Oce ColorWave 300 Manual de usuario
-
o
Océ
ColorWave® 300
Jump to One
User manual
Safety information
Copyright
© 2009 Océ
All rights reserved. No part of this work may be reproduced, copied, adapted, or transmitted
in any form or by any means without written permission from Océ.
Océ makes no representation or warranties with respect to the contents hereof and specifi-
cally disclaims any implied warranties of merchantability or fitness for any particular purpose.
Further, Océ reserves the right to revise this publication and to make changes from time
to time in the content hereof without obligation to notify any person of such revision or
changes.
Edition: 2009-10
Contents
Chapter 1
Safety information..............................................................................................5
Instructions for safe use............................................................................6
Chapter 2
Regulation notices............................................................................................11
Regulation notices (country dependent)................................................12
Chapter 3
General information.........................................................................................17
Caution labels and notations...................................................................18
Chapter 4
Miscellaneous....................................................................................................19
Addresses of local Océ organisations ...................................................20
3
Contents
4
Contents
Chapter 1
Safety information
Instructions for safe use
Introduction
All the products have been tested in accordance with the strictest international safety
standards. Please read the following sections before you connect the machine to the
power supply. These sections contain important information with regard to the user
safety and the prevention of equipment problems. Make sure that you observe the safety
rules hereinafter. This helps to assure that you can work with the product safely. Make
sure that you observe all the precautions mentioned below.
Note:
Some parts of the contents of this section may not be applicable to your product.
Note:
Please refer to the corresponding Safety Data Sheets for specific safety information. You
can download the Safety Data Sheets from the support site of your product at
http://global.oce.com/support/.
Warning and Caution Symbols
Caution:
Ignoring this warning could cause serious injury or even death.
Attention:
Ignoring this warning could cause injury or damage to property.
Note:
Indicates additional important information.
The indicators above are used on the warning labels or in the manuals to categorize the
level of safety warnings.
Disassembly and Modification
Warning
Chapter 1 - Safety information6
Instructions for safe use
■Do not remove covers and panels that are fixed to the machine. Some machines have
a high-voltage component or a laser beam source inside that could cause an electric
shock or blindness
■Do not modify this machine, since this could cause fire, electric shock, or breakdown.
If the machine contains a laser, the laser beam source could cause blindness.
Caution
■Do not carry out maintenance activities on components and maintenance materials
other than the components and materials that are mentioned in the user manual.
■Do not place any liquids on the machine.
■Do not open any door while the machine starts up or runs, unless the operator panel
displays a message asking you to open one or more doors.
■Only use maintenance materials or other materials for their intended purpose.
■To avoid any risk, only properly qualified and trained service technicians are allowed
to modify the machine.
■Do not bridge any mechanical or electrical circuit breakers.
Note
■Keep maintenance materials away from children.
Power cord
Warning
■Do not scratch, abrade, heat, twist, bend, place a heavy object on or cause any other
damage to the power cord. The use of a damaged power cord (exposed core wire,
broken wire, for example) could result in a fire or breakdown. If you find any of these
conditions, immediately turn OFF the power switch and unplug the power cord from
the power outlet. Then call your authorized service representative.
■Only use the mains connector cable that was supplied with the machine.
Power source
Warning
■Do not connect the machine to a mains voltage that differs from the value as stated
on the power marking label.
Note
■If connection to a different mains voltage is required, contact your authorized service
representative.
Power plug
Warning
Chapter 1 - Safety information 7
Instructions for safe use
■For machines that are connected via a wall socket: Place the machine close to a wall
socket that is easily accessible. The power plug is intended to serve as a disconnect
device.
Grounding
Warning
■Connect the power cord to an electrical outlet (wall socket) that is equipped with a
grounding terminal.
Installation
Warning
■Make sure that the machine is placed on a level, horizontal surface of sufficient strength.
Do not place this machine on an unstable or tilted bench.
■Do not place this machine in a location that is subject to lots of vibrations and shocks.
■Do not use flammable sprays, liquids or gases near this product, because this could
cause a fire.
Ventilation
Caution
■The machine can produce odors of exhaust air when you:
- use this machine in a poorly ventilated room for a long time
- produce large amounts of copies or print
Therefore, make sure that you ventilate this room well. Do not block the ventilation
openings of the machine.
■Do not place the machine in rooms which are too small and insufficiently ventilated.
See the Product Safety Data Sheet of the machine for the ventilation requirements.
Actions in response to troubles
Warning
■When a piece of metal, water or any other similar foreign matter gets inside the ma-
chine, immediately turn OFF the power switch and unplug the power cord from the
power outlet. Then call your authorized service representative.
■Immediately stop using the machine if the machine becomes excessively hot, emits
smoke, or produces unusual odors or noises. Immediately turn OFF the power switch
and unplug the power cord from the power outlet. Then call your authorized service
representative.
Caution
■Stop using the machine if the machine was dropped or a cover was damaged. Imme-
diately turn OFF the power switch and unplug the power cord from the power outlet.
Then call your authorized service representative.
Chapter 1 - Safety information8
Instructions for safe use
■LCD display. Do not rub, press or touch the display surface with hard material, because
the polarizer at the surface can be easily scratched. The LCD module consists of glass.
Therefore, the LCD module can damage when you drop, pinch strongly or punch
the module. When glass breaks, be careful that you do not get injured by glass pieces.
Call Customer Service.
Consumables, supplies and maintenance materials
Warning
■Do not throw ink containing or contaminated parts into an open flame.
Caution
■Do not leave ink containing or contaminated parts in a place within reach of children.
■Always use the materials which the manufacturer recommended and which are devel-
oped for this machine. Materials not approved by the manufacturer may result in
faults in your machine.
Moving the Machine
Caution
■Make sure that you disconnect the power cord and other cables before you move the
machine.
■Make sure that you check the documentation for the space requirements before you
move the machine.
Holidays
Caution
■Unplug the machine if you will be using it for a long period of time.
Chapter 1 - Safety information 9
Instructions for safe use
Chapter 1 - Safety information10
Instructions for safe use
Otros manuales para ColorWave 300
3
Tabla de contenidos
Otros manuales de Impresora todo en uno de Oce
Oce
Oce VarioLink 2221 Manual de usuario
Oce
Oce VarioLink 6022 Manual de usuario
Oce
Oce PP18C Manual de usuario
Oce
Oce im4530 Manual de usuario
Oce
Oce im5530 Instrucciones de instalación y mantenimiento
Oce
Oce VL3622 Manual de usuario
Oce
Oce em3521 Manual de usuario
Oce
Oce 31x5E Manual de usuario
Oce
Oce im5530 Manual de usuario
Oce
Oce ColorWave 300 Manual de usuario
Oce
Oce VarioLink 4522c Manual de usuario
Oce
Oce 3100 Manual de usuario
Oce
Oce VarioPrint 6000 MICR series Documento técnico
Oce
Oce OP30C Manual de usuario
Oce
Oce cm4521 Manual de usuario
Oce
Oce VarioPrint 2070 Manual de usuario
Oce
Oce im2330 Manual de usuario
Oce
Oce VarioPrint 2100 Manual de usuario
Oce
Oce cm5520 Manual de usuario
Oce
Oce FX3000 SERIES Manual de usuario
Manuales populares de Impresora todo en uno de otras marcas
Triumph Adler
Triumph Adler DC 2016 Manual
Epson
Epson WorkForce WF-2510 Guía del usuario
Epson
Epson Stylus Scan 2000 Manual de instalación y operación
Epson
Epson PictureMate Snap PM 240 Manual de instrucciones
Konica Minolta
Konica Minolta bizhub C35 Manual de usuario
Brother
Brother MFC-J430w Manual de usuario
