BA W-ALS 50X35_50X55 01/20 GB
Niedax GmbH & Co. KG - Asbacher Straße 141 - D-53545 Linz/Rhein
T
el.:
+49
(0
26
44)
56
06-0
-
Fax:
+49
(0
26
44)
56
06-13
-
[email protected] -
www.niedax.de
DISASSEMBLY (SEE FIGURE 02, 03)
Now the punching process can be started by pressing the operating switch (1.4). The opera-
ting switch has to be pressed until a clear crunch from the metal sheet, signifying the comple-
te cut, can be heard and the loose metal sheet section can be seen.
The „drive on block” of the punch on the mould is to be avoided!
Afterwards the reset lever (1.5) of the basic unit is pressed and the notching tool opens (the
punch separates from the mould).
In case the basic unit has reached the end position beforehand, it is now required to press
theresetlevermorermly.
The entire tool is now either removed from the surface metal raceway by lifting it up or moved
sideways for punching further notches.
It is not permitted to punch more than 40 notches in a row due to the risk of overheating the
hydraulic punch.
Forthenextuseonadierentsurfacemetalracewaythenut(2.2)hastobefullyloosenedto
open the notching tool and tightened again after putting the notching tool in position.
No sheets of metal should remain in the mould of the notching tool. If there are they must be
removed.
• Whendisassemblingthenotchingtoolitisabsolutelynecessarytoremove the battery
(1.3) of the drive / basic unit.
• Afterwardsthenotchingtoolcanbeunscrewedfromthebasicunitviathethreadedbolt
(2.1).
• Theinnergearofthebasicunitdoesn’thaveaself-lockingcapacity.
• Becauseofthisitispossibleforthegearofthebasicunittoturnwiththemotionof
unscrewing the notching tool and making disassembly impossible.
• Inthiscasethebatteryhastobeinsertedagain.
• CAUTION: Risk of injury, keep hands out of the area of the notching tool!
• Thentheoperatingswitch(1.4)isactivateduntiltheendpositionisreached.Afterwardsthe
battery is removed. Now the gear of the basic unit (1) is blocked and the notching tool (2)
can be unscrewed. Once this is done, the reset lever has to be pushed for the gear to be
loosened again by the hydraulic system.
7/8
