Mounting the AIRNET
Outdoor Bridge in a
Pole or Tower
Netkrom AIRNET Outdoor Bridge device
can be mounted on the pole or tower as
shown in following:
1.- Attach the mounting bracket to the back
of the radio using the four hex screws
provided. (Do not over tighten the screws.)
Note:The bracket in the illustration side
shows the normal orientation which allows
the wireless unit to be pointed up towards
the base station antenna. However, if you
live somewhere that would require you
pointing the device down towards the base
station antenna (for example, you are on the
side of a mountain in view of the base station
antenna below), reverse the bracket so the
Netkrom wireless radio Unit can be “tilted”
downward when you aim the AIRNET
Outdoor Bridge in a later step.
2.- You can use the pipe bracket assembly
for either thin or thick poles by just inverting
the position of one of the elements as it
shown on the right.
Note: Do not tighten the screws all the way
because you will need to adjust the AIRNET
Outdoor Bridge direction in a later step.
4.- Mount the AIRNET Outdoor Bridge to
the top of the pipe or other support and point
the AIRNET Outdoor Bridge in the
approximate direction of the base station
antenna, then hand-tighten the nuts on the
mounting system.
