OPTRONIC jetcam 4.0 Manual de usuario
V2.0 Page 1
Operating instructions
www.optronic.de
V2.0 Page 2
Table of contents
Preface (Page 3)
Warning notices (Page 4)
Quality features (Page 4)
Description of components (Page 5)
Data sheet (Page 6-8)
Preparation (Page 10)
Preparation (Page 11-12)
Commissioning (Page 13)
Cleaning/inspection using the JetCam (Page 14-15)
Straight sections, elbows, branches, over soil
Cleaning the nozzle (Page 15)
V2.0 Page 3
Preface
Please read through these instructions for use carefully.
It contains valuable instructions on correct use of the JetCam, but also tips for
effective operation.
We wish you all the best when using it.
Team OPTRONIC
V2.0 Page 4
Warnings
·
For cleaning, do not use any high-
pressure cleaners
·
Do not place any heavy objects on the
device
·
Do not perform repair work by yourself,
consult an authorised customer service.
Otherwise, the manufacturer guarantee
shall be invalidated!
·
Do not use when the cable is
damaged.
·
This system must be disposed of in a
professional manner and must not be
disposed of with domestic waste.
Quality
characteristic
Components of the JetCam, such as camera head, impact guard, steering piece,
high-pressure hose may have minimal scratch marks when being delivered. These
marks are the result of our end test.
V2.0 Page 5
Component description
V2.0 Page 6
Factsheet
V2.0 Page 7
V2.0 Page 8
Battery voltage: 14.4 V DC
Charging voltage: 17 V DC
Output: 6.9 Ah (for app. 10 operating hours)
Charging time: app. 7 hours
Possible hazards !
Lithium-Ion batteries are sealed gas tight and are harmless as long as
they are used and handled in line with the manufacturer regulations.
Warning !
Never use battery chargers that are not intended for the battery type!
Do not short-circuit. Do not damage mechanically (puncture, deform, dismantle,
etc.) Do not heat above the permissible temperature or burn. Keep batteries away
from smaller children. Always store batteries dry and cool.
Instructions for use
The JetCam has been optimally designed for your tasks in diameters from
50 to 300 mm
V2.0 Page 9
V2.0 Page 10
Preparation
Please make sure that the following are available at the operating location:
·
a jetter, where the output corresponds approximately to:
40 - 60 litre / min. 100 - 150 bar for JetCam with 3/8" hose
60 - 80 litre / min. 100 - 150 bar for JetCam with 1/2" hose
·
2 open-ended spanners, 27mm for connecting the high-pressure hose of the
jetter to the JetCam
·
Charged battery:
Please note that the rechargeable battery of a brand-new system
is not fully charged when delivered.
Tabla de contenidos
Otros manuales de Equipo de limpieza de OPTRONIC
