1. The SPA PROTM Massage Stone Heater should not be used if the following conditions
are present: Tuberculosis, tumors, open wounds, hemorrhages, bruises, broken skin,
thrombosis or phlebitis, varicose veins, or undetermined joint pain or pain in the calf.
2. People who are pregnant, have diabetes or other illness, should have a physicians
approval prior to receiving therapy.
3. Contact your physician if you have any questions concerning the therapeutic affects of
this appliance.
4. If you experience unusual pain, contact your physician before using the SPA PROTM.
5. Discontinue use of the SPA PROTM if you experience any discomfort from the therapy
and contact your physician.
6. Do not use this appliance when you are feeling drowsy or are going to fall asleep.
7. The SPA PROTM is not a toy. USE EXTREME CAUTION when using this appliance
and PLEASE keep children away from this appliance.
Unpack your SPA PROTM Massage Stone Heater completely and REMOVE THE WATER
RESERVIOR, ALL PACKAGING MATERIAL AND INFORMATION LABELS. Place unit
in a WELL VENTILATED AREA ON A HEAT RESISTANT SURFACE.
Turn the Temperature Control full counter-clockwise and plug the SPA PROTM into a suitable
120 volt AC outlet.
Turn the Temperature Control to the “Preheat” setting and allow the SPA PROTM to operate
for approximately 60 minutes, or until any odor or smoking disappear.
Some smoke and odor are a normal part of curing the heating element and will not occur
again during normal spa use.
When curing is completed, turn the Temperature Control full counter-clockwise to turn the
appliance off, unplug SPA PROTM from wall outlet and allow unit to cool.
Wash all stones before each use.
Place a hand towel on the bottom of the SPA PROTM water reservoir. Place all stones on
top of the towel.
Before plugging appliance into outlet, add sufficient water, fill the water reservoir to just
above the stones or fill to maximum capacity, but no more that 1-inch below the top rim.
Turn the Temperature Control full counter clockwise. Place Cover on appliance.
Plug power cord into a standard 120 VAC grounded outlet. Turn the Temperature Control to
“Preheat” position for about 20 to 30 minutes to speed warm up time. When the water
reaches the desired temperature, turn the Temperature Control to the “Operating
Range” to maintain the proper temperature.
Use an accurate thermometer to measure water temperature in the Water Reservoir to
ensure that stones are at a proper therapeutic temperature. Consult a professional
therapist for correct stone temperatures if you are unsure.
Model 4418 (18 qt version) only: The Indicator Lamp cycles off and on with the heating
element. The element is heating when the lamp is on.
Carefully remove the first stone from the SPA PROTM Water Reservoir. Test the
temperature of the stone by touching it with your finger, then hold in your hand. The
temperature should feel warm to the touch, but not uncomfortable.
When the therapy session is finished, turn the Temperature Control full counter-
clockwise to turn unit off. Always unplug appliance when not in use.
Do not drop stones into the SPA PROTM heating unit. This may damage the appliance.
Use care when removing or replacing stones.
Do not apply warm stones to areas of your body that are inflamed.
5
Before Using Your SPA PRO
For The First Time
