Nikon D7000 Manual de usuario
Page 1of 30
Nikon D7000 Camera Kit
-Checklist and Operations Manual-
July 31, 2013
SRQ Composite Squadron, FLWG, Civil Air Patrol
Page 2of 30
1.0 Equipment Pre-Mission Check
1.1 Open the camera case and verify the following items are enclosed
Nikon D7000 camera, MB-D11 Battery Grip, 18-105mm Nikkor lens, 50mm
Nikkor lens, UV filters and lens caps.
2 rechargeable camera batteries (one stored in the battery grip)
Nikon GP-1 GPS attachment with attached cable
Charger for camera batteries
Instruction manuals for D7000, GP-1
Page 3of 30
D7000 Camera
Battery Grip
Lens Cover & Lens Shield
(lens Shield not used)
SD Memory Card
Battery Charger and Battery
Battery
Page 4of 30
Adapter for 4 AA Batteries
(use when rechargeable
batteries are discharged)
GP1 GPS Adapter
USB Cable
50mm F1.8 Lens
1.2 Charge Camera Batteries
To remove the battery pack from the camera body, open the door on the bottom of the
camera by moving the release lever. When the battery access door opens, move the
yellow release lever until the battery pack pops free. There is one battery pack in the
battery grip. To remove the battery pack from the battery grip, pull the release ring out
and turn counter-clockwise to open the battery grip. Slide the insert out and remove
the battery by pressing the button marked “push” and slide the battery free. Charge
each battery pack, one at a time, and bring the batteries to full charge. The indicator
light will flash during charging. When fully charged, the light will illuminate
continuously.
Page 5of 30
Battery Compartment Release
Battery release lever
Battery Grip Release Tab
Battery Pack Tab Marked “push”
Page 6of 30
1.3 Nikon D7000 Camera Pre-mission Initiation
Verify the Camera is turned off
Mode Selector On/Off Switch
Install memory cards
(cards may already be in the camera) by moving the door located on the right side of the camera and
pushing it slightly toward the rear of the camera to open the memory card access cover. The cards are
installed by gently pushing the card in until it clicks in place. A light located on the back-right of the
camera will briefly illuminate to confirm the card is seated. The card can be removed by pushing the
card in and it will pop out. Two 32 GB cards are furnished with the system.
SD Memory Cards Memory Card Access Cover
Page 7of 30
Set the lens autofocus switch to AF Set the camera autofocus switch to AF
Just to the left of the camera AF switch is the lens optical
stabilizer switch (OS). Place this switch to ON.
Rotate mode switch to "S".
The Mode switch is located on the top-left side of the camera.
Page 8of 30
Install the Nikon GP1 GPS
If the cable is not attached to the GP-1, insert the smaller connector into
the GP-1 while lining up the arrows on the GP-1 and cable. Push it in
until it snaps in place hiding the arrows.
The other end of the cable goes into the GPS port on the camera. The
arrow on the connector should face the back of the camera. Slide the
connector all the way in. It does not snap in place.
Page 9of 30
Insert camera batteries
The D7000 body holds one battery. The MB-D11 holds one battery. The
D7000 will operate properly without the MB-D11. The MB-D11 extends
operation time. If the MB-D11 Battery grip is attached, it must be
removed before replacing the battery in the camera body. At the back of
the MB-D11 is a wheel labeled “lock”.
To remove the MB-D11 turn the wheel to the left and the battery grip
will separate from the camera body.
With the MB-D11 removed, the battery compartment on the D7000 is
located on the bottom of the camera. Move the battery compartment
release toward the middle of the camera and the battery door will open.
With the door open, move the yellow release until the battery pops up.
To install a battery, with the battery door open push the battery in until it
snaps in place. Close the battery door, and attach the MB-D11.
The MB-D11 holds one battery. To access the battery compartment, pull
the release tab located on the side of the MB-D11. With the tab straight
out turn the tab in direction of the green arrow. The battery compartment
will slide out and expose the battery. To release the battery, push on the
tab labeled “push” and the battery will slide free. To install a battery,
slide the battery with the contacts down until it snaps into place. Then
slide the compartment into the MB-D11 and turn the release tab to lock
in place.
The MS-D11 also has an accessory that replaces the rechargeable battery
compartment with one that holds 4 AA batteries. Observe proper polarity
when installing batteries. The compartment slides in place in the same
manner as the standard rechargeable one. Photos on page 5
Page 10 of 30
Remove Lens Cap
Turn on the camera
Check Batteries
Note: the battery symbol above shows the status of the battery in use. When two batteries
are installed it is better to follow the procedure below to check battery status.
Press the "Info" button to turn on the Monitor.
The following will show on the Monitor. Both batteries are shown;
the active battery (chosen by the camera) and the standby battery.
Otros manuales para D7000
12
Tabla de contenidos
Otros manuales de Cámara digital de Nikon
Nikon
Nikon D5300 Manual de usuario
Nikon
Nikon COOLPIX L820 Manual de usuario
Nikon
Nikon CoolPix S8200 Manual de usuario
Nikon
Nikon COOLPIX L840 Manual de usuario
Nikon
Nikon Coolpix 5900 Manual de usuario
Nikon
Nikon D-40 - D40 6.1MP The Smallest Digital SLR... Manual de usuario
Nikon
Nikon D300 Manual de usuario
Nikon
Nikon Coolpix L14 Manual de usuario
Nikon
Nikon D-40 - D40 6.1MP The Smallest Digital SLR... Manual de usuario
Nikon
Nikon COOLPIX AW120 Manual de usuario
Nikon
Nikon COOLPIX 5200 Manual de usuario
Nikon
Nikon COOLPIX S02 Manual de usuario
Nikon
Nikon D2XS Manual de usuario
Nikon
Nikon Coolpix 880 Manual de usuario
Nikon
Nikon COOLPIX 3700 Manual de usuario
Nikon
Nikon Coolpix L15 Manual de usuario
Nikon
Nikon D3000 Manual de usuario
Nikon
Nikon Z fc Manual de usuario
Nikon
Nikon D3S Manual de usuario
Nikon
Nikon Coolpix L29 Manual de usuario
