Nexcom Peak 703P Series Manual de usuario
www.nexcom.com
Single Board Computer
Peak 703P Series
User’s Manual
2005-08 Edition
Peak 703P User’s Manual 1 Preface
Preface
Copyright
This publication, including all photographs, illustrations and software, is protected under international
copyright laws, with all rights reserved. No part of this manual maybe reproduced, copied, translated or
transmitted in any form or by any means without the prior written consent from NEXCOM International
Co., Ltd.
Version 1.0
Copyright 2005
Disclaimer
The information in this document is subject to change without prior notice and does not represent
commitment from NEXCOM International Co., LTD. However, users may update their knowledge of any
product in use by constantly checking its manual posted on our website: http://www.nexcom.com.
NEXCOM shall not be liable for direct, indirect, special, incidental, or consequential damages arising out
of the use of any product, nor for any infringements upon the rights of third parties, which may result
from such use. Any implied warranties of merchantability of fitness for any particular purpose is also
disclaimed.
Acknowledgements
The Peak 703P series is a trademark of NEXCOM international CO., LTD. All other product names
mentioned herein are registered trademarks of their respective owners.
Regulatory Compliance Statements
This section provides the FCC compliance statement for Class A devices and describes how to keep the
system CE compliant.
Federal Communications Commission (FCC) For Class A Device
This equipment has been tested and verified to comply with the limits for a Class A digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. Operation of this equipment in
a residential area (domestic environment) is likely to cause harmful interference, in which case the user
will be required to correct the interference (take adequate measures) at their own expense.
Peak 703P User’s Manual 2 Preface
CE Certification
The product(s) described in this manual complies with all applicable European Union (CE) directives if it
has a CE marking. For computer systems to remain CE compliant, only CE-compliant parts may be used.
Maintaining CE compliance also requires proper cable and cabling techniques.
Safety Information
Before installing and using the Peak 703P, note the following precautions:
Read all instructions carefully.
Do not place the unit on an unstable surface, cart, or stand.
Follow all warnings and cautions in this manual.
When replacing parts, ensure that your service technician uses parts specified by the manufacturer.
Avoid using the system near water, in direct sunlight, or near a hearing device.
WARNINGS
Read and adhere to all warnings, cautions, and notices in this guide and
the documentation supplied with the chassis, power supply, and accessory
modules. If the instructions for the chassis and power supply are inconsistent
with these instructions or the instructions for accessory modules, contact
the supplier to find out how you can ensure that your computer meets
safety and regulatory requirements.
CAUTION
Electrostatic discharge (ESD) can damage NSA components. Do the
described procedures only at an ESD workstation. If no such station is
available, you can provide some ESD protection by wearing an antistatic
wrist strap and attaching it to a metal part of the computer chassis.
Peak 703P User’s Manual 3 Table of Content
Table of Content
Preface
......................................................................................................................................................1
Copyright
................................................................................................................................................1
Disclaimer
...............................................................................................................................................1
Acknowledgements
...........................................................................................................................1
Regulatory Compliance Statements
.......................................................................................1
Federal Communications Commission (FCC) For Class A Device
....................1
CE Certification
..................................................................................................................................2
Safety Information
............................................................................................................................2
Table of Content
.................................................................................................................................3
Chapter 1 General Information
1.1 Features.............................................................................................................................................7
1.2 Specification .....................................................................................................................................7
1.3 Power Consumption Measurement................................................................................................9
1.4 Board Layout .................................................................................................................................10
1.5 Board Dimensions..........................................................................................................................11
Chapter 2 Jumper Setting
2.1 Before You Begin............................................................................................................................13
2.2 Precautions .....................................................................................................................................13
2.3 Setting Jumpers .............................................................................................................................14
2.4 Location of Jumpers ......................................................................................................................15
2.5 Function of Jumper .......................................................................................................................15
2.6 Pin Definition .................................................................................................................................16
Chapter 3 Expansion Capability
3.1 Installing SODIMM.......................................................................................................................27
Peak 703P User’s Manual 4 Table of Content
3.2 Installing Compact Flash ..............................................................................................................29
3.3 Installing Intel Pentium-M CPU and Fan Heatsink...................................................................30
Chapter 4 Award BIOS Setup
4.1 About the BIOS ...........................................................................................................................33
4.2 When to Run BIOS .....................................................................................................................33
4.3 Entering Setup.............................................................................................................................34
4.4 The Main Menu...........................................................................................................................34
4.5 Getting Help ................................................................................................................................35
4.6 Control Keys................................................................................................................................36
4.7 Standard CMOS Features ..........................................................................................................37
4.8 Advanced BIOS Features ...........................................................................................................38
4.9 Advanced Chipset Features........................................................................................................40
4.10 Integrated Peripherals.................................................................................................................42
4.11 Power Management Setup ..........................................................................................................45
4.12 PnP/PCI Configurations .............................................................................................................48
4.13 PC Health Status..........................................................................................................................49
4.14 Load Fail-Safe Defaults...............................................................................................................49
4.15 Load Optimized Defaults ............................................................................................................49
4.16 Set Password.................................................................................................................................50
4.17 Save & Exit Setup ........................................................................................................................50
4.18 Exit Without Saving.....................................................................................................................50
Appendix A IO PORT ADDRESS MAP
A.1 IO PORT ADDRESS MAP ..........................................................................................................53
Appendix B GPI/O Programming
B.1 Programming the GPI/O ..............................................................................................................56
Appendix C Watchdog Timer
C.1 Watchdog Timer Working Procedure .........................................................................................59
C.2 Watchdog Timer Control Register ..............................................................................................60
C.3 Watchdog Timer Programming Procedure ................................................................................60
Peak 703P User’s Manual 5
Peak 703P User’s Manual 6 Chapter 1
Chapter 1
General Information
Peak 703P User’s Manual 7 Chapter 1
1.1 Features
The Peak 703P is a member of NEXCOM’s P4-based SBC family. The features of this model are as
follows:
•
Socket 478 / uFCBGA2 479 for Intel® Pentium® M / Celeron® M Processor up to 2GHz+ with
400 MHz FSB
•
Intel® 852 GM (E) / ICH4 Chipsets
•
184-pin DIMM x1, support DDR200/266 SDRAM memory up to 1GB
•
Intel® 82551ER 10/100 LAN x 1 or Intel® 82541ER GbE LAN x 1
•
USB 2.0 ports x 4,Serial ports x 4,LVDS interface x 1
1.2 Specification
System Architecture - Small Form Factor with 4 screw holes for Embedded Application or
Optional PCB Solder Side Protected Plastic Plate
- Half-size SBC with PCI-ISA Golden finger
CPU support - Single 478uFCPGA/479uFCBGA socket
- Support Intel® Dothan : 2MB on Die L2 Ca
che , 400 MHz FSB,
speed up to 2.0GHz
-
Support Intel® Pentium® M : 1MB on Die L2 Cache, 400 MHz
FSB, speed up to 1.7GHz
- Support Intel® Celeron®-M: 512KB on Die L2 Cache , 400 MHz
FSB, speed up to 1.3GHz
Memory - 200-pin SO-DIMM socket x 1
- Support un-buffered non-ECC DDR 200/266 up to 1GB
BIOS - Award System BIOS
- Advanced Configuration & Power Interface support
- 4M bits flash ROM
- Advanced Power Management support
Chipsets - Intel® 852GM/GME (GMCH)
- 4M bit Flash BIOS
- Intel® FW82801 (ICH4)
LAN - Intel®82541ER Gigabit Ethernet LAN x 1
- RJ45 with LED x 1
- Driver support: Windows 2003/2000/XP, Linux
Display -Intel® 852GM/GME integrated dynamic video shared memory, 32
MB max adjusted by OS
- VGA interface: D-sub 15-pin for standard CRT
-
Resolution : Up to 1600 x 1200 for CRT or UP to 1280 x 1024 for
Peak 703P User’s Manual 8 Chapter 1
TFT
- Internal LVDS: Support 18/24bit single pixels or 18-bit dual pixels
LVDS panel (Resolution support up to 1280 x 1024)
- Dual Display : Simultaneous Scan-CRT + LVDS LCD, Dual
View-CRT+LVDS LCD
I/O Interface - 5-pin for key lock
- Serial port: 40-pin box headerx1 support RS232 x 4 (optional
COM2 RS232/422/485 by switch)
- USB 2.0 portx4
- HDD: Ultra ATA 100/66/33 support, 40 pin connector x1
- CF socket x 1
- Parallel Port: 26-pin connector x 1
- PS/2 keyboard/mouse: 6-pin MiniDIN connectorx1
- AC97 audio interface: 4-pin header x 3 for Line-in/Line-out/Mic-in/
- Speaker-out x 1
- Digital I/O port: 8 sets general purpose I/O each with TTL level
Interface
- LVDS Single Channel
I/O on Bracket - Gigabit Ethernet LAN with LED x1
- PS2 Keyboard/Mouse Mini DIN x 1
- VGA 15-pin D-sub connectorx1
- USB connector x 1
System Monitor - One Fan speed (For CPU)
- System monitor controller derived from IT8712
- 7 voltage (For Vcore, +1.05V, +1.2V, +2.5V, +3V, +5V, +5V
Stand-By)
-
2 temperature (one for CPU internal use, another for external system
use)
Real Time Clock - On chip RTC with battery back up
- Lithium battery x 1
Power Requirement - TBD
Watchdog Timer - 1, 2, 4, 8, ...128 seconds time-out intervals
Dimensions - 186.5mm(L) x 127.5mm(W)
Environments - Operating temperatures: -20°C to 70°C
- Storage temperatures: -20°C to 80°C
- Relative humidity: 10% to 90% (Non-condensing)
Certification - CE approval
- FCC Class A
Peak 703P User’s Manual 9 Chapter 1
1.3 Power Consumption Measurement
Test Condition : Win2000 HCT9.5 and KPower
Test Equipment :
CPU Pentium-M 2.0GHz
DRAM Model P/N and Size
Apacer 78.92046.561\512MB
HDD Model P/N DJSA-210
Power Supply Model P/N ST-300GL
Power Rail +12V +5V +3.3V
Power Consumed 0.12A 6.9A NA
Tabla de contenidos
Otros manuales de Computadora de placa única de Nexcom
Manuales populares de Computadora de placa única de otras marcas
WIN Enterprises
WIN Enterprises PL-80910 Manual de usuario
AXIOMTEK
AXIOMTEK SBC81206 Series Manual de usuario
Embest
Embest SOM-PH8800 Manual de usuario
SeaLevel
SeaLevel SBC-R9 Manual de usuario
SMART Embedded Computing
SMART Embedded Computing ATCA-8310 Manual de usuario
WinSystems
WinSystems PPM-LX800-G Manual de usuario
GIGAIPC
GIGAIPC QBiX-PPC Series Manual de usuario
OLIMEX
OLIMEX A10S-OLinuXino-MICRO Manual de usuario
Commell
Commell FS-978 Manual de usuario
GIGAIPC
GIGAIPC QBiP-8665A/ Manual de usuario
VersaLogic
VersaLogic Python EBX-11 Manual de usuario
Micro Computer Specialists
Micro Computer Specialists IRV-3702 Manual de usuario
