- 3 -
Confirm that the power supply to be used is within the designated of
specification for this machine.
Failure to do this may cause fire or electric shock.
Avoid using the press in the following environment.
Failure to do this may cause fire or electric shock.
In the atmosphere of inflammable or ignitable gas
In the atmosphere of corrosive gas
In the ambient temperature of 5C or below
In the ambient temperature of 40C or above
In the atmosphere of high humidity (environment where humidity exceeds
85%)
In the environment subject to wetting by steam, water drop or dew
condensation, etc.
Be sure to wear heat-resistant gloves when operating this press.
Failure to do this may cause burn.
When operating this press, avoid touching the heat plate area even if
wearing heat-resistant gloves.
Press heat plates get heated to the preset temperature while being heated.
Failure to do this may cause burn, even if wearing heat-resistant gloves.
Avoid operating the press at the place close to combustible material.
Failure to do this may cause fire.
Always use the pre-setter of our product.
Failure to do this may cause fire or electric shock.
Use of the pre-setter made by other product may possibly spoil the safety
protection function of the product.
Use a dry cloth for cleaning this machine. Strictly avoid using alcohol,
benzene, thinner or other inflammable solvents.
Using inflammable solvents may cause fire.
Impressed voltage is directly applied to the power cable. Observe the
following precautions not to damage the cable.
Failure to do this may cause fire or electric shock.
Disconnect the power plug by hand.
Avoid pulling the cable to disconnect the power plug.
Avoid remodeling the power plug or replacing the plug with other
manufacturers.
Avoid placing a thing on the power cable.
Avoid bending the power cable.
Take care to prevent the power cable from touching the heat plate of the
press.
Connect the power plug to the socket correctly.
Failure to do this may cause electric shock.
The power cable of this machine uses an earth connection plug. Connect the
power plug correctly into an earth connection socket.
Model Power supply
NPS-1210A-1 100 - 120V 50 / 60Hz
NPS-1210A-2 200 - 240V 50 / 60Hz
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
