Ninja Master Prep Advantage QB800NZ 30 Manual de usuario

Master Prep™ Advantage

OWNER’S GUIDE

QB800NZ 30

QB800NZ_30_IB_120626_3.indd 1 12-06-26 12:59 PM

IMPORTANT SAFETY INSTRUCTIONS

For Household Use Only

WHEN USING ELECTRICAL

APPLIANCES, BASIC SAFETY

PRECAUTIONS SHOULD ALWAYS

BE FOLLOWED, INCLUDING THE

FOLLOWING:

READ ALL INSTRUCTIONS

BEFORE USING YOUR NINJA™

MASTER PREP™ ADVANTAGE.

IMPORTANT: This appliance can

be used by children aged from 8

years and above and persons with

reduced physical, sensory or mental

capabilities or lack of experience

and knowledge if they have been

given supervision or instruction

concerning use of the appliance

in a safe way and understand the

hazards involved. Children should

be supervised to ensure that they

do not play with the appliance.

Cleaning and user maintenance shall

not be made by children without

supervision.

WARNING:

TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK OR INJURY:

1. Close supervision is necessary when

any appliance is used by or near

children.

2. To protect against electric shock,

DO NOT immerse cord, plug or any

part of the main unit in water or any

other liquids.

3. DO NOT let cord hang over edge

of table or counter, or touch hot

surfaces.

4. DO NOT operate the appliance with

a damaged plug or cord, or if the

unit has been dropped, damaged

or dropped in water. To avoid

the risk of electric shock, do not

disassemble or attempt to repair

the appliance on your own. If the

supply cord is damaged, it must be

replaced by a qualiﬁed electrician

in order to avoid a hazard. Incorrect

re-assembly or repair can cause

a risk of electrical shock or injury

to persons when the appliance is

usedt.

5. Unplug appliance from outlet when

not in use and before cleaning.

6. DO NOT place on or near a hot gas

or electric burner.

7. The use of accessory attachments,

including canning jars not

recommended by the manufacturer

may cause ﬁre, electrical shock or

risk of personal injury.

8. Extreme caution must be used when

moving an appliance containing hot

food, water or other liquids.

9. Use this appliance on a stable work

surface away from water.

QB800NZ_30_IB_120626_3.indd 1 12-06-26 12:59 PM

24. If the appliance overheats, a thermal

switch will become activated and

shut off the motor. To reset, unplug

the appliance and let it cool down

for approximately 10 minutes before

using again.

25. THIS PRODUCT IS INTENDED FOR

HOUSEHOLD USE ONLY. Do not

use this appliance for anything

other than its intended use. Do not

use outdoors.

WARNING: Extension cords

are not recommended for use with this

product.

SAVE THESE

INSTRUCTIONS

10. DO NOT remove the motor head

before the chopping blades have

stopped turning.

11. CAUTION! Chopping blades are

sharp, handle with care. When

handling the chopping blades,

always hold by the plastic shaft.

12. DO NOT attempt to sharpen

blades.

13. DO NOT expose pitcher to extreme

temperature changes.

14. DO NOT use pitcher if it is cracked

or chipped.

15. DO NOT use the appliance if

chopping blades are bent or

damaged.

16. Avoid contact with moving parts

at all times. Keep hands, hair,

clothing as well as spatulas and

other utensils away from pitcher

during operation to prevent risk of

personal injury and/or damage to

the appliance.

17. Exercise extreme caution when

blending hot liquids.

18. Immediately release the On/Off

pulse button on the motor head

in the event that the appliance

malfunctions during use.

19. To reduce the risk of injury, NEVER

operate the appliance without the

splash guard in place; DO NOT try

to defeat the interlock mechanism;

make sure that the cutting blades

are properly assembled before

operating the appliance.

20. DO NOT use outdoors.

21. DO NOT use appliance for other

than intended use.

22. DO NOT operate the appliance for

more than 15 seconds.

23. DO NOT operate the appliance

empty.

QB800NZ_30_IB_120626_3.indd 2 12-06-26 12:59 PM

TECHNICAL SPECIFICATIONS

Voltage: 220-240V~, 50Hz.

Power: 500 Watts

Pitcher Capacity: 1.2 L (40 ounces) (5 cups)

The Ninja™ Master Prep™ Advantage is an indispensable kitchen tool that is perfect for

blending, whipping, ice crushing and food processing - all in the conveniently sized

‘Advantage’ pitcher! For best results, be sure to carefully read all the instructions

contained in the manual before using this appliance.

500 Watt Power Head

The 500 watt power head operates on 220-240V., 50Hz. electrical power. NEVER allow

the power head to become wet when plugged into an electrical outlet.

WARNING: The power head should never be immersed in water or any other liquid.

CAUTION: Make sure that the power head is unplugged from the electrical outlet and that

the blades have stopped turning before attaching or removing any accessory.

CAUTION: Blades are sharp! Use extreme caution when handling the blades. Always

hold them by the shaft. Do not attempt to sharpen blades.

IMPORTANT: Never run the appliance empty.

Z854

SAA110120EA

QB800NZ_30_IB_120626_3.indd 3 12-06-26 12:59 PM

Contents

Thank you for

purchasing

the Ninja™

Master Prep™

Advantage.

Getting Started ...................................................................................5

Using the Master Prep™ Advantage Pitcher ..............................6

Cleaning and Maintenance .............................................................8

Troubleshooting Guide ....................................................................8

QB800NZ_30_IB_120626_3.indd 4 12-06-26 12:59 PM

Getting Started

f Master Prep™ Advantage 1.2 L. Pitcher with

Non-Slip Base

g Spindle Pin

h Pitcher Storage Lid

i Power Cord (not shown)

a On/Off Pulse Button

b Power Head

c Pouring Spout

d Splash Guard

e Ninja™ 4-Blade

QB800NZ_30_IB_120626_3.indd 5 12-06-26 12:59 PM

Fig. 2

Using the Master Prep™ Advantage Pitcher

Fig. 1

Shaft

CAUTION: Blades are sharp! Use extreme

caution when handling the blades.

Always hold them by the shaft.

IMPORTANT: Never run the appliance

empty.

1 Place the Master Prep™ Advantage Pitcher

on a clean, dry, level surface.

2 Holding the blade by the shaft, place it

onto the spindle pin inside the pitcher.

(Fig. 1, a)

IMPORTANT: Place blade inside the

container carefully as blades are sharp.

WARNING: DO NOT try to place the

blade onto the power head and then into

the pitcher. (Fig. 1, b)

3 Add the ingredients to be processed into

the pitcher.

IMPORTANT: Never add ingredients into

the pitcher before placing the blades in

ﬁrst.

4 Place the pitcher splash guard onto the

top of the pitcher. (Fig. 1, c)

5 Place the power head on top of the

pitcher splash guard making sure that it

is securely in place. (Fig. 2)

WARNING: DO NOT attempt to operate

the appliance without the safety splash

guard in place.

QB800NZ_30_IB_120626_3.indd 6 12-06-26 12:59 PM

Fig. 3

6 To start the appliance, plug the power

cord into the electrical outlet, securely

hold power head while operating and

press on the On/Off pulse button located

on the top of the power head. (Fig. 3)

7 Hold the pitcher ﬁrmly while depressing

the On/Off pulse button to ensure the

unit stays in place.

NOTE: DO NOT operate the appliance

continuously for more than 15 seconds at

a time.

8 To stop the appliance, remove your

ﬁngers from the On/Off pulse button.

9 In order to obtain a better quality of

chopping, operate the appliance by using

the “pulse” method.

10 Make sure that the blades have stopped

completely before removing the power

head.

11 If the ingredients stick to the side of the

pitcher, stop the appliance, remove the

power head and the splash guard. Use a

spatula to dislodge the pieces and then

replace the splash guard and the power

head. Continue processing.

12 Depending on the consistency of the

contents, use the pouring spout to empty

liquid contents.

13 For thicker consistencies, ﬁrst remove

splash guard and blade (by its shaft),

then empty contents of the pitcher.

HINTS & TIPS FOR USING YOUR NINJA™

MASTER PREP™ ADVANTAGE

• The chopping blades can be used for

chopping meat, ﬁsh, vegetables, cheese etc.

• For mincing, chopping and pureeing,

increase the length of pulses.

• For coarse chopping, use short, quick

pulses and monitor food texture.

• Pre-cut larger pieces to make them ﬁt

into the Master Prep™ Advantage. When

chopping hard foods (e.g. meat, cheese) cut

into 1-inch cubes.

• To crush ice into snow, start by using short

pulses to break up large chunks. Continue

until snow is achieved.

Using the Master Prep™ Advantage Pitcher - cont’d

QB800NZ_30_IB_120626_3.indd 7 12-06-26 12:59 PM

Cleaning and Maintenance

CAUTION: Make sure that the power head is unplugged from power source before

inserting or removing any attachment and before cleaning.

DO NOT immerse the power head into water or any other liquid. Clean with a damp

sponge or cloth and wipe dry.

The Master Prep™ Advantage pitcher, storage lid, splash guard and blades are all

dishwasher safe. It is recommended to place the storage lid and the blades on the top

rack. Use extreme caution when handling the blades as they are very sharp.

Clean the Ninja™ Master Prep™ Advantage and all parts before ﬁrst use and immediately

after each use.

PROBLEMS POSSIBLE REASONS & SOLUTIONS

Motor Doesn’t Start

or Blades Don’t

Rotate.

Check that the bottom of motor head is clean and

there is no food blocking connection when placing on

containers.

There is too much food in the pitcher.

The unit has overheated. Unplug and wait approximately

10 minutes before using again.

Make sure the splash guard is securely on pitcher.

Make sure the power head is securely placed on splash

guard.

Check that the plug is securely inserted into the electrical

outlet.

Check fuse or breaker. Replace fuse/reset breaker.

Food is Unevenly

Chopped.

Either you are chopping too much food at one time, or

the pieces are not small enough. Try cutting the food

into smaller pieces of even size and processing smaller

amounts per batch.

Food is Chopped Too

Fine or is Too

Watery.

The food has been over processed. Use brief pulses or

process for shorter time. Let blades stop completely

between pulses.

Food Collects On

Splash Guard/Safety

Cover or On the Sides

of the pitcher.

You may be processing too much food. Turn the machine

Off. When the blades stop rotating, remove the power

head and the splash guard. Remove some of the food

being processed.

You Cannot Achieve

Snow From Solid Ice.

Do not use ice that has been sitting out or has started

to melt. Be sure to use short pulses in the beginning to

break up large pieces.

Troubleshooting Guide

QB800NZ_30_IB_120626_3.indd 8 12-06-26 12:59 PM

Notes

QB800NZ_30_IB_120626_3.indd 9 12-06-26 12:59 PM

Tabla de contenidos

Otros manuales de Licuadora de Ninja

Ninja

Ninja BL682NZ Manual de usuario

Ninja

Ninja FOODI CB352ANZ Manual de usuario

Ninja

Ninja NUTRI PRECISION BLENDER Manual de usuario

Ninja

Ninja TWISTI SS150 Series Manual de usuario

Ninja

Ninja FOODI POWER MIXER CI100 Series Manual de instalación y operación

Ninja

Ninja DETECT TB200 Series Manual de usuario

Ninja

Ninja STORM QB751QBK 30 Manual de usuario

Ninja

Ninja BL450EU Manual de usuario

Ninja

Ninja 4-IN-1 KITCHEN SYSTEM Manual de usuario

Ninja

Ninja BL450SM Series Manual de usuario

Ninja

Ninja CT610UK Manual de usuario

Ninja

Ninja BL470 series Manual de usuario

Ninja

Ninja Master Prep Professional QB1007Q Manual de usuario

Ninja

Ninja BL685 Manual de usuario

Ninja

Ninja Pulse Bl200QUK series Manual de usuario

Ninja

Ninja BL454Q Series Manual de usuario

Ninja

Ninja STORM QB750Q Series Manual de usuario

Ninja

Ninja QB1004 series Manual de usuario

Ninja

Ninja Foodi CO351B Series Manual de usuario

Ninja

Ninja QB3001NZ Manual de usuario

Ninja

Ninja BC151UK Series Manual de usuario

Ninja

Ninja BL480EU Manual de usuario

Ninja

Ninja Ninja Pulse BL205 Manual de usuario

Ninja

Ninja BL642ME Manual de usuario

Manuales populares de Licuadora de otras marcas

ROTOR

ROTOR 1125.201 Manual de usuario

Braun

Braun Multiquick 5 Vario series Manual de usuario

ARENDO

ARENDO MIRA 305424 Manual de usuario

CHEF-BUILT

CHEF-BUILT CCB-3500 Manual de usuario

Viconte

Viconte VC-4406 Manual de usuario

Oster

Oster BLSTAB-CB0 Manual de usuario

HOFFEN

HOFFEN MC-3005 Manual de usuario

Black & Decker

Black & Decker BLC18750DM Manual de usuario

Sunbeam

Sunbeam 4182 Manual de usuario

Bialetti

Bialetti FMX35 Manual de usuario

Black & Decker

Black & Decker BL8000 Manual de usuario

Duronic

Duronic BL530 Manual de usuario

Exquisit

Exquisit MS 3002 wes Manual de usuario

Lumme

Lumme LU-KP1891A Manual de usuario

Binatone

Binatone HB-735 Manual de usuario

Moulinex

Moulinex LM936E10 Manual de usuario

Oster

Oster VERSA Manual de instalación y operación

Vigan Mammoth

Vigan Mammoth TM4V1 Manual de usuario