will be valid however all numbers of preset points afterward and their speed and dwelling time shall be set as
0 automatically.
◆
After tracks are edited, press OFF to store and exit while push the joystick to exit without storage.
6. Run Cruise Track: [SHOT]+[N]+ [Enter]
Display: Input Tour No: 01
Description: N –– No. of the track from 1 to 6.
Function: Tour the No. N track and stop tour by pushing the joystick.
7. Stop Cruise Track: [SHOT]+[N]+ [OFF]
Display: Input Tour No: 01
Description: N –– No. of the track from 1 to 6.
Function: Stop the No. N track or stop tour by pushing the joystick.
8. Cancel Cruise Track: [SHOT]+[N]+ [OFF] (Pressing [OFF] down until “ Clear Tour OK ”appears)
Display: Input Tour No: 01
Description: N –– No. of the track from 1 to 6.
Function: Delete the No. N track
9. Auto Pan ON (Operation of COP-2 Protocol): [AUTO]+[P1]+[ON]+[P2]+[OFF]
Display: Input 1st No: 001
Description: P1–––– the starting scan No. of preset point from 1 to 128, which should be set already.
Display: Input 2nd No: 002
Description: P2–––– the ending scan No. of preset point from 1 to 128, which should be set already.
If P1 = P2 or P1 and P2 are coincided, the speed dome will make scan in range of 360°.
Note:
(1) For PELCO-D and PELCO-P Protocols the way of operation is as follows:
◆
Set the Starting Scan Position: Transfer the speed dome to the starting scan position, operation
[AUTO]+[ON]
◆
Set the Ending Scan Position: Transfer the speed dome to the ending scan position, operation
[AUTO]+[OFF]
◆
Run Auto Pan
：
[AUTO]+[ENTER]
(2) Auto Pan operation takes the following parameters. You must set these parameters before using a
Auto Pan command to begin the scan operation. You can use the scan Stop command or PT scan stop
command to stop the scan. Setting scan condition:
◆
Auto Pan Position (First specify position, second specify position)
◆
Auto Pan Speed and Direction
10. Stop Auto Pan: [AUTO]+[OFF] (only for
COP-2
protocol)or push the joystick to stop scan.
11. Control the Zoom of the Camera: [WIDE]/[TELE]
12. Control the Focus of the Camera: [FAR]/[NEAR]
13. Control the Iris of the Camera: [OPEN]/[CLOSE]
