Niveo NGS24U Manual de usuario
NGS24U
24 Port 10M/100M/1000M Desktop
Gigabit Ethernet Switch
User’s Manual
- 1 -
Web Smart Switch
Ⅰ. Features Overview
Supports real-time status (link, speed, duplex) of each port
Supports port setting for enable or disable operation (the 1st
port can’t be disabled)
Supports port setting for N-Way or force mode operation
Supports Broadcast Storm Protection
Supports Port-bases VLAN
Supports priority queues for QoS
Ⅱ. Configure
Please follow the steps to configure this Web Smart switch.
Step 1:
Use a twisted pair cable to connect this switch to your PC.
Step 2:
Set your PC’s IP to 192.168.2.xx.
- 2 -
Step 3:
Open the browser (like IE…) and go to http:// 192.168.2.1
You will see the login screen as below:
Please key in the password to pass the authentication.
Password: admin
After the authentication procedure, the switch can be used now.
Step 4:
On the home page, select the configuration by clicking the icon
as below:
- Configuration
- Monitoring
- Maintenance
- Logout
- 3 -
Configuration: System Configuration
It shows system status, such as: MAC address, system firmware
version and so on.
You can change the user name, the password and IP address,
and click “Apply” to confirm the new change.
Afterwards, you can reset the switch by turning off and turning on
it to take the new user name, the password and IP address
effectively.
- 4 -
Configuration: Port Configuration
You can enable or disable Jumbo Frames by clicking the checking
box.
Select the “Port no.” which you want to configure the mode below,
- Auto speed
- enable/disable the port
- 10M/100M/1000M
- full/half-duplex
- enable/disable flow control
- 5 -
Configuration: VLAN Configuration
There are 16 VLAN groups.
Select and add a group into “VLAN ID” and then click the port
number which you want to put into the selected VLAN group.
- 6 -
Configuration: Aggregation/Trunk Configuration
Set up port trunk groups and then click the port number you want
to include into the same group.
There are eight groups to choose and the maximum for one group
is 24 ports.
- 7 -
Configuration: LACP Port configuration
Select the port number which you want to enable/disable its
protocol.
- 8 -
Configuration: RSTP Configuration
Select the port number which you want to enable/disable its
protocol.
- 9 -
Configuration: 802.1x Configuration
Select the “Port no.” which you want to configure the mode below,
- Auto
- Force Authorized
- Force Unauthorized
Otros manuales de Cambiar de Niveo
Niveo
Niveo NGS 24TP-AV Manual de usuario
Niveo
Niveo NGSME48T2H Manual de usuario
Niveo
Niveo NGS24TP-AV Manual de usuario
Niveo
Niveo NGSME24G4S Manual de usuario
Niveo
Niveo NGS16TP Manual de usuario
Niveo
Niveo NGSME48T4H Manual de usuario
Niveo
Niveo N10GSM8F8 Manual de usuario
Niveo
Niveo NGSM48T2 Manual de usuario
Niveo
Niveo NGS18T16 Manual de usuario
