Copyright
This manual is an unpublished work and contains the trade secrets and confidential information of
Neptune Technology Group Inc., which are not to be divulged to third parties and may not be reproduced or transmitted in
whole or part, in anyform or by any means, electronic or mechanical for anypurpose, without theexpress written permission
of Neptune Technology Group Inc. All rights to designs orinventions disclosed herein, including the right to manufacture, are
reserved to Neptune Technology Group Inc.
Neptune engages in ongoing research and development to improve and enhance its products. Therefore, Neptune reserves
the right to change product or system specifications withoutnotice.
Trademarks used in this manual
E-Coder is a trademark of Neptune Technology Group Inc. R900 is a registered trademark of
Neptune Technology Group Inc. E-Coder)R900iis a trademark of Neptune Technology Group Inc. Other brands or product
names are the trademarks or registered trademarks of their respective holders.
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: Thisequipmenthas beentested andfoundto complywith thelimits fora ClassB digitaldevice,pursuant toPart 15of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
This equipment complies with the FCC RF radiation requirements for uncontrolled environments. To maintain compliance
with these requirements, the antenna and any radiating elements should be installed to ensure that a minimum separation
distance of 20cm ismaintained from the general population.
Professional Installation
Inaccordance withsection15.203 ofthe FCCrulesand regulations,the MIUmust beprofessionallyinstalled bytrained utility
meter installers. Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Changesor modifications not expressly approvedby the partyresponsibleforcompliancecould void
the user's authority to operate the equipment.
