Optex PRO WAVE Manual de usuario
Angle plate
4. Drill holes at the 2 marks using
a 3/16” drill bit.
3. Mark the center of the two
mounting holes.
6. Install housing with supplied screws.
( DO NOT FULLY TIGHTEN )
1. Drill two 1/8” mounting holes on
back of housing.
2. Hold housing at desired mounting
location ensuring it is level.
8. Close the sensor casing.
7. Ensure housing is level and tighten
screws.
Detection
area
Less than 8”
30 - 44”
Sensitive area
7 feet
7-8”
Within 12” from mounting wall
PIR Sensor
Receiver
Touch free
5. Knock in the two plastic anchors.
Holes with
plastic anchors
THICK
THIN
7to8”
30 to 44”
For hand sticker: 30 to 44”
Touch Free
Wave hand here
to open door
Touch Free
Wave hand here
to open door
Angle plate
Thin
Angle Plate
Angle Plate
Thick
5918741
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Transmisor de Optex
Optex
Optex Wireless 1000 Annunciator System TC-10U Manual de usuario
Optex
Optex Redwall Wire-Free WF-100DT Manual de usuario
Optex
Optex TD-20U Manual de usuario
Optex
Optex SS Checker SC-T4 Manual de usuario
Optex
Optex SC-U1 Manual de usuario
Optex
Optex SS Checker SC-T4 Manual de usuario
Optex
Optex TD-20U Manual de usuario
Manuales populares de Transmisor de otras marcas
Dejero
Dejero EnGo 3x Manual de usuario
Rosemount
Rosemount 4600 Manual de usuario
Speaka Professional
Speaka Professional 2342740 Manual de usuario
trubomat
trubomat GAB 1000 Manual de usuario
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Manual de usuario
Rondish
Rondish UT-11 Manual de usuario
