Remark concerning the immunity to the electro-static discharges:
Trials according to the EN 61000-4-2 norm have shown a non-destructive and very short
lasting stop of the saw in case of a more than 4000 volts electric shock.
2.8 Maintenance - Cleaning
Disconnect the power supply before any maintenance or cleaning operation.
Check that no electric cable is damaged, that the oscillating shaft and the switch are not
blocked in their movements by an accumulation of sawing wastes.
The only maintenance this saw needs is that it has to be kept clean. Wipe clean with a
damp rag. Do neither immerse the saw in water nor every other liquid, nor clean it with a
shower.
3 Be sure to observe scrupulously the safety instructions
- The device can be used only by an operator competent in plaster room who has
attentively read this present instruction.
- Every modification of the device in comparison with its original version is strictly
forbidden.
- The duty cycle according to chapter 1.4 is only available when the saw is used
together with the vacuum cleaner which is cooling the saw.
- The device is designed only for a dry use and must be used or stored in a dry place
only.
- Every use other than the one indicated on the present manual may constitute a
danger which can so be avoided.
- Check that the socket in compliance with the plug of the device.
- Check that the indicated voltage on the motor block is in compliance with the used
power source.
- Never let the device running unattended.
- Always take the plug off before doing whichever intervention on the device, or when
the device remains unattended or within reach of children or persons who are not
responsible for their actions.
- Do not pull neither lift the device when using the electric cable.
- The maintenance and repairs must be provided by specialised persons; the possibly
damaged parts will be replaced by original spare parts.
-The manufacturer refuses to accept any responsibility in case of every third-party
damage to people, animals or objects as a result of the lack of respect of these
following instructions or if the device has been used on an unproper way.
Manufacturer’s address: OSCIMED SA - Allée du Quartz 3 - CH-2300 La Chaux-de-Fonds
