NETGEAR RangeMax WNR1000 Manual de usuario

January 2009

208-10430-01

v1.0

NETGEAR, Inc.

350 E. Plumeria Drive

Santa Jose, CA 95134 USA

N150 Wireless Router

WNR1000 Setup Manual

Trademarks

NETGEAR and the NETGEAR logo are registered trademarks, and RangeMax and Smart Wizard are trademarks of

NETGEAR. Inc. Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation. Other

brand and product names are registered trademarks or trademarks of their respective holders.

Statement of Conditions

In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to

make changes to the products described in this document without notice.

NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit

layout(s) described herein.

iii

Contents

N50 Wireless Router WNR1000 Setup Manual

Getting to Know Your Wireless Router................................................................................1

Unpacking Your New Router .............................................................................................1

Hardware Features ............................................................................................................2

Front Panel ..................................................................................................................3

Back Panel ..................................................................................................................4

Router Label ................................................................................................................5

Positioning Your Wireless Router ......................................................................................5

Installing Your Wireless Router ..........................................................................................6

Updating Your Router Firmware ........................................................................................7

Installing Your Router Using the Smart Wizard...................................................................9

Using the Smart Wizard .....................................................................................................9

Accessing Your Router After Installation .........................................................................11

Manually Installing Your Router .........................................................................................13

Connecting Your Wireless Router ....................................................................................14

Verifying Your Connection ...............................................................................................17

Setting Up Your Router for Internet Access .....................................................................18

Configuring Your Wireless Network...................................................................................21

Specifying Wireless Settings ...........................................................................................21

Setting Your SSID and Wireless Security Manually ..................................................21

Using Push 'N' Connect (WPS) to Configure Your Wireless Network .......................23

Testing Basic Wireless Connectivity ................................................................................26

Troubleshooting...................................................................................................................29

Basic Setup Checklist ......................................................................................................29

Checking Basic Router Functions ...................................................................................30

Troubleshooting Login Problems .....................................................................................32

Checking the Internet Service Connection ......................................................................33

Obtaining an Internet IP Address ....................................................................................33

Troubleshooting PPPoE ............................................................................................34

Troubleshooting Internet Browsing ...........................................................................35

Using the Ping Utility to Troubleshoot ..............................................................................35

Testing the Path from Your Computer to Your Router ...............................................35

Testing the Path from a Computer to the Internet .....................................................36

Technical Specifications .....................................................................................................37

Default Configuration Settings .........................................................................................37

Restoring the Default Password and Configuration Settings ...........................................39

Related Documents..............................................................................................................41

Registration and Certifications............................................................................................43

Getting to Know Your Wireless Router 1

Getting to Know Your Wireless Router

Congratulations on your purchase of a NETGEAR® high-speed wireless router, the N150

Wireless Router WNR1000.

Before you begin installing your router, check the package contents (see “Unpacking Your New

Router” on page 1). Become familiar with the front and back panels of your router—especially the

status lights—and the important information on the router label (see “Hardware Features” on

page 2). Then, read the section on “Positioning Your Wireless Router” on page 5 to ensure that you

have selected the best location to install your router.

Unpacking Your New Router

Your product package should contain the following items:

• The N150 Wireless Router

• A snap-on stand for your wireless router

• An AC power adapter (varies by region)

• A yellow Ethernet cable

•TheResource CD, which includes:

– The Smart Wizard Installation Assistant (Autorun.exe)

– A PDF version of this manual

– A link to the online User Manual

• Warranty and Support Information cards

If any of the parts are incorrect, missing, or damaged, contact your NETGEAR dealer. Keep the

carton, including the original packing materials, in case you need to return the product for repair.

A link to the online User Manual is also available from the router interface,

after the router is installed. Click Documentation on the main menu.

2 Getting to Know Your Wireless Router

To prepare your router for installation:

1. Carefully peel off the protective film covering the sides of your router.

2. Set up your wireless router by inserting the router into the stand supplied with it.

3. Place your router in a suitable area for installation (near an AC power outlet and accessible to

the Ethernet cables for your wired computers).

Hardware Features

Before you install and connect your router, take a moment to become familiar with the front and

back panels of the router—especially the status lights on the front panel.

Figure 1

Getting to Know Your Wireless Router 3

Front Panel

The router front panel, shown in Figure 2, contains status lights. (For more information on

interpreting the status lights, see “Verifying Your Connection” on page 17 and “Checking Basic

Router Functions” on page 30.)

You can use the status lights to verify various conditions.

Figure 2

Table 1. Status Light Descriptions

Label Activity Description

1. Power

Solid Amber

Solid Green

Blinking–Amber

Blinking–Green

Off

The router is performing the power-on self-test diagnostic.

The power is on and the router is ready.

A software update is in progress.

Firmware is corrupted. See “Checking Basic Router Functions” on

page 30 for instructions on restoring your router firmware.

Power is not being supplied to the router

2. Push 'N'

Connect

Solid Green

Blinking Green

Off

Indicates a (WPS) connection to a WPS-capable device.

WPS-capable device can associate with the router within 2 minutes.

No WPS connection exists.

3. Wireless

Solid Blue

Blinking Blue

Off

The wireless interface is enabled.

Data is being communicated over the wireless network.

The wireless interface is turned off.

4 Getting to Know Your Wireless Router

Back Panel

The router back panel, shown in Figure 3, contains port connections.

Viewed from left to right, the rear panel contains the following elements:

1. AC power adapter outlet for connecting the power adapter.

2. Power on/off push-button.

3. Four Local Area Network (LAN) 10/100 Mbps Ethernet ports for connecting the router to

your local computers.

4. Internet/Wide Area Network (WAN) Ethernet port for connecting the router to a cable or DSL

modem.

5. Restore factory settings button. Press for approximately 5 seconds to reset the router to the

factory default settings.

6. Push 'N' Connect (WPS) push-button.

4. Internet

Solid Amber

Solid Green

Blinking Green

Off

No IP address acquired.

The wireless router has acquired an Internet address.

Data is being communicated with the Internet.

No Ethernet cable is connected to the modem.

5. LAN

(Ports 1–4)

Solid Green

Blinking Green

Solid Amber

Blinking Amber

Off

The local port is connected to a 100 Mbps device.

Data is being transmitted at 100 Mbps.

The local port is connected to a 10 Mbps device.

Data is being transmitted at 10 Mbps.

No link is detected on this port.

Figure 3

Table 1. Status Light Descriptions (continued)

Label Activity Description

1 43265

Getting to Know Your Wireless Router 5

Router Label

The label on the bottom of the wireless router shows the router’s MAC address, serial number,

security PIN, and factory default login information.

The ports on the router are color-coded to distinguish your Internet port from the other four ports

that connect to the wired computer(s) on your Local Area Network (LAN).

Positioning Your Wireless Router

The wireless router lets you access your network from virtually anywhere within the operating

range of your wireless network. However, the operating distance or range of your wireless

connection can vary significantly depending on the physical placement of your router. For

example, the thickness and number of walls the wireless signal must pass through might limit the

range. For best results, place your router:

• Near the center of the area where your computers and other devices will operate, preferably

within line of sight to your wireless devices.

• Accessible to an AC power outlet and near Ethernet cables for wired computers.

• In an elevated location such as a high shelf, keeping the number of walls and ceilings between

the wireless router and your other devices to a minimum.

Figure 4

6 Getting to Know Your Wireless Router

• Away from electrical devices which are potential sources of interference, such as ceiling fans,

home security systems, microwaves, or the base for a cordless phone.

• Away from any large metal surfaces, such as a solid metal door or aluminum studs. Large

expanses of other materials such as glass, insulated walls, fish tanks, mirrors, brick, and

concrete can also affect your wireless signal.

Installing Your Wireless Router

To help you set up your router and get on the Internet quickly, the Resource CD contains a Smart

Wizard™ Installation Assistant. The Installation Assistant walks you through the steps required to

connect your router, modem, and PC(s); configure your wireless settings; and enable wireless

security for your network. When you have finished, you will be Internet ready!

You can set up your wireless router using one of two methods:

•Smart Wizard Setup: The Smart Wizard Installation Assistant setup is available on your

Resource CD. See “Installing Your Router Using the Smart Wizard” on page 9 to use the

Smart Wizard Installation Assistant.

– This is the easiest option. The wizard guides you through the setup process. It automates

many of the steps and verifies that the steps have been successfully completed.

– Smart Wizard requires a PC running Microsoft Windows.

•Manual Setup: If you cannot or prefer not to use the Smart Wizard Installation Assistant, see

“Manually Installing Your Router” on page 13. For example, if you are connecting to a Mac,

are using a Linux operating system, or are technically knowledgeable, select this option. If you

choose to use this option and install your router manually, for best results, install and set up

your router in this order:

Failure to follow these guidelines can result in significant performance degradation

or an inability to wirelessly connect to the Internet.

NETGEAR does not recommend or support adding a NETGEAR router behind

another router, or replacing a gateway with a a NETGEAR router.

If you have a Macintosh or Linux system, you must use the manual installation

method (see “Manually Installing Your Router” on page 13).

Otros manuales para RangeMax WNR1000

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Enrutador inalámbrico de NETGEAR

NETGEAR

NETGEAR DGN2200v1 Manual de usuario

NETGEAR

NETGEAR WNDR3400v3 Manual de usuario

NETGEAR

NETGEAR DGN2200 - Wireless-N 300 Router Manual de usuario

NETGEAR

NETGEAR DGN2000 - Wireless Router Manual de usuario

NETGEAR

NETGEAR DG834PN - RangeMax ADSL Modem Wireless... Manual de usuario

NETGEAR

NETGEAR RANGEMAX WNDR3300 Manual de usuario

NETGEAR

NETGEAR JNR1010v2 N150 Manual de usuario

NETGEAR

NETGEAR C7800 Manual de instalación y operación

NETGEAR

NETGEAR RBK50-100PES ORBI Manual de usuario

NETGEAR

NETGEAR Nighthawk M6 Manual de usuario

NETGEAR

NETGEAR WNHD3004 - High Performance Wireless-N HD Home Theatre... Manual de usuario

NETGEAR

NETGEAR RangeMax NEXT WNR834A Manual de usuario

NETGEAR

NETGEAR HR314 - Wireless Router Manual de usuario

NETGEAR

NETGEAR Nighthawk X6 R7900 Manual de usuario

NETGEAR

NETGEAR DGN2200v4 Manual de usuario

NETGEAR

NETGEAR MR814 - 802.11b Cable/DSL Wireless Router Manual de usuario

NETGEAR

NETGEAR JNR3000 Manual de capacitación

NETGEAR

NETGEAR WGR101 Manual de usuario

NETGEAR

NETGEAR WNR614 Manual de usuario

NETGEAR

NETGEAR WNDR3400v3 Manual de usuario

NETGEAR

NETGEAR N750 DGND4000 Manual de usuario

NETGEAR

NETGEAR WGT634U 108 Mbps Wireless Media Router WGT634U... Manual de usuario

NETGEAR

NETGEAR MR814V2 - 802.11b Cable/DSL Wireless Router Manual de usuario

NETGEAR

NETGEAR 108 MBPS WIRELESS WGT624 V3 Manual de usuario

Manuales populares de Enrutador inalámbrico de otras marcas

Milesight

Milesight UG67 Manual de usuario

Airlogic

Airlogic AirSync Class 1 Manual del propietario

Samsung

Samsung WCH730B Manual de usuario

TELEFONICA

TELEFONICA USB Adapter Manual de usuario

Askey

Askey RAC2V1K Manual de usuario

Alloy

Alloy WLF2454AP-S Manual de usuario

TP-Link

TP-Link TL-WR542G Manual de usuario

Hama

Hama 53120 Manual de usuario

Intellinet

Intellinet 524582 Manual de usuario

Asus

Asus RT-N10P Manual de usuario

D-Link

D-Link DIR-506L Manual de usuario

Sapido

Sapido GR297n Manual de usuario

Asus

Asus DSL-N55U Manual de usuario

AMTC

AMTC WR7502 Manual de usuario

Compaq

Compaq CP-2W - iPAQ Connection Point Manual de usuario

SMC Networks

SMC Networks WBR14-N2 FICHE Manual de usuario

Draytek

Draytek Vigor2120 Series Manual de usuario

Sitecom

Sitecom WLR-4000 Manual de usuario