Panasonic EH-NE83 Manual de usuario

Order Number PEWT1710A28CE

(Household) Hair Dryer

Model No.

EH-NE83

Asia

Middle East

TABLE OF CONTENTS PAGE

1 Warning ---------------------------------------------------------------------------------------

2 Specifications ------------------------------------------------------------------------------- 2

3 Troubleshooting Guide ------------------------------------------------------------------------ 3

4 Disassembly and Assembly Instructions -------------------------------------------- 5

5 Wiring Connection Diagram------------------------------------------------------ 12

6 Schematic Diagram ---------------------------------------------------------------- 15

7 Exploded View & Replacement Parts List ----------------------------------- 16

and distribution is a violation of law.

1. Warning

Caution:

- Pb free solder has a higher melting point that standard solder; Typical the melting point is 50 - 70°F (30 - 40℃) higher.

Please use soldering iron with temperature control and adjust it to 750 ±20°F (400 ± 10 ℃).

In case of using high temperature soldering iron, please becareful not to heat too long.

- Pb free solder will tend to splash when heated too high (about 1100°F / 600℃).

Power source

Power consumption

(" II - Hot ")

Air volume without nozzle

Air temperature without nozzle

(" II - Hot ")

Dimensions

Cord length

Weight

Supplied accessory

90 K (in case of room temperature 30°C)

(W) 90mm x (D) 220mm. x (H) 270mm.

(without power cord and nozzle)

2. Specifications

AC 220-240 V , 50~60 Hz

Code L / 605 / 615 / 655 / 685 = 1.7 m

Approx. =530g.

Set nozzle

AC 220 V, 50~60 Hz, 2100 W

AC 230 V, 50~60 Hz, 2300 W

AC 240 V, 50~60 Hz, 2500 W

1.9 m3/min

3. TROUBLESHOOTING GUIDE

Refer to WIRING CONNECTION DIAGRAM.

< TROUBLE >

< CHECK >

< REMEDY >

Check if there are odd objects between

joints of thermo switch or not

(Figure 3)

Remove the odd objects

between joints

Found odd object

No odd objects

Replace the

MOTOR HEATER ASSEMBLY

Figure 3

Thermo Switch

Hot air is not emitted

Check the conductivity between the terminal 1

and 2 by push and hold

the COOL SWITCH BUTTON

(Figure 2)

Check the conductivity between the terminal 2

and 4 by setting

the TEMPERATURE SWITCH to Position 2

(Figure 1)

Replace the

MAIN SWITCH

Replace the

COOL SWITCH BUTTON

Lead Wire (Orange)

Lead Wire (Blue and Red)

For EH-NE81-84 only

Figure 2

Figure 1

Lead Wire (Black)

Lead Wire (Brown)

Lead Wire (Orange)

Temperature Switch

3. TROUBLESHOOTING GUIDE

Refer to WIRING CONNECTION DIAGRAM.

< TROUBLE >

< CHECK >

< REMEDY >

Main body is

not operated

Check the conductivity of power cord

Check the conductivity between the terminal 1

and 4 by setting

the MAIN SWITCH to Position 1

(Figure 4)

Replace the

MAIN SWITCH

Replace the

MOTOR HEATER

ASSEMBLY

Replace the

MOTOR HEATER

ASSEMBLY

Lead Wire (Yellow)

Lead Wire (Red)

Lead Wire (Gray)

Lead Wire (Orange)

*For code : 605, 655, 685, 695, 865

MAIN SWITCH

Figure 4

4. Disassembly and Assembly Instructions

4.1. Disassembly Instructions

1. Remove the FILTER FRAME ASSEMBLY 4. Remove TAPPING SCREWS by a cross

slot screw driver.Than take out AIR OUTLET RING

and AIR OUTLET GRILL by rotating follow the direction

below.

2. Remove 3 TAPPING SCREWS by a cross

slot screw driver,then Remove AIR INLET RING.

5. Take off HOUSING AB follow the figure below.

3. Remove 2 TAPPING SCREWS at HOUSING A

by flat-blade screwdriver and 2 TORX SCREWS

at HANDLE by Driver then remove HANDLE AB.

6. Remove DISCHARGE COVER

Counter clockwise rotation

4. Disassembly and Assembly Instructions

4.1. Disassembly Instructions

7. remove Ion Holder from DISCHARGE COVER as figure below.

8. Take off MOTOR HEATER ASSEMBLY, and PLATE SPRING from HOUSING B.

Unclip this 2 ribs

4.2 Assembly Instructions

1. High voltage lead wire for Ion discharge must be fixing with Ribs from Heater holder as below picture.

2. Install MAIN SWITCH PLATE AB and MAIN SWITCH HOLDER.

3. Install Ion discharge in to DISCHARGE COVER.

Ribs of MAIN SWITCH

HOLDER must fully

lock with MAIN SWITCH

(2 Ribs)

4. Assemble MOTOR HEATER ASSEMBLY, COOL SWITCH PLATE and PLATE SRPING into HOUSING B.

Lead wire to Heater block

assembly

must not on this area

Position of component must be as below

(EH-NE81,82,83,84 only)

5. Assemble DISCHARGE COVER / DESIGN COVER into HOUSING B.

6. Assemble HOUSING A, then tightening 2 TORX SCREWS.

7. Assemble AIR INLET RING and 3 TAPPING SCREWS.

TAPPING SCREWS 2.6*10

TORX SCREWS 3.0*12

Tabla de contenidos

Otros manuales de Secador de pelo de Panasonic

Panasonic

Panasonic EH-ND12 Manual de usuario

Panasonic

Panasonic EH5571 Manual de usuario

Panasonic

Panasonic EH-TNA9J Manual de usuario

Panasonic

Panasonic EH-NE65 Manual de usuario

Panasonic

Panasonic EH-NE20 Manual de usuario

Panasonic

Panasonic EH-NE65-K655 Manual de usuario

Panasonic

Panasonic EH-ND21 Manual de usuario

Panasonic

Panasonic EH-NE82 Manual de usuario

Panasonic

Panasonic EH-NE50 Manual de usuario

Panasonic

Panasonic nanoe EH-NA27 Manual de usuario

Panasonic

Panasonic EH-NA98 Manual de usuario

Panasonic

Panasonic EH5163 Manual de usuario

Panasonic

Panasonic EH5502W Manual de usuario

Panasonic

Panasonic EH-NE84-K865 Manual de usuario

Panasonic

Panasonic EH-ND11 Manual de usuario

Panasonic

Panasonic nanoe EH-NA63 Manual de usuario

Panasonic

Panasonic EH-ND33 Manual de usuario

Panasonic

Panasonic nanoe EH-NA67 Manual de usuario

Panasonic

Panasonic EH-NE27 Manual de usuario

Panasonic

Panasonic nanoe EH-NA9K Manual de usuario

Panasonic

Panasonic EH-NE64 Manual de usuario

Panasonic

Panasonic EH-NA95 Manual de usuario

Panasonic

Panasonic Zigzag EH5206P Manual de usuario

Panasonic

Panasonic Nanoe EH-ANA3 Manual de usuario

Manuales populares de Secador de pelo de otras marcas

CTC Union

CTC Union Clatronic HT 3428 Manual de usuario

Rowenta

Rowenta Motion Dry Ionic CV3721K0 Manual de usuario

Bosch

Bosch PHD5962 Manual de usuario

Conair

Conair Infiniti 213 Guía del usuario

Beurer

Beurer Elle HDE 15 Manual de usuario

Braun

Braun 3542 Manual de usuario

Marta

Marta MT-1498 Manual de usuario

AEG

AEG FOEN HT 5608 Manual de usuario

Vitek

Vitek VT-2378 Manual de usuario

ARESA

ARESA AR-3215 Manual de usuario

TREVIDEA

TREVIDEA SPASSO G3 FERRARI G30029 Manual de usuario

Helvex

Helvex MB-1011 Manual de usuario

Dolphin

Dolphin BC109-ST5 Valera+ Manual de usuario

Remington

Remington Get The Look D3110GP Manual de usuario

Conair

Conair VS Sassoon Eco Dry Manual de usuario

Dyson

Dyson supersonic HD01 Manual de usuario

Grundig

Grundig HD 2509 R Manual de usuario

Imetec

Imetec Bellissima My Pro Diffon DF1 3000 Manual de usuario