D
I
SPOSAL
This product must not be disposed of along with the domestic waste. This product has
to be disposed at an authorized place for recycling of electrical appliances.
By collecting and recycling waste,you help save natural resources,and make sure the
product is disposed in an environmental friendly way.
CONTROLS
1.General
When first powering the heater, it will make a beeping sound, the LED display will flash.
The factory default,high level heat temperature is 20°C, this can be set from 5°C to 35°C by the user and
will be displayed in LED window. Low level heat temperature is 5°C, and this cannot be altered.
Default working mode is P1 and the time is Monday (d1), 12:00.The symbol will flash to remind you
to set the time.
When the heater is on and producing heat the symbol, will light on the LED display.
The function module is equipped with an accurate thermal cut-out when the programmed temperature is
achieved. It has a built in memory with 6 heatingprograms, of which 5 are pre-defined as
“P1,P2,P3,P4,P5” and 1 is available for programming by the user as “UP”.
2. Setting the Day and Time:
When the panel heater is first installed, or has been switched off or disconnected from the mains supply
for more than 72 hours, the Dayand Time will need to be set again.
2.1 – Press the“Time” button.The LED display will display d.1, and “1” will flash. Use the “+” or “-” buttons
to choose the correct day. It’s from 1 to 7which means from Monday to Sunday.
2.2 - Press the “Time” button. The LED display will flash “12”. Use the “+” or “-” button to choose the
correct Hour. This is from 0 to 23.
2.3 - Press the “Time”button. The LED display will flash “0”, use the “+” or “-” button to choose the correct
Minute. This is from 0 to 59.
2.4 - Press the “Time” button once more to save. The LED window will return to the display setting
temperature, will light off.
2.5 -If want to check the time, just press Time button once to show the Day, second time to show the Hour,
third time to show the Minute, the fourth time to quitand return to the temperature display.
3. Setting the Temperature:
The LED displaywill show thecurrent set temperature, press the “+” or “-” button to choose the required
temperature, it’s from 5°C to 35°C. During low heat time periods, it will display 5°C.
4. Description of the Programs Available:
There are 6 programs which switch the heating between Low Heat and High Heat at various times of the
dayand night. 5 of which are pre-defined and cannot be altered. These are displayed as
“P1,P2,P3,P4,P5”. The other is the"UP" programs which can be defined bythe user.
The table over the page shows the Low/High heat setting running times for each available program.
