2-Step unlocking
The keyless entry system can be installed to unlock the doors in two steps.
Pressing will unlock only the driver’s door. If is pressed within the next
three seconds, the remaining doors will unlock.
Trunk release
The keyless entry system may be interfaced to the vehicle’s electric trunk
release. By pressing and holding for 3-seconds, the vehicle’s trunk will open.
If the trunk release feature is not used, this button may be used to control other
options (remote car starter, window roll up, etc.).
Starter disable
The keyless entry system can be connected to a starter disable mechanism
providing security by disabling the ability to start the engine during an
attempted break-in.
REMOTE BATTERY REPLACEMENT
The remote control is powered by a 12-volt battery that lasts approximately six
months to one year depending on the frequency of use. A weak remote battery
will be indicated by the following symptoms:
A) Remote control range decreases.
B) The LED on the remote goes dim.
If the battery needs to be replaced, please see your authorized JTI dealer.
User Selectable Quiet Mode
Your keyless entry system has the ability to be locked and unlocked silently (no
horn honks). To place the keyless entry into quiet mode, press and
simultaneously on the remote control for three seconds. The parking lights will
flash once to indicate you have placed the system into quiet mode. You may
then lock and unlock the system silently by pressing on the remote control.
Quiet mode does not affect the panic feature.
To take the keyless entry system out of quiet mode, press and
simultaneously on the remote control for three seconds. The parking lights
will flash twice to indicate that you have placed the system into normal
operating mode. You may then lock and unlock the system by pressing
on the remote control.
Panic Feature
You may panic the system by pressing for three seconds. This is done to
attract attention to your vehicle. The horn will sound for thirty seconds. Pressing
on the remote control will turn the panic feature off early.
Multi-Car Remote Operation
Your remote control remote control is also able to operate a second vehicle if
that vehicle is equipped with a Nobody Messes With..It Keyless Entry system.
Your authorized JTI dealer can program this feature.
Vehicle #1 will be the primary vehicle (all functions will operate).
Vehicle #2 will be the secondary vehicle ( on the remote control will
lock/unlock the vehicle, no other functions will be available from the primary
remote on the secondary vehicle).
OPTIONAL FEATURES
Ignition controlled door locks
The vehicle’s doors can be programmed to lock automatically when the vehicle’s
ignition is turned on and unlock automatically when the ignition is turned off. The
lock and unlock function can be programmed independently by your authorized
JTI installer/dealer.
Interior illumination
The keyless entry system may be interfaced to the vehicle’s interior lights. When
the keyless entry system is disarmed/unlocked, the vehicle’s interior lights will
turn on. The interior lights will turn off after 25-seconds, if the vehicle is locked
with the remote control, or if the ignition is turned on.
23
