Oricom UHF050 Manual de usuario
User Guide
Oricom UHF050 40 Channel UHF CB Radio
Downloaded from www.cbradio.nl
3
Table of contents
Important Information 4
Please read before installing or operating your Oricom Radio 4
Safety Warning 5
Controls and Connectors 6
Installation of your Oricom UHF 050 8
Box Contents 8
Antenna Installation 8
DC Power 9
DIN Kit 9
Optional External Speaker 9
Operation 10
Dual Function buttons 10
Power ON / OFF 10
Squelch 10
To Select a Channel 10
To Select A CTCSS / DCS or 60Rx Receive channels 10
Transmitting 11
Busy Channel Lock (BCL) 11
To Transmit 11
Call Tone 12
CTCSS (Continuous Tone Coded Squelch System) 12
DCS (Digitally Coded Squelch) 12
Receive & Transmit Indicator 13
Time Out Timer (ToT) 13
Duplex Operation 13
Roger Beep (RGB) 15
Emergency Channel (EMG) 15
Priority Channel (PRI) 15
BEEP Tone (BPT) 16
Memory Scan 16
Priority Scan 17
LCD Display Controls 17
60 Rx channels 17
Factory Reset 18
Specications 19
Frequency Table (Channel 1-20) 20
Frequency Table (Channel 21-40) 21
Warranty 22
Customer Support 23
4
Important information
Please read before installing or operating
your Oricom Radio
The operation of this radio in Australia and New Zealand is subject
to conditions in the following licenses. In Australia the ACMA Radio
communications (Citizen Band Radio Stations) and in New Zealand by MED
General User Radio License for Citizen Band Radio and operation is subject
to conditions contained in those licences.
Channels 5 and 35 (paired for Duplex repeaters) are reserved as emergency
channels and should be used only in an emergency. CTCSS and DCS will
not operate on these channels.
Channel 11 is a calling channel generally used to call others and channel
40 is the customary road vehicle channel.
Once contact is established on the calling channel, both stations should
move to another unused “SIMPLEX” channel to allow others to use the
calling channel.
Channels 22 and 23 are for Telemetry and Telecommand use, voice
communications are not allowed on these channels by law.
Channels marked Duplex are reserved for repeater use in some areas.
These are paired with higher channels as output/input (1/31, 2/32, etc.)
Check for local repeater activity before using these channels in Simplex
mode to avoid interference. Channels 9 and above are the best choices for
general use in Simplex mode. You can nd more information about channels
and frequencies by visiting the Web site:
http://www.acma.gov.au
Note:
Refer to the “Channel Table” section of this Owner’s Manual for detailed
frequency listing.
5
Important information
Safety Warning
NOTE:
Areas with potentially explosive atmospheres are often, but
not always clearly marked. They include fueling areas such
as below deck on boats; fuel or chemical transfer or storage
facilities; areas where the air contains chemicals or particles,
such as grain, dust, or metal powders; and any other area
where you would normally be advised to turn off your vehicle
engine.
Potentially Explosive Atmospheres
Turn your radio OFF when in any area with a potentially
explosive atmosphere. Sparks in such areas could cause an
explosion or re resulting in injury or even death.
Blasting Caps and Areas
To avoid possible interference with blasting operations, turn
your radio OFF near electrical blasting caps or in a “blasting
area” or in areas posted: “Turn off the two way radio.” Obey all
signs and instructions.
Electromagnetic Interference/Compatibility
Nearly every electronic device is susceptible to electromagnetic
interference (EMI). To avoid the possibility of electromagnetic
interference and/or compatibility conicts, turn off your radio
in any location where posted notices instruct you to do so such
as health care facilities.
WARNING
Operation
6
Controls and Connectors
Front View
60RX
CTCSS
DCS
1 2 4
14131211109876
53
1. Rotary On / Off Switch and Volume Control
2. LCD Display
3. Rx / Tx Indicator
4. CTCSS / DCS, 60 Channel Rx Selector switch
5. Rotary squelch control
6. Microphone connector
7. Call- Call Button, Set- Set Button
8. M SC – Memory Scan, P SC – Priority Scan
9. DW – Dual Watch, BPT – Beep Tone
10. MEM – Memory Skip, RGB – Roger Beep
11. EMG – Emergency Channel, DPX – Duplex
12. PRI – Primary, BCL – Busy Channel Lock
13. BLT – Back light, DIM – DIM
14. Rotary Channel Button
Operation
7
Rear View
1 2 3
1. Antenna Connection
2. 3.5mm external jack for optional 8 ohm speaker
3. Power Supply Connection
Microphone
1. Push to talk switch (PTT)
2. Select Up
3. Select Down
4. Instant Channel
1
2 4 3
8
Installation of your Oricom UHF050
Box Contents
1 X UHF050 CB Radio
1 X Microphone
1 X DC Power cord with inline fuse
1 X Mounting bracket with mounting screws
1 X Microphone hanger
1 X DIN mounting kit
1 X User Guide
When installing your radio in your vehicle, check that during
installation you do not damage any wiring or vehicle components
that may be hidden around the mounting position.
If you are unsure about how to install your radio, we suggest
for optimum performance you have your radio professionally
installed by a UHF specialist or Auto electrician. When installing
the radio, avoid mounting it close to heaters or air conditioners.
Do not press the PTT or CALL button before installing the
antenna.
Antenna Installation
To obtain the best performance from your UHF050 it is important to obtain
a good quality antenna. You should purchase an antenna designed for the
477MHz frequency band.
1. Connect the antenna to the rear antenna socket using a PL259 coaxial
connector.
9
Installation of your Oricom UHF050
DC Power
The UHF050 is designed for 13.8V DC negative earth installations only.
1. Connect the negative (Black) DC power lead to the vehicle chassis or
directly to the vehicle battery negative terminal if preferred.
2. Connect the positive (Red) DC power lead via the in line fuse to a
suitable point in the vehicle fuse box or directly to the positive battery
terminal. When selecting a suitable point take into consideration if you
want your UHF 050 to be operational when the car ignition is off.
DIN Kit
The UHF050 can be installed using a optional DIN Kit - Part number; DIN050
for mounting in a vehicle dash board.
Optional External Speaker
Depending on the installation it may be necessary to use an external
speaker (not supplied) to give improved volume and clarity. This can be
plugged into the EXT –SPK socket on the rear of the unit.
Operation
10
Operation
Dual Function buttons
The dual function button (buttons 7 to 13) have two functions.
To use the primary function (printed on the button) just press the button. To
use the secondary function (printed above the button)
press and hold the button for 2 seconds.
Power ON / OFF
Rotate the power switch in a clockwise direction to turn the unit ON,
adjust the volume to a comfortable level. Rotate the Power Switch counter
clockwise until it click to turn off the power.
Squelch
To adjust the level of squelch use the rotary SQL control. Turning the control
clockwise reduces the amount of squelch, turning counter clockwise
increase the amount of squelch. To reduce the signals that you can hear,
increase the squelch, to hear more signals which may include weak signals
decrease the squelch.
To Select a Channel
To select a channel rotate the CH control clockwise or counter clockwise to
the desired channel.
To Select A CTCSS / DCS or 60Rx Receive channels
Press the CTCSS / DCS button once to obtain CTCSS channel select. Press
twice to obtain DCS channel select.
Press and hold the button for 2 seconds to obtain the 60Rx channels.
Tabla de contenidos
Otros manuales de Radio de Oricom
Oricom
Oricom DTX4200 Manual de usuario
Oricom
Oricom UHF025 Manual de usuario
Oricom
Oricom UHF098 Manual de usuario
Oricom
Oricom UHF350DR Manual de usuario
Oricom
Oricom UHF400R Manual de usuario
Oricom
Oricom UHF5500 Manual de usuario
Oricom
Oricom PMR795 Manual de usuario
Oricom
Oricom UHF080 Manual de usuario
Oricom
Oricom UHF360 Manual de usuario
Oricom
Oricom DTX4000 Manual de usuario
Oricom
Oricom UHF350DR Manual de usuario
Oricom
Oricom UHF5400 Manual de usuario
Oricom
Oricom UHF180F Manual de usuario
Oricom
Oricom UHF028 Manual de usuario
Oricom
Oricom DTX4200X Manual de usuario
Oricom
Oricom UHF098 Manual de usuario
Oricom
Oricom UHF360 Manual de usuario
Oricom
Oricom PMR3000 Manual de usuario
Oricom
Oricom UHF305 Manual de usuario
Oricom
Oricom UHF380M Manual de usuario
