NETGEAR DG834PN - RangeMax ADSL Modem Wireless... Guía del usuario
October 2005
NETGEAR, Inc.
4500 Great America Parkway
Santa Clara, CA 95054 USA
Wireless ADSL Modem
Router Setup Manual
ii
v1.0, October 2005
© 2005 by NETGEAR, Inc. All rights reserved.
Trademarks
NETGEAR is a trademark of Netgear, Inc. Microsoft, Windows, and Windows NT are registered trademarks of
Microsoft Corporation. Other brand and product names are registered trademarks or trademarks of their respective
holders.
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to
make changes to the products described in this document without notice.
NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit
layout(s) described herein.
1
v1.0, October 2005
Contents
Wireless ADSL Modem Router Setup Manual
Chapter 1
Connecting the Router to the Internet
What’s in the Box? ..........................................................................................................1-1
The Router’s Front Panel .........................................................................................1-2
The Router’s Rear Panel .........................................................................................1-3
What You Need Before You Begin ..................................................................................1-3
Internet Configuration Requirements .......................................................................1-4
Understanding ADSL Microfilters .............................................................................1-4
Computers Set to DHCP ..........................................................................................1-5
Setting Up Your Wireless ADSL Modem Router .............................................................1-5
How to Set Up and Test Basic Wireless Connectivity ...................................................1-12
Implement Appropriate Wireless Security ....................................................................1-13
Chapter 2
Troubleshooting
Basic Functioning ...........................................................................................................2-1
Power LED Not On ...................................................................................................2-2
Test LED Never Turns On or Test LED Stays On .....................................................2-2
LAN or ADSL Internet Port LEDs Not On .................................................................2-3
Troubleshooting the Web Configuration Interface ..........................................................2-3
Troubleshooting the ISP Connection ..............................................................................2-4
ADSL link .................................................................................................................2-4
Obtaining an Internet IP Address .............................................................................2-5
Troubleshooting PPPoE or PPPoA ..........................................................................2-6
Troubleshooting Internet Browsing ..........................................................................2-7
Troubleshooting a TCP/IP Network Using the Ping Utility ..............................................2-7
Testing the LAN Path to Your Router .......................................................................2-7
Testing the Path from Your Computer to a Remote Device .....................................2-8
2
v1.0, October 2005
Restoring the Default Configuration and Password ........................................................2-9
Using the Reset Button ............................................................................................2-9
Appendix A
Related Documents
Connecting the Router to the Internet 1-1
v1.0, October 2005
Chapter 1
Connecting the Router to the Internet
This chapter describes how to set up the router on your Local Area Network (LAN) and connect to
the Internet. It describes how to set up your wireless ADSL modem router for Internet access and
configure basic wireless connectivity.
What’s in the Box?
The product package should contain the following items:
• Wireless ADSL Modem Router
• AC power adapter (varies by region)
• Category 5 (Cat 5) Ethernet cable
• Telephone cable with RJ-11 connector
• Microfilters (quantity and type vary by region)
•Resource CD, including:
— The Smart Wizard Installation Assistant
— This manual
• Warranty and Support Information cards
If any of the parts are incorrect, missing, or damaged, contact your NETGEAR dealer. Keep the
carton, including the original packing materials, in case you need to return the product for repair.
Wireless ADSL Modem Router Setup Manual
1-2 Connecting the Router to the Internet
v1.0, October 2005
The Router’s Front Panel
The wireless ADSL modem router front panel shown below contains status LEDs.
You can use the LEDs to verify various conditions. Table 1-1 describes each LED.
Figure 1-1
Table 1-1. LED Descriptions
Label Activity Description
1. Dome On (default)
Off 1-7 antenna lights blink indicating wireless activity.
The antenna lights are turned off.
2. Power On
Off Power is supplied to the router.
Power is not supplied to the router.
3. Test On
Off The system is initializing.
The system is ready and running.
4. PPP Link On
Off The ADSL link is active.
The ADSL link is inactive.
5. Internet Blink -- Amber
On -- Green
Blink -- Green
Indicates ADSL training.
The Internet port has detected a link with an attached device.
Data is being transmitted or received by the Internet port.
6. Wireless On
Off Indicates that the Wireless port is initialized.
The Wireless Access Point is turned off.
7. LAN
On (Green)
Blink (Green)
On (Amber)
Blink (Amber)
Off
The Local port has detected a link with a 100 Mbps device.
Data is being transmitted or received at 100 Mbps.
The Local port has detected a link with a 10 Mbps device.
Data is being transmitted or received at 10 Mbps.
No link is detected on this port.
7
234
5
1
6
Wireless ADSL Modem Router Setup Manual
Connecting the Router to the Internet 1-3
v1.0, October 2005
The Router’s Rear Panel
The rear panel of the wireless ADSL modem router contains port connections.
Viewed from left to right, the rear panel contains the following elements:
1. AC power adapter outlet
2. Four Local Ethernet RJ-45 LAN ports for connecting the router to the local computers
3. RJ-11 ADSL port for connecting the router to an ADSL line
4. Factory Default Reset push button
What You Need Before You Begin
You need to prepare the following before you can set up your router:
• Active Internet service provided by an ADSL account.
• The Internet Service Provider (ISP) configuration information for your ADSL account.
• ASDL microfilters as explained below.
• Your computers set to DHCP.
Figure 1-2
1
2
4
3
Wireless ADSL Modem Router Setup Manual
1-4 Connecting the Router to the Internet
v1.0, October 2005
Internet Configuration Requirements
Depending on how your ISP set up your Internet account, you need one or more of these
configuration parameters to connect your router to the Internet:
• Virtual Path Identifier (VPI)/Virtual Channel Indentifier (VCI) parameters
• Multiplexing Method
• Host and Domain Names
• ISP Login Name and Password
• ISP Domain Name Server (DNS) Addresses
• Fixed or Static IP Address
Your ISP should have provided you with all the information needed to connect to the Internet. If
you cannot locate this information, you can ask your ISP to provide it.
Understanding ADSL Microfilters
ADSL technology uses the same wires as your telephone service. However, ADSL adds signals to
the telephone lines which create noise in the telephone service. You must use ADSL microfilters to
filter out these signals before they reach your telephone.
Note: If you purchased the wireless ADSL modem router in a country where a microfilter
is not included, you must acquire one.
Wireless ADSL Modem Router Setup Manual
Connecting the Router to the Internet 1-5
v1.0, October 2005
ADSL Microfilter
Each device such as a telephone, fax machine, answering machine, or caller ID display will require
an ADSL microfilter.
ADSL Microfilter with Built-In Splitter
Use an ADSL microfilter with built-in splitter when there is a single wall outlet which must
provide connectivity for both the wireless ADSL modem router and telephone equipment.
Computers Set to DHCP
For the initial connection to your router, your computer has to be set to automatically get its
TCP/IP configuration from the router via DHCP. This is usually the case. The NETGEAR Smart
Wizard CD automatically takes care of this requirement. For manual setup, refer to the
documentation that came with your computer.
Setting Up Your Wireless ADSL Modem Router
There are four steps to setting up your wireless ADSL modem router:
Figure 1-3
Warning: Do not connect the wireless ADSL modem router to the ADSL line through a
microfilter unless the microfilter is a combination microfilter/splitter
specifically designed for this purpose. Doing so will prevent block your
connection to the Internet. If you have any doubts about this, connect the
wireless ADSL modem router directly to the ADSL line.
Figure 1-4
Phone
Phone
ADSL
Line
Wireless ADSL Modem Router Setup Manual
1-6 Connecting the Router to the Internet
v1.0, October 2005
1. Install ADSL filters on the phone lines.
2. Connect the router to the ADSL line.
3. Log in to the router.
4. Connect to the Internet.
Follow the steps below to connect your router to your network. Before you begin, locate the ADSL
configuration information from your Internet Service Provider (ISP).
1. Connect the ADSL filter.
a. You need to install an ADSL filter for every telephone that uses the same phone line as
your wireless ADSL modem router. Select the filter that came with your wireless ADSL
modem router.
Note: If you purchased the DG834G in a country where an ADSL filter is not
included, you must acquire one.
1. One-Line Filter: Use with a phone or fax machine.
2. Splitter: Use with a one-line filter to share an outlet with a phone and the wireless ADSL
modem router.
3. Two-Line Filter with Splitter: Use to share an outlet with a phone and the wireless ADSL
modem router.
Figure 1-5
0HONE
0HONE
!$3,
,INE
12
3
Otros manuales para DG834PN - RangeMax ADSL Modem Wireless...
3
Tabla de contenidos
Otros manuales de Módem de NETGEAR
NETGEAR
NETGEAR Nighthawk X4S D7800 Manual de usuario
NETGEAR
NETGEAR FVL328 - Cable/DSL ProSafe VPN Firewall... Manual de usuario
NETGEAR
NETGEAR DGFV338 - ProSafe Wireless ADSL Modem VPN Firewall... Manual de usuario
NETGEAR
NETGEAR LB1121 Manual de usuario
NETGEAR
NETGEAR CMD31T-100NAS Manual de usuario
NETGEAR
NETGEAR D3600 Manual de usuario
NETGEAR
NETGEAR Nighthawk CM2050V Manual de usuario
NETGEAR
NETGEAR MBM621 - 3G HSDPA Ethernet Modem Manual de usuario
NETGEAR
NETGEAR CGD24G Manual de usuario
NETGEAR
NETGEAR Nighthawk C7100V Manual de usuario
NETGEAR
NETGEAR JDGN1000 Manual
NETGEAR
NETGEAR ATT-340U Manual de usuario
NETGEAR
NETGEAR DM602 - ADSL-Modem - 8 Mbps DSL Modem Manual de usuario
NETGEAR
NETGEAR XM128S Manual de usuario
NETGEAR
NETGEAR 341U Manual de funcionamiento
NETGEAR
NETGEAR DM111P - ADSL2+ Ethernet Modem Guía del usuario
NETGEAR
NETGEAR orbi CBK40 Manual de usuario
NETGEAR
NETGEAR CM500 Manual de usuario
NETGEAR
NETGEAR DM200 Manual de usuario
NETGEAR
NETGEAR CM500 Manual de usuario
Manuales populares de Módem de otras marcas
US Robotics
US Robotics 3453C Manual de usuario
MaxTech
MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Manual de usuario
Zte
Zte MF823 Manual de usuario
Four-Faith
Four-Faith F1403 Manual de usuario
Sierra Wireless
Sierra Wireless AIRLINK MP595W Manual de usuario
Gemtek
Gemtek WiMAX WIXFBR-103 Manual de usuario