novaexled.com/800.595.6302
Page 2
WIFI-104 LED CONTROLLER
NF-WC-WIFI-104
Controller Operating Instructions:
RUN:
LINK:
The indicator light flashes quickly about 25s during the electric initialization. Flashes once per second
after initialization.
The indicator light stays lit when the mobile device connects to WiFi-104, and turns off when disconnect.
RX/TX: The indicator light turns on when WiFi-104 receives or transmits the WiFi data, turns off in the
free time.
2 Work Status Indicator Instructions:
1 Install/Uninstall ANT:
Clockwise to install the WiFi-104 ANT, counterclockwise to take off.
3 SSID Number Setting:
Use code switch to set the controller's SSID number, WIFI-104-SSID-X, X stands for a certain No. ranging
from 0-F, totally 16 options. which means our product could set 16 isolated LAN in the same area. WiFi-104
will initialize with run LED indicator flashing about 25s quickly, each time the SSID NO. is changed. Mobile
devices need to search and connect WiFi again after Initialization finished.
4 “Match” and “Scene” Button:
Short press MATCH button, WiFi controller begins its learning ID status for M12 remote (learning method, see
P13). Short press “SCENE” button entering into the user-saved scene modes sequentially, 4 scenes total.
[ Restore factory settings/Delete password ]
Long press “MATCH” and “SCENE” button simultaneously more than 2 seconds, the machine will back to the
default parameter, including the parameters of changing modes, zone, group and network. Machine default
parameters: Only the 1st zone is present, default RGBW mode, the changing mode is RGB jumping, white
is the brightest, no groups, network SSID is wifi-104-SSID-X (X is the actual coding switch corresponding
SSID values), wifi-104 controller restores as direct connection and the connection password is blank.
Scene interface
Scene button and match button
