RCPR/03
Comfortable work position: Slide seats all way back, if right handed
sit in passenger seat; if left handed, sit in driver seat.
Installation preparation: Connect wiring extension supplied to console
wiring loom; connect red to red,white to white and yellow to yellow.
Tape up all connections.
Use ‘Blu-Tack’ in fit kit to adhere one of the 6mm x 25mm round head bolts to Phillips head screw driver and
store in convenient location, eg: on seat of vehicle or in/on centre console.
CONSOLE INSTALLATION:
Stand console up on front seat and plug yellow, white and red console wires into interior light plug (as per
Fig. D). Check that console lights work independently once doors are shut and timer switches off then tape up
to ensure wires do not become disconnected.
Hold console up in position over Front Mounting Bracket ensuring bracket fits in between front of console and
rear of radio surround/storage tray. Look up under rear mounting hole; line up captive nuts in Rear Fixing Plate
with slotted fastening holes, tuck wiring loom out of way so as not jam between console body and rear
mounting plate. Using the 6mm x 25mm round head bolt ‘Blu-Tacked’to your Phillips screw driver loosely
fasten console up to Rear Fixing Plate.
Using a short Philips head screw driver fasten front of console to Front Mounting Bracket using the two (2)
6mm x 16mm black round head Phillips bolts, to do this push up hard on front of console, use rear view mirror
to help line up captive nuts, do bolts up tight.
‘Blu-Tack’other 6mm x 25mm bolt to screw driver and loosely fasten into Rear Fixing Plate. Check first by
measurement that rear of console is centered in vehicle then tighten rear bolts. NOTE: Only tighten rear bolts
up firm so console is held to roof. DO NOT keep tightening so as to bend rear mounting plate downwards. Do
rear bolts up with equal tension.
Open Locker Box and remove Microphone Cable Holder and Mounting Hole Cover from inside; fasten Cover
in place using screws supplied. Fasten Microphone Cable Holder in place as per radio installation instructions.
There is an on/off switch located in front of front lights, when off it acts as a kill switch and no lights will work;
when on lights work independently as map/interior lights when doors are shut and timer switches off; when
doors are opened lights will work as door/interior lights.
Fit Kit: RCPR03
One (1) Front Mounting Bracket
One (1) Rear Fixing Plate
One (1) Fastening Plate with 14mm plastic spacer
One (1) Wiring extension
Two (2) 10# x 10mm Phillips self tapping screws
Two (2) 6mm x 16mm black round head Phillips bolts
Two (2) 10# x 20mm Phillips self tapping screws
One (1) 6mm x 20mm round head Phillips bolt
Two (2) 6mm x 25mm round head Phillips bolts
One (1) Small piece of ‘Blu-Tack’
Three (3) x 100mm Sticky back foam pieces
