PAC PAC-200 Manual de servicio
The relay will handle 200 amperes on a continuous basis at 12 VDC and 300 Amperes in rush peak or surge.
Mount the relay between batteries as an isolator or in the main power lead servicing the mobile audio system,
amplifiers, light bars or any other equipment requiring on/off control.
INSTALLATION INSTRUCTIONS:
The two small terminals are for switching the relay on and off. Either one of the small terminals should be
connected to chassis ground or other ground location and the other terminal to switching power output. Switching
power must be between 10 and 16 VDC. The relay coil draws less than 1amp when switched on.
Battery or main power leads use the two large terminals. Either one may be incoming power. Fuse power leads as
close to battery or batteries as possible.
MODEL PAC-200
MOBILE AUDIO RELAY AND BATTERY ISOLATOR
200 Amp Continuous Power Handling
Pacific Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
_+
Battery
_+
Battery
FUSE
FUSE
PAC-200
Alternator
+
Accessory
Tabla de contenidos
Otros manuales de Accesorios para automóviles de PAC
PAC
PAC VS41 Manual de usuario
PAC
PAC C2R-CHYNA Manual de usuario
PAC
PAC NU-CHY2 Manual de usuario
PAC
PAC GM1A-R Manual de usuario
PAC
PAC UPAC-NIS2 Manual de usuario
PAC
PAC RB10GM14B Manual de usuario
PAC
PAC BCI-CH21 Manual de usuario
PAC
PAC BCI-CH41 Manual de usuario
PAC
PAC SWI-ECL2 Manual de usuario
PAC
PAC RP4-CH21 Manual de usuario
PAC
PAC C2R-CHY4 Manual de usuario
PAC
PAC OS-4 Manual de usuario
PAC
PAC SWI-RC Manual de usuario
PAC
PAC AAI-NIS2 Manual de usuario
PAC
PAC CH1AJKIT Manual de usuario
PAC
PAC TATO Manual de usuario
PAC
PAC RadioPRO 4 Manual de usuario
PAC
PAC RP4-CH11 Manual de usuario
PAC
PAC GM1A-RST Manual de usuario
PAC
PAC SWI-RC Manual de usuario
