Necta Kobalto Manual del propietario

PROGRAMMING MANUAL

Code: Date:P285U00

English

05 - 2007

P285U00 05 - 2007

IntroductIon

This “Programming Manual” is a very useful tool for those operators who want to get the most out of the

potential of the installed software and know in detail all of the software available functions.

This document is available in PDF format in the Reserved Area of our internet site

www.nwglobalvending.com or, on request, through our after-sales service.

The Manual is divided into 2 parts:

The First Part contains the information concerning the Filler Menu.

The Second Part contains the information concerning the Technician Menu.

The operations described can modify the functioning cycles, therefore they must be carried out only by per-

sonnel who have the specic knowledge of the machine functioning from a point of view of electrical safety

and health regulations.

IntroductIon

The machines can function in 3 different operating modes:

- Normal Vending

- Filler Menu

- Technician Menu

normal vendIng mode

In Normal Vending mode it is possible to perform some operations with the door closed, keeping pressed the

wash button “” for more than 2 seconds or the “ ” button (see gure) if the wash button is not present.

The push-buttons take on numeric values as shown in the gure:

The machine waits a few seconds for the entry of a 5-digit

code that will allow the following operations if enabled in the

Password option within the Technician Menu:

- Reset counters

- Jug Facility

- Free Vending

- Keypad lock

- Wash

- Test selections

- Filter reset

- Waste tray reset

By default all passwords are disabled.

P285U00 05 - 2007

programmIng menu

In order to access the programming menu, open the front door of the vending machine, switch on the ma-

chine and insert the yellow key supplied in the relevant slot located on the left-hand side of the machine.

Press the programming access button as shown in the gure:

The machine goes into “Filler Menu” mode.

The buttons shown in the gure are used for surng through the different menus:

Scrolling buttons UP “” and DOWN “”

The UP and DOWN scrolling buttons are used for moving from one programming menu item to the next one,

located in the same level, and at the same time change the status or the numeric value of the corresponding

functions.

Conrm / enter button “”

The conrm / enter button is used for moving to the lower level or for conrming a value after being entered

or changed.

Exit button “”

The exit button is used for returning to the higher level or for exiting a change eld of a function. When reach-

ing the highest level in the menu, this button is pressed for going from the Technician menu into the Filler

menu and vice versa.

P285U00 05 - 2007

FILLER MENU

1 - STATISTICS

1.1 - STATIS. PRINTING

1.1.1 - PARTIAl PRINTING

1.1.1.1 - SEl. CNT. PRINT.

1.1.1.2 - PRINT BAND CNT

1.1.1.3 - DISC. CNT.PRINT.

1.1.1.4 - FAIl. CNT.PRINT.

1.1.1.5 - COIN MECH. PRINT

StatIStIcS

1.1

prIntIng the StatIStIcS

1.1.1

partIal prIntout

1.1.1.1

prIntIng the SelectIon counterS

When conrming this function, the counters regarding the different

selections are printed.

1.1.1.2

prIntIng the tIme band counterS

When conrming this function, the counters regarding the different

time bands are printed.

1.1.1.3

prIntIng the dIScount counterS

When conrming this function, the counters regarding discounts

and overprice are printed.

1.1.1.4

prIntIng the faIlure counterS

When conrming this function, the counters regarding the different

failure are printed.

1.1.1.5

prIntIng the coIn mechanISm data

When conrming this function, the counters regarding the coin

mechanism data are printed.

P285U00 05 - 2007

FILLER MENU

1.1.2 - TOTAl PRINTING

1.2 - PRINT REl. STAT.

1.2.1 - PARTIAl PRINTING

1.2.1.1 - SEl. CNT. PRINT.

1.2.1.2 - PRINT BAND CNT

1.2.1.3 - DISC. CNT.PRINT.

1.2.1.4 - FAIl. CNT.PRINT.

1.2.1.5 - COIN MECH. PRINT

1.1.2

total prIntout

When conrming this function, all statistics are printed.

1.2

prIntIng the relatIve StatIStIcS

1.2.1

partIal prIntout

1.2.1.1

prIntIng the SelectIon counterS

When conrming this function, the relative counters regarding the

different selections are printed.

1.2.1.2

prIntIng the tIme band counterS

When conrming this function, the relative counters regarding the

different time bands are printed.

1.2.1.3

prIntIng the dIScount counterS

When conrming this function, the relative counters regarding dis-

counts and overprice are printed.

1.2.1.4

prIntIng the faIlure counterS

When conrming this function, the relative counters regarding

failures are printed.

1.2.1.5

prIntIng the coIn mechanISm data

When conrming this function, the relative counters regarding the

coin mechanism data are printed.

P285U00 05 - 2007

FILLER MENU

1.2.2 - TOTAl PRINTING

1.3 - STATIST. DISPlAY

1.3.1 - SEl. CNT. DISP.

1.3.1.1 - CNT DIS. X S.SEl

1.3.1.2 - TOT CNT DISPlAY

1.3.1.3 - SEl.NO.CNT. DIS.

1.3.2 - DISPlAY BAND CNT

1.3.3 - DISC. CNT. DISP.

1.2.2

total prIntout

When conrming this function, all relative statistics are printed.

1.3

dISplayIng the StatIStIcS

1.3.1

dISplayIng the SelectIon counterS

1.3.1.1

dISplayIng the SIngle counterS

This function is used for displaying the counters regarding each

selection, divided by price band (0, 1, 2, 3, 4, Free, Test).

1.3.1.2

dISplayIng the total counterS

This function is used for displaying the total counters regarding

each selection.

1.3.1.3

dISplayIng the SelectIon counterS In normal vendIng - /maIntenance

This function is used for displaying the total counters regarding the

selections made while in normal vending mode and maintenance

mode.

1.3.2

dISplayIng the tIme band counterS

When selecting the desired price band (0, 1, 2, 3, 4, Free,

Test), the total number of selections made for that price band is

displayed.

1.3.3

dISplayIng the dIScount counterS

This function is used for displaying the total amount of discounts

and overprice accumulated for the dispensed selections.

P285U00 05 - 2007

FILLER MENU

1.3.4

dISplayIng the faIlure counterS

This function is used for displaying the number of times each pos-

sible failure occurred in the vending machine.

1.3.5

dISplayIng the coIn mechanISm data

1.3.5.1

dISplayIng the audIt data

This function is used for displaying the number of coins inserted in

the vending machine, differentiated by the type of coin.

1.3.5.2

dISplayIng the caShed amount

This function is used for displaying the value of:

- Total cashed

- Total sold

- Total cashed by credit

1.4

dISplayIng the relatIve StatIStIcS

1.4.1

dISplayIng the SelectIon counterS

1.4.1.1

dISplayIng the SIngle counterS

This function is used for displaying the counters regarding each

selection, divided by price band (0, 1, 2, 3, 4, Free, Test).

1.4.1.2

dISplayIng the total counterS

This function is used for displaying the total counters regarding

each selection.

1.3.4 - FAIl. CNT. DISP.

1.3.5 - COIN MECH. DISP.

1.3.5.1 - AUDIT DATA DISP.

1.3.5.2 - CASH COUNT. DIS.

1.4 - DISP. REl. STAT.

1.4.1 - SEl. CNT. DISP.

1.4.1.1 - CNT DIS. X S.SEl

1.4.1.2 - TOT CNT DISPlAY

P285U00 05 - 2007

FILLER MENU

1.4.1.3 - SEl.NO.CNT. DIS.

1.4.2 - DISPlAY BAND CNT

1.4.3 - DISC. CNT. DISP.

1.4.4 - FAIl. CNT. DISP.

1.4.5 - COIN MECH. DISP.

1.4.5.1 - AUDIT DATA DISP.

1.4.5.2 - CASH COUNT. DIS.

1.5 - DElETE REl.STAT.

1.4.1.3

dISplayIng the SelectIon counterS In normal vendIng - maIntenance

This function is used for displaying the total counters regarding the

selections made while in normal vending mode and maintenance

mode.

1.4.2

dISplayIng the tIme band counterS

When selecting the desired price band (0, 1, 2, 3, 4, Free,

Test), the total number of selections made for that price band is

displayed.

1.4.3

dISplayIng the dIScount counterS

This function is used for displaying the total amount of discounts

and overprice accumulated for the dispensed selections.

1.4.4

dISplayIng the faIlure counterS

This function is used for displaying the number of times each fail-

ure occurred in the vending machine.

1.4.5

dISplayIng the coIn mechanISm data

1.4.5.1

dISplayIng the audIt data

This function is used for displaying the number of coins inserted in

the vending machine, differentiated by the type of coin.

1.4.5.2

dISplayIng the caShed amount

This function is used for displaying the value of:

- Total cashed

- Total sold

- Total cashed by credit

1.5

deletIng the relatIve StatIStIcS

P285U00 05 - 2007

FILLER MENU

1.5.1 - PARTIAl RESET

1.5.1.1 - SEl. CNT. RESET

1.5.1.2 - DISC. CNT. RESET

1.5.1.3 - FAIl. CNT. RESET

1.5.1.4 - COIN MECH. RESET

1.5.2 - TOTAl RESET

1.5.1

partIal delete

1.5.1.1

deletIng the SelectIon counterS

When conrming this function, the counters regarding the different

selections are deleted.

1.5.1.2

deletIng the dIScount counterS

When conrming this function, the counters regarding discounts

and overprice are deleted.

1.5.1.3

deletIng the faIlure counterS

When conrming this function, the counters regarding the different

failure are deleted.

1.5.1.4

deletIng the coIn mechanISm data

When conrming this function, the counters regarding the coin

mechanism data are deleted.

1.5.2

total delete

When conrming this function, all relative statistics are deleted.

Tabla de contenidos

Otros manuales de Cafetera de Necta

Necta

Necta Brio 250 Manual de usuario

Necta

Necta Colibri Hoja de especificaciones

Necta

Necta BRIO "Easy Serving Espresso" Manual de usuario

Necta

Necta Korinto Espresso Manual del propietario

Necta

Necta Koro Manual de usuario

Necta

Necta Colibri Manual de servicio

Necta

Necta Brio Espresso Manual de usuario

Necta

Necta Koro Manual de usuario

Necta

Necta Koro Espresso Manual de usuario

Necta

Necta Kobalto espresso Manual de usuario

Necta

Necta KORO PRIME ES Manual de usuario

Necta

Necta Korinto UL 120V Manual de usuario

Necta

Necta KORO Fresh Brew Manual de usuario

Necta

Necta KIKKO ES6 Manual de usuario

Necta

Necta Korinto UL Manual de usuario

Necta

Necta KORO FRESH-BREW Manual de usuario

Necta

Necta Koro Espresso Manual de usuario

Necta

Necta KREA TOUCH Manual de usuario

Necta

Necta Korinto Espresso Manual de usuario

Necta

Necta Necta Colibri Espresso Manual de usuario

Necta

Necta BRIO Manual de usuario

Necta

Necta Astro Guía de instalación

Necta

Necta brio 3 Manual del propietario

Necta

Necta Kikko Max P250U00 Manual del propietario

Manuales populares de Cafetera de otras marcas

Taurus

Taurus Livorno 6 Manual de usuario

Delta-q

Delta-q QUICK Manual de usuario

Bunn

Bunn LCA-1 Guía de solución de problemas

Black & Decker

Black & Decker BLACK DECKER HOME DE790 Instrucciones de instalación

Saeco

Saeco Vienna Plus Sup 018M Manual de usuario

DeLonghi

DeLonghi DC300 Manual de usuario

INCAPTO

INCAPTO BXCO1470E Manual de usuario

Bosch

Bosch TASSIMO finesse TAS16B Series Manual de usuario

Exido

Exido 245-072 Manual de usuario

Animo

Animo OptiVend Choco Manual de usuario

Siemens

Siemens TQ505DF Series Manual de usuario

DeLonghi

DeLonghi ECI341 Manual de usuario

Krups

Krups KT406511 Manual de usuario

Cimbali

Cimbali M32 Classic Manual de usuario

Philips

Philips HL3844N Manual de usuario

Bosch

Bosch TES 515 SERIES Manual de usuario

Tekmatix

Tekmatix TMFM - 65 Manual de usuario

Scarlett

Scarlett SC-CM33005 Manual de usuario