Nokia 6275 Guía

Nokia Customer Care

6275/6275i (RM-154)

Mobile Terminals

Issue 1 - September 2006 Company Confidential

Antenna Description and

Troubleshooting

6275/6275i (RM-154)

Antenna Description and Troubleshooting Nokia Customer Care

Page 2 Company Confidential Issue 1 - September 2006

Contents Page

Introduction ..................................................................................................................................................... 3

CDMA Antenna on the E-Cover Assembly............................................................................................... 4

Damaged CDMA Radiator Bezel Assembly ...........................................................................................4

Missing or Damaged CDMA Antenna and IHF Pogo Pins ................................................................4

IHF Module ....................................................................................................................................................5

Obstructed RF Feed and Ground Pads ...................................................................................................5

Damaged RF Connector .............................................................................................................................5

Auxiliary Antennas: GPS, BT, and FM ....................................................................................................... 8

GPS Antenna .................................................................................................................................................8

Bluetooth Antenna ......................................................................................................................................9

FM Antenna ...................................................................................................................................................9

Circuit Diagrams and Chip Locations ..................................................................................................10

SAR Reduction Foil...................................................................................................................................... 13

Nokia Customer Care Antenna Description and Troubleshooting

6275/6275i (RM-154)

Issue 1 - September 2006 Company Confidential Page 3

Introduction

This troubleshooting guide addresses potential failures that affect antenna performance

of the 6275/6275i mobile terminals and discusses methods for correction of these

failures. Following are the three serviceable antennas used in the 6275/6275i mobile

terminals:

• CDMA antenna (on the E-cover assembly)

• GPS antenna (on the antenna module)

• Bluetooth antenna (on the D-cover assembly)

The following sections describe these antennas and their connections to the mobile

terminal components.

6275/6275i (RM-154)

Antenna Description and Troubleshooting Nokia Customer Care

Page 4 Company Confidential Issue 1 - September 2006

CDMA Antenna on the E-Cover Assembly

The E-cover (or antenna cover assembly) is comprised of the E-cover plastic part, the

CDMA antenna (or CDMA radiator) and the bezel assembly. The bezel assembly includes

the camera, flash windows, and the bezel.

The E-cover connects to the D-cover assembly via six tabs located on the four corners

and top edge of the E-cover, as well as a snap-in feature located on the bottom two

corners.

Figure 1: CDMA antenna on the E-cover

Damaged CDMA Radiator Bezel Assembly

The CDMA flex radiator antenna and bezel assembly are glued to the inside surface of

the E-cover. To remove the E-cover assembly from the D-cover, use the SRT-6 opening

tool to release the two snap-in tabs that secure the E-cover to the D-cover.

If either the CDMA radiator or bezel assembly is damaged, replace the E-cover assembly.

Note: You cannot replace the CDMA radiator or the bezel individually. You must

replace the entire E-cover assembly.

To reattach the E-cover assembly to the D-cover, align the E-cover above the D-cover

and apply a vertical force to engage the snap-in feature.

Missing or Damaged CDMA Antenna and IHF Pogo Pins

The CDMA antenna is connected to the PWB through two pogo pins. The CDMA antenna

pogo pins are housed in the D-cover (see Figure 1 on page 4).

If a CDMA antenna pogo pin is damaged or missing, replace the D-cover. An improper

connection between the CDMA antenna and the PWB due to a damaged or missing pogo

pin degrades the CDMA antenna performance by 5dB to more than 15dB.

Antenna pogo pins

Ground pin

Feed pin

E-cover assembly

Nokia Customer Care Antenna Description and Troubleshooting

6275/6275i (RM-154)

Issue 1 - September 2006 Company Confidential Page 5

IHF Module

The IHF module impacts the CDMA antenna performance. If there is any damage to the

IHF module, replace the acoustic module.

Figure 2: IHF module

Obstructed RF Feed and Ground Pads

The CDMA antenna ground and feed pogo pins touch the PWB on ground and feed pads.

• If the main antenna feed pad is obstructed, removed, or covered, the CDMA

antenna feed pogo pin does not touch the PWB and the antenna gain degrades

by more than 15 dB.

• If the CDMA antenna ground pad is obstructed, removed, or covered, the ground

pogo pin does not touch the PWB and the antenna gain degrades by more than

5dB.

• If corrosion is present or the pads are missing, replace the PWB.

• If either pad is obstructed or covered, clear or clean the pads.

• If the CDMA antenna matching network is missing or damaged, replace the

component.

• If the PWB is permanently damaged, replace the PWB.

Damaged RF Connector

The CDMA RF connector could fail by not connecting the RF input to the RF output of

the RF connector. If this happens, the antenna gain degrades by about 15dB. You can

check this by testing for DC conductivity between the RF connector’s RF input and

output.

GPS Antenna

Flex Strip on

side of IHF

6275/6275i (RM-154)

Antenna Description and Troubleshooting Nokia Customer Care

Page 6 Company Confidential Issue 1 - September 2006

Perform the DC conductivity test without a cable attached to the RF connector. Because

the RF connector is also a switch, the RF output disconnects from the RF input when a

cable is inserted into the RF connector. When a cable is not inserted, the RF input is

connected to the RF output of RF connector.

• CDMA RF input – connects to the duplexer

• CDMA RF output – connects to the antenna pad through vias

• RF connector – connects to a coaxial cable

If the RF input is not connected properly to the RF output, replace the RF connector.

Figure 3: Main PWB - bottom side

Figure 4: Main PWB - top side

Ground pad

Feed pad

CDMA antenna

matching network

RF connector

GPS pogo pins

Flash pogo pins

RF connector

Nokia Customer Care Antenna Description and Troubleshooting

6275/6275i (RM-154)

Issue 1 - September 2006 Company Confidential Page 7

Figure 5: CDMA antenna matching network schematics

6275/6275i (RM-154)

Antenna Description and Troubleshooting Nokia Customer Care

Page 8 Company Confidential Issue 1 - September 2006

Auxiliary Antennas: GPS, BT, and FM

See the Disassembly chapter for instructions about disassembling the mobile terminal for

auxiliary antenna troubleshooting.

GPS Antenna

The GPS antenna is a printed trace on a flex that adheres to the plastic audio module.

The GPS antenna connects to two pogo pins that are soldered to the PWB. The GPS flex

wraps around the side of the plastic audio module and ends near the audio port at the

top end of the module. Use an RF connector to test the GPS RF components directly.

Figure 6: Remove the audio module from the D-cover

The GPS antenna system has the following possible failure modes:

• If the solder bridge of the two GPS pogo-pin pads are dirty, remove and clean the

bridge.

• If the GPS SMD pogo pins are misaligned, properly align and solder them.

• If the GPS SMD pogo pins do not operate freely or easily in their sleeves, replace

them.

• If the wrong pogo pins are soldered at the GPS SMD pogo-pin location, use the

proper GPS pogo pins.

Note that the Flash pogo pins are 5.5mm high, while the GPS SMD pogo pins

are 3.8mm high. (See Figure 3 on page 6.)

• If the GPS SMD pogo pins are improperly soldered to their pads (e.g., cold solder

joint, cracked solder joint, insufficient solder, excessive solder causing tilting),

properly align and solder them.

• If the GPS flex antenna (see Figure 2 on page 5) shows damage to the pogo-pin

pad (pressure tearing, hole, cracking, corrosion, bubbles, etc.) replace the GPS/

audio module.

• If the GPS flex antenna shows damage to the flex (e.g., tearing, cracking,

corrosion, bubble, etc.), replace the GPS/audio module.

Use the SRT-6 opening

tool to remove the audio

module at these locations

IHF contact pins

Earpiece contact pins

Nokia Customer Care Antenna Description and Troubleshooting

6275/6275i (RM-154)

Issue 1 - September 2006 Company Confidential Page 9

• If the GPS flex antenna shows damage to the audio outer gasket or screen (e.g.,

permanently creased, indented, torn, dislodged, distorted, or pressed to the side,

abnormal shape, texture, coloration), replace the GPS/audio module.

• If the GPS flex antenna trace shows damage or contamination (e.g., cracking,

discoloration, corrosion, bubble.), replace the GPS/audio module.

• If the GPS cellular RF connector is defective, replace the RF connector and make

sure the orientation is correct.

Bluetooth Antenna

The bluetooth (BT) antenna is a stamped metal sheet formed with one spring contact and

heat-staked ultrasonically to the D-cover.

Figure 7: Bluetooth antenna

A 0.5pf shunt capacitor was used for antenna impedance matching on the main PWB.

Figure 8: Bluetooth matching component on the main PWB

The BT antenna system has following possible failure modes:

• If the BT antenna spring clip is deformed, replace the D-cover.

• If the BT antenna plastic heat stakes do not hold the metal antenna firmly,

replace the D-cover.

• If the D-cover is deformed or broken, replace the D-cover.

• If the antenna match component is broken, replace the match component.

FM Antenna

The FM-antenna uses the connection through the universal headset jack (UHJ) or the

Pop-port connector to a headset to create an FM antenna of reasonable gain. If the FM

antenna is not working, the chips, UHJ connector, or the Pop-port connector could be

bad.

6275/6275i (RM-154)

Antenna Description and Troubleshooting Nokia Customer Care

Page 10 Company Confidential Issue 1 - September 2006

The FM antenna system has following possible failure modes:

• If the chip components are bad, replace them.

• If the UHJ or Pop-port connector is bad, replace connector.

• If the headset is bad, replace it.

Circuit Diagrams and Chip Locations

Figure 9: Matching chips for the UHJ on the audio schematic

Figure 10: Matching chips for the UHJ on the top PWB component layout

Otros manuales para 6275

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Teléfono móvil de Nokia

Nokia

Nokia NPE-4 Manual de usuario

Nokia

Nokia N72 Manual de usuario

Nokia

Nokia 5700 - XpressMusic Smartphone 128 MB Manual de usuario

Nokia

Nokia 6205 Manual de usuario

Nokia

Nokia N77 Manual de usuario

Nokia

Nokia N73 - Smartphone 42 MB Hoja de especificaciones

Nokia

Nokia C5-03 Manual de usuario

Nokia

Nokia 2680 - Slide Cell Phone Manual de usuario

Nokia

Nokia RM-70 Manual de usuario

Nokia

Nokia 2652 - Cell Phone - GSM Manual de usuario

Nokia

Nokia RH-18 Series Manual de usuario

Nokia

Nokia RH-37 Series Manual de usuario

Nokia

Nokia 2285 - Cell Phone - CDMA2000 1X Manual de usuario

Nokia

Nokia 7710 - Cell Phone 90 MB Manual de usuario

Nokia

Nokia 3205 - Cell Phone - CDMA2000 1X Manual de usuario

Nokia

Nokia 5170i Manual de usuario

Nokia

Nokia 6800 Manual de usuario

Nokia

Nokia Lumia 620 Manual de usuario

Nokia

Nokia NSM-9DX Guía

Nokia

Nokia N86 Manual de usuario

Nokia

Nokia 6315i - Cell Phone 21.5 MB Guía del usuario

Nokia

Nokia N73 - Smartphone 42 MB Guía del usuario

Nokia

Nokia C6-01 Manual de usuario

Nokia

Nokia 7260 - Cell Phone - GSM Manual de usuario

Manuales populares de Teléfono móvil de otras marcas

Zte

Zte BLADE A520 Manual de usuario

Blackbe;rry

Blackbe;rry KEYone Manual de usuario

Bea-fon

Bea-fon X5 Premium Manual de usuario

Blackbe;rry

Blackbe;rry 8707 Series Manual de usuario

Blackbe;rry

Blackbe;rry Storm Instrucciones de funcionamiento

LG LM-X420QN Manual de usuario

LifeWatch

LifeWatch V Manual de usuario

Bea-fon

Bea-fon SILVER LINE SL860 Manual de usuario

IKI Mobile

IKI Mobile KF4.5i Manual de usuario

Hitech

Hitech HT-850 Manual de usuario

Yezz

Yezz Fashion F10 Manual de usuario

Point Mobile

Point Mobile PM60 Manual de usuario

Blackbe;rry

Blackbe;rry Q10 Manual de usuario

Blackbe;rry

Blackbe;rry Bold 9900 Manual de usuario

Blackbe;rry

Blackbe;rry STORM 9500 - VERSION 5.0 Manual de usuario

LG LM-K420EMW Manual de usuario

ISAFE MOBILE

ISAFE MOBILE IS655.2 Manual de usuario

LG Thrive Manual de usuario