National Instruments InsightCM Manual de usuario

For information about configuring specific server and device settings, browse to

http://serverHostname:82 and click Help to launch the NI InsightCM

Configuration and Monitoring Help.

Useful Resources

For a complete list of documentation for NI InsightCM, visit ni.com/info and

enter the Info Code insightcmdocs.

Services & Support

ni.com/services

CompactRIO Specifications and Module Pinouts

Visit ni.com/info and enter insightcmdocs

AI1

AI2

AI3

AI4

AI5

Monitoring Devices

Quick Start

NI InsightCM™

376270E-01 Jul 17

Caution Before installing your device, read all product

documentation to ensure compliance with safety, EMC, and

environmental regulations.

Documentation

Ethernet Cable NI Monitoring

System

Blank USB Drive

Power Supply

Screwdriver

What You Need

Connect the controller to an Ethernet network using Ethernet port 1 on the

controller front panel.

Use a standard Category 5 (CAT-5) or better Ethernet cable to connect the controller

to an Ethernet hub.

You can start setting up devices independently from NI InsightCM Server. However, to

complete the setup, NI InsightCM Server must be online. The following ﬂowchart shows

how the device setup depends on NI InsightCM Server.

This document prompts you to complete the server-related steps when necessary to

continue setting up the device.

1. This document assumes the device is mounted as desired. For physical dimensions and

mounting instructions, refer to the Maintaining Hardware document, available by visiting

ni.com/info and entering insightcmdocs.

2. This document assumes the device is unwired. If the device is already connected to

the network, a power source, and sensors, proceed to step 4.

Where to Go Next

Connect to Network

Before You Begin

Software

installation

Device added

to server

Verify device

and prepare for

provisioning

Additional system

configuration

NI InsightCM

Server Setup

Connect to network

and sensors

Connect to power

Provision device

Verify connectivity

Device

Setup

Refer to the NI Trademarks and Logo Guidelines at ni.com/trademarks for more information on National

Instruments trademarks. Other product and company names mentioned herein are trademarks or trade names of their

respective companies. For patents covering National Instruments products/technology, refer to the appropriate

location:

Help»Patents

in your software, the patents.txt file on your media, or the National Instruments

Patents Notice at ni.com/patents. You can find information about end-user license agreements (EULAs) and

third-party legal notices in the readme file for your NI product. Refer to the Export Compliance Information at ni.com/

legal/export-compliance for the National Instruments global trade compliance policy and how to obtain relevant

HTS codes, ECCNs, and other import/export data. NI MAKES NO EXPRESS OR IMPLIED WARRANTIES AS TO THE

ACCURACY OF THE INFORMATION CONTAINED HEREIN AND SHALL NOT BE LIABLE FOR ANY ERRORS. U.S.

Government Customers: The data contained in this manual was developed at private expense and is subject to the applicable

limited rights and restricted data rights as set forth in FAR 52.227-14, DFAR 252.227-7014, and DFAR 252.227-7015.