Omega Engineering BVLS Series Manual de usuario

BVLS Series

Limit Switch for BVP70, BVPS70, BVP80 &

BVPS80 Series Actuated Ball Valves

2

3

MATERIALS OF CONSTRUCTION

BODY / COVER: Aluminium with TeflonImprenated Hard Anodized (PolyLube)Surfaces

PROBES: 316 Stainless Steel

SEALS - COVER, PROBES: Buna N

RATINGS / SPECIFICATIONS

TEMPERATURE: 10 F to 180 F

CONDUIT CONNECTION: 1/2” NPT

ELECTRICAL RATING: 10 amp. 250VAC maximum; 1/2 amp. 125VDC; 1/4 amp. 250VDC; 5 amp.

125VAC lamp load. Note: each pole must be the same polarity to utilize these ratings.

MICROSWITCHES: Mechanical S.P.D.T. (Single Pole Double Throw)

INTERNAL WIRING CONNECTIONS: Screw Clamp

NEMA STANDARDS: NEMA 1 (General Purpose); NEMA 4 (Watertight & Dusttight); NEMA 7 (Haz-

ardous Locations, Class I Groups B, C, & D); NEMA 9 (Hazardous Locations, Class II, Groups E, F, &

G); NEMA 12 (Oiltight and Driptight); and NEMA 13 (Oiltight and Dusttight).

UL LISTINGS: Industrial Control Equipment for use in Hazardous Locations, Class I, Groups B,C, & D

and Class II, Groups E, F, & G

MAINTENANCE

The BVLS normally requires no maintenance. However, in certain situations the switch adjustment

screws may require some attention to either advance or retard the cam actuated switch point. This

enables precise adjustment of the switch timing throughout the life of the unit.

Switch Adjustment

Screws

Terminal Strip

Electrical Schematic as

Shown - Inside Cover

4

Attachment of Limit Switch / NAMUR Mounting Pad

1. Remove the position indicator from atop the actuator and secure

the NAMUR 30 Shaft Coupling to the actuator Shaft Extension with

the #6-32 Set Screw using a medium strength (nonpermanent) thread

locker (not included in mounting kit).

2. Place the Limit Switch / NAMUR Mounting Pad on top of the actua-

tor. Be sure that the lower flats of the NAMUR 30 Shaft Coupling are

oriented such that they align with the Limit Switch Mounting holes on

the Limit Switch / NAMUR Mounting Pad.

3. Fasten the Limit Switch / NAMUR Mounting Pad to the actuator

using the (2) Mounting Bracket Screws.

4. Slide the position indicator over the NAMUR 30 Shaft Coupling

until it ‘snaps’ into place just above the bracket.

Attachment of Limit Switch

1. Fit the bushings, which extend from the Limit Switch housing, into the matching holes in the mounting pad. Push

switch housing against pad and verify that switch body touches pad. Secure switch body to pad with two #10-24

setscrews using a medium strength (nonpermanent) thread locker (not included in mounting kit). Note: Hex wrench sup-

plied with Mounting Kit.

Wiring Instructions

1. Route the wire to be terminated through the conduit hub and up

through the access space to the terminal block.

2. Strip insulation back 1/4”, insert the stripped ends directly into the

proper terminal clamps and tighten screws.

3. Internal interconnections between terminal-block and switches are

diagrammed inside the Limit Switch Cover.

Note: If the Switch is installed in a hazardous location i.e. where

flammable vapors or dust are present in the atmosphere, replace

the cover and tighten securely before connecting the electrical sup-

ply circuit. If necessary, a screwdriver shank or similar tool may be

engaged in the cover wrenching lugs to assist removal and replace-

ment.

Wiring Specifications

Switch Ratings

AC 250 volts; 10 amps

DC 250 volts; 0.25 amps

125 volts; 0.50 amps

Lamp Load 125 volts; 5 amps

Wire Size

#12 AWG Max.

#24 AWG Min.

65

M-4153/0405

M-4153/0405

6

Este manual sirve para los siguientes modelos

4

Tabla de contenidos

Otros manuales de Cambiar de Omega Engineering

Omega Engineering

Omega Engineering PSW-180 Series Manual de usuario

Omega Engineering

Omega Engineering PSW32 SERIES Manual de usuario

Omega Engineering

Omega Engineering LVU-230 Manual de usuario

Omega Engineering

Omega Engineering LV-60 Manual de usuario

Omega Engineering

Omega Engineering LVP-51 LVP-51 Series Manual de usuario

Omega Engineering

Omega Engineering LV-1201 Manual de usuario

Omega Engineering

Omega Engineering PSW490B Manual de usuario

Omega Engineering

Omega Engineering LV-510 Series Manual de usuario

Omega Engineering

Omega Engineering LVR300 Series Manual de usuario

Omega Engineering

Omega Engineering PSW400 Manual de usuario

Omega Engineering

Omega Engineering LVK-10 Manual de usuario

Omega Engineering

Omega Engineering LVUN-600 Manual de usuario

Omega Engineering

Omega Engineering LV-1101 Manual de usuario

Omega Engineering

Omega Engineering PSW18H Seriers Manual de usuario

Omega Engineering

Omega Engineering LVCN700 Series Manual de usuario

Omega Engineering

Omega Engineering FSW-410 Series Manual de usuario

Omega Engineering

Omega Engineering PSW495B Manual de usuario

Omega Engineering

Omega Engineering 430 Manual de usuario

Omega Engineering

Omega Engineering PSW141 series Manual de usuario

Omega Engineering

Omega Engineering PSW1000 Manual de usuario

Omega Engineering

Omega Engineering PSW2000 Manual de usuario

Omega Engineering

Omega Engineering LVU-700 Manual de usuario

Omega Engineering

Omega Engineering LVH-200 Series Manual de usuario

Omega Engineering

Omega Engineering FSW-50 Series Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario