NETGEAR CWGE111 Manual de usuario
April 2010
202-10634-01
v1.0
350 East Plumeria Drive
San Jose, CA 95134
USA
CWGE111
802.11g WiFi Receiver
User Manual
2 |
CWGE111802.11gWiFiReceiverUserManual
© 2010 NETGEAR, Inc. All rights reserved.
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated
into any language in any form or by any means without the written permission of NETGEAR, Inc.
P/N: Part Number TBD v1.0
Technical Support
When you register your product at http://www.netgear.com/register, we can provide you with faster expert technical
support and timely notices of product and software upgrades.
NETGEAR, Inc.
350 East Plumeria Drive
San Jose, CA 95134 USA
E-mail: support@netgear.com
Website: http://www.netgear.com
Phone: 1-888-NETGEAR, for US & Canada only. For other countries, see your Support information card.
Trademarks
NETGEAR, the NETGEAR logo, ProSafe, Smart Wizard, and Auto Uplink are trademarks or registered
trademarks of NETGEAR, Inc. Microsoft, Windows, Windows NT, and Vista are registered trademarks of Microsoft
Corporation. Other brand and product names are registered trademarks or trademarks of their respective holders.
Statement of Conditions
To improve internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes
to the products described in this document without notice. NETGEAR does not assume any liability that may occur
due to the use or application of the product(s) or circuit layout(s) described herein.
Revision History
Publication Part Number Version Publish Date
202-10634-01 v1.0 April 2010
TableofContents |3
Chapter 1 CWGE111 Initial Setup
About the CWGE111 802.11g WiFi Receiver . . . . . . . . . . . . . . . . . . . . . . . 5
Hardware Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
LED Descriptions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Preconfiguration Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
First Time Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Associating the Wireless Access Point . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Chapter 2 Advanced Configuration
CPE Setup Screen & Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
LAN Interface Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
DHCP Server Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Radio Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
WAN Mode Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Wireless Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Roaming Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
IP Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
AP Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
WAI Redirection Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Web Password Protection Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Restore and Reboot. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
Port Forwarding. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
DMZ Host. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
QoS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
Firmware Upgrade. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
Debug and System Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
Index
Table of Contents
Chapter1: CWGE111InitialSetup |4
CWGE111 Initial Setup
1
This chapter includes the following topics:
• About the CWGE111 802.11g WiFi Receiver
• Hardware Setup
• LED Descriptions
• Preconfiguration Setup
• Associating the Wireless Access Point
• First Time Setup
Chapter1: CWGE111InitialSetup |5
CWGE111802.11gWiFiReceiverUserManual
About the CWGE111 802.11g WiFi Receiver
Congratulations on purchasing your NETGEAR CWGE111 802.11g WiFi Receiver.
Hardware Setup
Figure 1-1 CWGE111 WiFi Receiver
To connect your modem
1. Attach the provided antenna to the antenna connector.
2. Insert the provided power adapter into the DC socket on the receiver.
3. Plug the power adaptor into an electric wall socket.
4. Connect one end of the provided Ethernet cable to the LAN port on the receiver, and the
other end to the Ethernet port on the computer.
LED Descriptions
Figure 1-2 CWGE111 LED Status Indicators
LED Description
Power - PWR Green: Power is on.
Off: Power is off.
Status - RDY Green: Device is booted.
Off: Device is not booted.
Ethernet - ENET Green: Ethernet is connected.
Blinking: Sending/Receiving data.
Off: Ethernet is not connected.
Signal bars
Green: Associated with an access point.
Back-and-forth: Searching access point.
Blinking: Acquiring IP address.
Off: Not associated with an access point.
The number of lit signal bars depends on the strength of the received signal.
More lit bars indicate a stronger signal.
6| Chapter1: CWGE111InitialSetup
CWGE111802.11gWiFiReceiverUserManual
Preconfiguration Setup
Before you begin, be sure of the following:
1. You have an active ISP account and can access the Internet.
Open a web browser (e.g, Internet Explorer, Mozilla Firefox, etc.) and visit an Internet
web site. If you successfully see the web site, you are connected. If not, you need to
establish an active Internet connection before proceeding with the installation.
2. Preconfigure your computer to automatically obtain an IP address.
If not already done, set up the LAN interface on your computer to obtain an IP address
automatically. If you are already set up for automatic IP, you should encounter no
problems with your set up.
To obtain an automatic IP address
1. Go to the Start menu
2. Open the Control Panel and then Network Connections.
3. Right click on the Local Area Connection icon
a. Choose Properties
b. Double-click on Internet Protocol (TCP/IP) from the list.
c. Check the “Obtain IP address automatically” radial button.
d. Click OK to confirm the change.
Figure 1-3 LAN interface configuration for automatic IP addressing
Chapter1: CWGE111InitialSetup |7
CWGE111802.11gWiFiReceiverUserManual
First Time Setup
Once your system is preconfigured, when you plug in your CWGE111 802.11g WiFi Receiver
User Manual, you should be automatically redirected to the connection page.
If this page (Figure 1-4) does not automatically appear, open a browser and enter
http://192.168.20.1/ in the address field.
Figure 1-4 Opening Connection Page
Connection Failed
Initially you may get a Connection Failed message. If this happens, click the Advanced
Configuration button and use the options to set the correct access point parameters.
Figure 1-5 Connection Failed
8| Chapter1: CWGE111InitialSetup
CWGE111802.11gWiFiReceiverUserManual
Associating the Wireless Access Point
When you click the Advanced Options button, you will see the CPE Setup screen:
Figure 1-6 CPE Setup Screen
To Associate the Access Point
1. Click the Advanced Option button.
1. On the CPE Setup screen, locate the Wireless Settings options.
2. In the SSID field, input the access point SSID (also called the network name).
3. Select the Authentication method. According to Access Point settings you are
associating to, you might need to choose a different Authentication setting.
4. Enter the Encryption Key if a Static WEP or WPA/WPA2-Personal is selected for
Authentication.
Additional options include 802.1x with dynamic WEP key and WPA/WPA2-Enterprise.
You do not need to use these settings unless instructed to do so by your ISP.
5. Click the Save button at the bottom of the screen.
Figure 1-7 Associate wireless access points
Chapter1: CWGE111InitialSetup |9
CWGE111802.11gWiFiReceiverUserManual
6. Click the Connect link on the top bar
7. Then click the Connect button to associate with the access point.
Figure 1-8 Establishing Connection to the Internet
Connection Established
At this point, you are associated with the access point. You can now close the web browser
and open a new one to start web browsing.
Figure 1-9 Connection Established
Chapter2: AdvancedConfiguration |10
Advanced Configuration
2
This chapter discusses the following topics:
• CPE Setup Screen & Options
• LAN Interface Settings
• DHCP Server Settings
• Radio Settings
• WAN Mode Settings
• Wireless Settings
• Roaming Settings
• IP Settings
• AP Settings
• WAI Redirection Settings
• Web Password Protection Settings
• Restore and Reboot
• Port Forwarding
• DMZ Host
• QoS
• Firmware Upgrade
• Debug and System Information
Tabla de contenidos
Otros manuales de Receptor de NETGEAR
NETGEAR
NETGEAR EVA8000-100NAS - Digital Entertainer HD... Manual de usuario
NETGEAR
NETGEAR EVA2000 - Digital Entertainer Live Manual de usuario
NETGEAR
NETGEAR EVA9100 - Digital Entertainer Express Manual de usuario
NETGEAR
NETGEAR EVA9150 - Digital Entertainer Elite Manual de usuario
NETGEAR
NETGEAR EVA9100 - Digital Entertainer Express Manual de usuario
