How to use Z800R
Z800R doesn’t support wireless on/off control. 800R can be switched by a echanical
toggle switch attached. Toggle switch ay not specifically On or Off in either switch
position depends on the previous switch position at last power cycle.
Per it other device to join
Z800R is featured to be a router in the network. It per its other devices to join the network.
In nor al operation, by default the router device Z800R does not per it any device to join
to the network to protect the network fro unexpected or unauthorized join atte pt. You
will need to open up the per it-join on Z800R or on other router device to allow new
devices (a router or an end device) to join.
Z800R is capable of holding 6 routers and 14 end devices.
Operation:
1. Short press the binding ey once (must be shorter than 3 seconds of ey press).
2. The per it-join is now enabled for 60 seconds and the indicator light will flash 60
ti es.
3. Z800R waits the new device to join in auto atically. Please note that the axi u
waiting ti e to join is 60 seconds. Repeat the process if you issed the 60 seconds
period.
Within the period of 60 seconds, press the binding key twice when you would like to
disable the per it-join feature.
Restore to factory setting
Z800R is capable of storing and saving includes network routing infor ation. If you wish to
re ove Z800R fro an exited network, you would need to clear the saved routing
infor ation to join to a new network by si ply reset the device to restore to the factory
setting.
Step 1. Re ove Z800R fro the power socket, use a pin and hold on to the binding key.
Step 2. While doing so, plug Z800R back to the power socket to give power then release
the pin.
Step 3. If restore to factory setting is successful, you should see the indicator light
flashes quic ly. Now the device has restored to the factory setting.
Now if you wish Z800R to join to a new network please power cycle the device again to
