Omega OM-CP-QUADVOLT Manual de usuario

OM-CP-QUADVOLT

4-Channel Low Level DC Voltage Data Logger

OM-CP-OCTVOLT

8-Channel Low Level DC Voltage Data Logger

MQS5086/1216

Xxxxx Xxxxxx

Xxxxx Xxxxxx Xxxxxxxx

M0000/0016

INSTRUCTION

SHEET

Xxxxx Xxxxxx

Xxxxx Xxxxxx Xxxxxxxx

M0000/0016

INSTRUCTION

SHEET

Shop online at omega.comSM e-mail: [email protected]

For latest product manuals: www.omegamanual.info

Office: Jl. Radin Inten II No. 62 Duren Sawit, Jakarta 13440 - Indonesia

Workshop: Jl. Pahlawan Revolusi No. 22B, Jakarta 13430 - Indonesia

Phone: 021-8690 6777 (Hunting) Fax: 021-8690 6777

Mobile: +62 816 1740 8925

Fax: 021-8690 6771

Product Overview

Engineering Units

Engineering units are used to convert one measurement reading to another. The OM-CP Data Logger software

allows for software level Engineering Units (conversion applied to data after download). Certain devices have

device level Engineering Units, which upon download automatically appear in the chosen unit of measure.

Wiring the Data Logger

OM-CP-QUADVOLT and OM-CP-OCTVOLT Single Ended Wiring (2.5, 15 and 30V)

Two-position removable screw terminal connections; accepts 2-wire conﬁgurations.

OM-CP-QUADVOLT and OM-CP-OCTVOLT Differential Wiring (+-100mV)

Three-position removable screw terminal connections; accepts 3-wire conﬁgurations.

Warning: Note the polarity instructions. Do not attach wires to the wrong terminals.

OM-CP-QUADVOLT and OM-CP-OCTVOLT

Office: Jl. Radin Inten II No. 62 Duren Sawit, Jakarta 13440 - Indonesia

Workshop: Jl. Pahlawan Revolusi No. 22B, Jakarta 13430 - Indonesia

Phone: 021-8690 6777 (Hunting) Fax: 021-8690 6777

Mobile: +62 816 1740 8925

Fax: 021-8690 6771

Installation Guide

Installing the Interface Cable

- OM-CP-IFC200

Insert the device into a USB port. The drivers will install automatically.

- OM-CP-IFC110

Plug the serial cable into the port and verify it is secure.

Installing the software

Insert the Omega Software Flash Drive in an open USB port. If the autorun does not appear, locate the drive

on the computer and double click on Autorun.exe. Follow the instructions provided in the Wizard.

Device Operation

Connecting and Starting the data logger

- Once the software is installed and running, plug the interface cable into the data logger.

- Connect the USB end of the interface cable into an open USB port on the computer.

- The device will appear in the Connected Devices list, highlight the desired data logger.

- For most applications, select “Custom Start” from the menu bar and choose the desired start method,

reading rate and other parameters appropriate for the data logging application and click “Start”. (“Quick

Start” applies the most recent custom start options, “Batch Start” is used for managing multiple loggers at once,

“Real Time Start” stores the dataset as it records while connected to the logger.)

- The status of the device will change to “Running”, “Waiting to Start” or “Waiting to Manual Start”,

depending upon your start method.

- Disconnect the data logger from the interface cable and place it in the environment to measure.

Note: The device will stop recording data when the end of memory is reached or the device is stopped. At this point

the device cannot be restarted until it has been re-armed by the computer.

Downloading data from a data logger

- Highlight the data logger in the Connected Devices list. Click “Stop” on the menu bar.

- Once the data logger is stopped, with the logger highlighted, click “Download”. You will be prompted to

name your report.

- Downloading will ofﬂoad and save all the recorded data to the PC.

OM-CP-QUADVOLT and OM-CP-OCTVOLT

Device Maintenance

Battery Replacement

Materials: 3/32” HEX Driver (Allen Key) and Replacement Battery (OM-CP-BAT103)

- Remove the cover from the device by unscrewing the four screws.

- Remove the battery from its compartment and unsnap it from the connector.

- Snap the new battery into the terminals and verify it is secure.

- Replace the cover taking care not to pinch the wires. Screw the enclosure back together securely.

Note: Be sure not to over tighten the screws or strip the threads.

Recalibration

The OM-CP-QUADVOLT or OM-CP-OCTVOLT standard calibration is dependant upon the range.

Recalibration is recommended annually for any Omega data logger; a reminder is automatically displayed in

the software when the device is due. Speciﬁcations subject to change. See Omega’s terms and conditions at

www.omega.com

OM-CP-QUADVOLT and OM-CP-OCTVOLT

Range 100mV 2.5V 15V 30V

Calibration Point 0mV and

90-100mV

0mV and

2.25-2.5V

0mV and

14.9-15.5V

0mV and

27-30V

Description OM-CP-QUADVOLT

Voltage Range

*See Table BelowVoltage Resolution

Voltage Accuracy

Memory 32,767/channel

Reading Rate 1 reading every second up to 1 reading every 12 hours

LED Indicator None

Channels 4

Required Interface Package IFC110 or IFC200

Baud Rate 2,400

Typical Battery Life 1 year

Operating Environment -40°C to +60°C, 0%RH to 95%RH (non–condensing)

Material Anodized aluminum

Dimensions 3.5” x 4.4” x 1.0”

(89 mm x 112 mm x 26 mm)

Weight 13 oz (370 g)

OM-CP-QUADVOLT General Speciﬁcations

Battery Warning

WARNING: FIRE, EXPLOSION, AND SEVERE BURN HAZARD. DO NOT SHORT CIRCUIT, CHARGE, FORCE OVER DISCHARGE, DISASSEMBLE, CRUSH,

PENETRATE OR INCINERATE. BATTERY MAY LEAK OR EXPLODE IF HEATED ABOVE 60°C (140°F).

Speciﬁcations subject to change.

See Omega’s terms and conditions at www.omega.com

Still need help? For more troubleshooting tips and information, refer to the built in help section visit us online at www.omega.com

or contact us for support at 1 (800) 872-9436.

*OM-CP-QUADVOLT Range, Resolution and Calibrated Accuracy

Nominal Range +-100mV 0 to 2.5V 0 to 15V 0 to 30V

Measurement Range (VDC) +-150mV -0.25 to 2.75 -1 to 16 -2 to 32

Accuracy +-0.01%FSR +-0.01%FSR +-0.10%FSR +-0.10%FSR

Resolution (mV) 5µV 0.1 0.5 1.0

Common Mode Input Range 0 to 2.5V 0 to 2.5V 0 to 2.5V 0 to 2.5V

OM-CP-QUADVOLT and OM-CP-OCTVOLT

OM-CP-OCTVOLT General Speciﬁcations

Description OM-CP-OCTVOLT

Voltage Range

*See Table BelowVoltage Resolution

Voltage Accuracy

Memory 16,383/channel

Reading Rate 1 reading every second up to 1 reading every 12 hours

LED Indicator None

Channels 8

Required Interface Package IFC110 or IFC200

Baud Rate 2,400

Typical Battery Life 1 year

Operating Environment -40°C to +60°C, 0%RH to 95%RH (non–condensing)

Material Anodized aluminum

Dimensions 3.5 in x 4.4 in x 1.5 in

(89 mm x 112 mm x 39 mm)

Weight 17 oz (480 g)

Battery Warning

WARNING: FIRE, EXPLOSION, AND SEVERE BURN HAZARD. DO NOT SHORT CIRCUIT, CHARGE, FORCE OVER DISCHARGE, DISASSEMBLE, CRUSH,

PENETRATE OR INCINERATE. BATTERY MAY LEAK OR EXPLODE IF HEATED ABOVE 60°C (140°F).

*OM-CP-OCTVOLT Range, Resolution and Calibrated Accuracy

Nominal Range +-100mV 0 to 2.5V 0 to 15V 0 to 30V

Measurement Range (VDC) +-150mV -0.25 to 2.75 -1 to 16 -2 to 32

Accuracy +-0.01%FSR +-0.01%FSR +-0.10%FSR +-0.10%FSR

Resolution (mV) 5µV 0.1 0.5 1.0

Common Mode Input Range 0 to 2.5V 0 to 2.5V 0 to 2.5V 0 to 2.5V

Office: Jl. Radin Inten II No. 62 Duren Sawit, Jakarta 13440 - Indonesia

Workshop: Jl. Pahlawan Revolusi No. 22B, Jakarta 13430 - Indonesia

Phone: 021-8690 6777 (Hunting) Fax: 021-8690 6777

Mobile: +62 816 1740 8925

Fax: 021-8690 6771

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Registrador de datos de Omega

Omega

Omega OM-90 Series Manual de usuario

Omega

Omega OM-21A Manual de usuario

Omega

Omega OM-USB-5203 Manual de usuario

Omega

Omega HH520 Manual de usuario

Omega

Omega OM-EL-WiFi Series Manual de usuario

Omega

Omega OM-CP-HITEMP140-FP Manual de usuario

Omega

Omega OM-EL-WiFi-TH Manual de usuario

Omega

Omega OM-DAQLINK-TEMP Manual de usuario

Omega

Omega OM-USB-5201 Manual de usuario

Omega

Omega OM-CP-RFRHTemp2000A Manual de usuario

Omega

Omega OMP-MODL Manual de usuario

Omega

Omega OM-CP-ULTRASHOCK-A Manual de usuario

Omega

Omega OM-EL-WiFi Series Manual de usuario

Omega

Omega OM-70 Series Manual de usuario

Omega

Omega OM-EL-WIN-USB Series Manual de usuario

Omega

Omega OM-CP-OCTRTD Manual de usuario

Omega

Omega OM-NET-1608 Manual de usuario

Omega

Omega OM-CP-RHTEMP101A Manual de usuario

Omega

Omega OM-WEB-TC Manual de usuario

Omega

Omega OM-USB-1208HS Series Manual de usuario

Omega

Omega OM-60-TE Manual de usuario

Omega

Omega OM-CP-VOLT101A Manual de usuario

Omega

Omega OM-DLAC Manual de usuario

Omega

Omega HFS DAQ Manual de usuario

Manuales populares de Registrador de datos de otras marcas

TESTO

TESTO 176 Manual de usuario

HT Italia

HT Italia XL421 Manual de usuario

HBM

HBM SOMAT XR CX22B-R Manual de usuario

Agtrix

Agtrix 380i Manual de usuario

Hobo

Hobo H8 Pro Manual de usuario

Beijing ART Tech

Beijing ART Tech PCI2320 Manual de usuario

Athena

Athena GET SL1 Manual de usuario

Motec Systems

Motec Systems C185 Manual de usuario

Beijing ART Tech

Beijing ART Tech USB2832 Manual de usuario

Rotronic

Rotronic HygroLog HL20 Manual de usuario

MRC

MRC DW-6092 Manual de usuario

Racelogic

Racelogic VBOX LapTimer Manual de usuario

Edu-Logger

Edu-Logger 900-240 Manual de usuario

Elma

Elma DT173 Manual de usuario

MadgeTech

MadgeTech PRTemp140 Hoja de especificaciones

Comet

Comet U0121M Manual de usuario

pico Technology

pico Technology PT-104 Manual de usuario

Soil Instruments

Soil Instruments GTecLink Manual de usuario