extreme care shouldbe takenduring repair.

Caution

Servicemen shouldremove theirwatches whenever working close

to or replacing the magnetron.

2.1. Check the grounding

Donot operate on a twowire extension cord. The microwave ovenis designedtobe grounded

whenused. It is imperative, therefore, toensure the appliance is properlygroundedbefore

beginning repairwork.

2.2. Inverter warnings

DANGER, HIGH VOLTAGE AND HIGH TEMPERATURE (HOT/LINE) OFTHE INVERTER POWER

SUPPLY (U)

The high voltage inverter power supplyhandles veryhigh voltage

and current for the magnetron tube. Though itisfree from danger

inordinaryuse, extreme care shouldbe taken during repair.

The aluminum heat sink isalso energized with high voltage (HOT),

do not touch when the AC input terminalsare energized. The power

device Collector isdirectlyconnected to the aluminum heat sink.

The aluminum heat sink maybe HOTdue to heat energy, therefore,

extreme care shouldbe taken during servicing.

H.V. Inverterwarning

WARNING FOR INVERTER POWER SUPPLY (U) GROUNDING

Check the high voltage inverter power supplycircuitgrounding.

The high voltage inverter power supplycircuitboard must have a

proper chassisground. The inverter grounding bracket must be

connected to the chassis. Ifthe inverter board isnot grounded it

will expose the user to veryhigh voltages and cause extreme

DANGER!Besure that the inverter circuitisproperlygrounded via

the inverter earth bracket.

Grounding of the invertercircuit board

WARNING!DISCHARGE THE HIGH VOLATGE CAPACITORS

For about 30 seconds after the oven isturned off, an electriccharge

remains inthe high voltage capacitors inthe inverter power supply

circuitboard.

When replacing or checking parts, remove the power plug from the

outlet and short the inverter output terminal of the magnetron

filament terminalsto the chassisground with an insulated handle

screwdriver to discharge. Please be sure to touch the chassis

ground side first and then short to the output terminals.

Discharging the high voltage capacitors

WARNING

There ishigh voltage present with high current capabilities inthe

circuits of the primaryand secondarywindings, choke coil and heat

sink of the inverter. Itisextremelydangerous to work on or near

these circuits with the oven energized. DO NOTmeasure the

voltage inthe high voltage circuitincluding the filament voltage of

the magnetron.

WARNING

Never touch anycircuitwiring with your hand or with an insulated

tool during operation.

2.3. Part replacement.

Whenanypart orcomponent is tobe replaced, always ensure that the powercordis removed

fromthe wall outlet.

2.4. When the 10Afuse isblowndue to the operation of the short

switch:

WARNING

When the 10A250V fuse isblowndue to the operation of the

interlock monitor switch, replace all of the components (primary

latch switch, door switch, short switch and power relayB(RY1)).

1. Thisismandatory. Refer to “adjustments and measurements” for

the location of these switches.

2. When replacing the fuse, confirm that ithas the appropriate rating

for these models.

3. When replacing faultyswitches, be sure the mounting tabs are

not bent, broken or deficient intheirabilityto holdthe switches.

2.5. Avoidinserting nails, wire etc. through anyholes inthe unit

during operation.

Neverinsert a wire, nail oranyothermetal object through the lampholes on the cavityorany

holes orgaps, because suchobjects maywork as anantenna and cause microwave leakage.

2.6. Confirm after repair

1. After repairor replacement of parts, make sure that the screwsof

the oven, etc. are neither loose nor missing. Microwaves might

leak ifscrewsare not properlytightened.

2. Make sure that all electrical connections are tight before inserting

the plug into the wall outlet.

3. Check for microwave energyleakage. (Refer to procedure for

measuring microwave energyleakage).

CAUTION MICROWAVE RADIATION

USE CAUTIONNOTTO BECOME EXPOSEDTO RADIATIONFROM

THEMICROWAVE MAGNETRONOROTHERPARTS CONDUCTING

MICROWAVE ENERGY

IMPORTANTNOTICE

The following components have potentialsabove 2000V whilethe

appliance isoperated.

-Magnetron

-High voltage transformer (Located on inverter (U))

-High voltage diodes (Located on inverter (U))

-High voltage capacitors (Located on inverter (U))

Payspecial attention to these areas.

When the appliance isoperated with the door hinges or magnetron

installed incorrectly, the microwave leakage can exceed more than

5mW/cm2. After repairor exchange, itisveryimportant to check if

the magnetron and the door hinges are correctlyinstalled.

2.7. Sharp edges

Caution

Please use caution when unpacking, installing or moving the unit,

as some exposed edges maybe sharp to the touch and cause

injuryifnot handled with care.

3. MEASUREMENTS AND ADJUSTMENTS

3.1. Adjustment of primarylatch switch, secondarylatch switch and

short switch.

1. Mount the Primarylatch switch, the secondarylatch switch and

the short switch to the door hook assemblyas showninILL.

NOTE:

Nospecificindividual adjustments during installation of the

Primarylatch switch, Secondarylatch switch or Short switch to

the door hook are required.

2. When mounting the door hook assemblyto the oven assembly,

adjust the door hook assemblybymoving itinthe direction of the

arrowsinthe illustration, so that the oven door will not have any

playinit. Check for playinthe door bypulling the door assembly.

Make sure that the latch keysmove smoothlyafter adjustment is

completed. Completelytighten the screwsholding the door hook

assemblyto the oven assembly.

3. Reconnect the short switch and check the continuityof the

monitor circuitand all latch switches againbyfollowing the

component test procedures.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Microondas de Panasonic

Panasonic

Panasonic NNA714 Guía del producto

Panasonic

Panasonic NN-SU66LS Manual de usuario

Panasonic

Panasonic NN-S562 Manual de usuario

Panasonic

Panasonic NN-CD997S Manual de usuario

Panasonic

Panasonic NN-SD65LS Manual de usuario

Panasonic

Panasonic NN-ST661 Manual de usuario

Panasonic

Panasonic Inverter NN-A574SBBTQ Manual de usuario

Panasonic

Panasonic NN-ST657S Manual de usuario

Panasonic

Panasonic NN-S533WF Manual de usuario

Panasonic

Panasonic NN-DF383 Manual de usuario

Panasonic

Panasonic NN-GT462M Manual de usuario

Panasonic

Panasonic INVERTER NN-T695 Manual de usuario

Panasonic

Panasonic NE-2740 Manual de usuario

Panasonic

Panasonic Slim Combi NN-L564 Manual de usuario

Panasonic

Panasonic NN-SU676S Manual de usuario

Panasonic

Panasonic NNSD986S - MICROWAVE OVEN 2.2CUFT Manual de usuario

Panasonic

Panasonic NN-GM231W Manual de usuario

Panasonic

Panasonic NN-CT65MB Manual de usuario

Panasonic

Panasonic NNS255 - MICROWAVE - 2.0CUFT Manual de usuario

Panasonic

Panasonic NN-GD568S Manual de usuario

Panasonic

Panasonic NN-CT867MBPQ Manual de usuario

Panasonic

Panasonic NN-S29KSM Manual de usuario

Panasonic

Panasonic NN-SD297 Manual de instrucciones

Panasonic

Panasonic NN-S758BA Manual de usuario

Manuales populares de Microondas de otras marcas

Daewoo

Daewoo KOG-574R0S Manual de usuario

LG MH7040SS Manual de usuario

Sharp

Sharp R-895(AL)M Manual de usuario

Dometic

Dometic DOTRM13W Manual de usuario

Sanyo

Sanyo EM-X680 Manual de usuario

Sharp

Sharp R-393M Manual de usuario

KitchenAid

KitchenAid KMCX4510 Instrucciones de instalación

Smeg

Smeg S45MCX1 Manual de usuario

Russell Hobbs

Russell Hobbs RHM2044 Manual de usuario

Sunbeam

Sunbeam SMW759 Manual de usuario

Gallet

Gallet FMOE230S Manual de usuario

Bosch

Bosch CEG732X.1B Manual de usuario

Dometic

Dometic Roadmate 230 Manual de usuario

Samsung

Samsung SJ0396W Manual de usuario

Sanyo

Sanyo EM-P494WS Manual de usuario

Sharp

Sharp R-240 Manual de usuario

Electrolux

Electrolux EMS2840 Manual de usuario

Daewoo

Daewoo KOC-984T2S13 Manual de usuario