5NookBox Installation Guide Input and Output Switch DIO-52-ZBS
• Input Follower:
In this mode, the input and output terminals of DIO-52 are connected to separate devices, and the output terminal device will act following
the trigger of input terminal device.
When input terminal device is triggered and sends a signal to the Control Panel, the output terminal device will be activated according to
the Output Follow Input settings in the Control Panel.
Power Terminal
The Switch uses two-wired 5-12V DC adapter to power on when connected to the Power Terminal. When Power Terminal and batteries are
both in use, the Switch will only power through AC Adapter.
Battery and Low Battery Detection
The Switch uses three CR123 Lithium batteries as its power source. The Switch features Low Battery Detection function. When the battery
voltage is low, the Switch will transmit Low Battery signal to the Control Panel to notify the user. When changing batteries, after removing
the old batteries, press the Function Button twice to fully discharge before inserting new batteries.
Supervision
The Switch will transmit a supervision signal to report its condition regularly according to user setting. The factory default interval is 30
minutes. The user can also press the Function Button once to transmit a supervision signal manually.
ZigBee Network Setup
ZigBee Device Guideline
ZigBee is a wireless communication protocol that is reliable, has low power consumption and has high transmission eciency. Based on
the IEEE802.15.4 standard, ZigBee allows a large amount of devices to be included in a network and are coordinated for data exchange and
signal transmission.
Joining the ZigBee Network
As a ZigBee device, the Switch needs to join a ZigBee network to transmit signal when it is triggered. Please follow the steps below to add
the Switch into the ZigBee network.
The Switch can only join ZigBee network within 3 minutes after power on.
1. Insert batteries or connect the two-wired 5-12V DC adapter to power on the Switch.
2. Within 3 minutes after power up, press and hold the Function button for 10 seconds, then release it to join the network. Please
make sure the permit-join feature on the router or coordinator of your ZigBee network is enabled.
3. If the Switch successfully joins a ZigBee network, the LED Indicator will ash twice to conrm.
4. After joining the ZigBee network, the Switch will be registered in the network automatically. Please check the ZigBee coordinator,
system control panel or CIE (Control and Indicating Equipment) to conrm if joining and registration is successful.
5. After joining the ZigBee network, if the Switch loses connection to current ZigBee network, the LED will ash every 20 minutes to
indicate. Please check your ZigBee network condition and Switch signal range to correct the situation.
NOTE: When learnt into the ZigBee Control Panel, the DIO-52 will be recognized as 2 separate devices (DI & DO) and will occupy 2 zones in
the Panel.
