HERA51 Mobile POS
-
6
-
BATTERY
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries
according to the instructions.
The main battery may not be charged to full for shipment. Charge the main battery to
full before using the mobile POS for the first time.
Main battery: The main battery powers the mobile POS to work. It takes approximately
4 hours to charge an empty main battery to full. For the first time charging the main
battery, please charge it for at least 8 to 12 hours.The charging LED above the screen
will light up in red while charging and will turn green when charging is complete.
When the main battery is removed, RTC retention will be maintained for at least 30
minutes.
Backup battery: The backup battery is mounted on the main board. Its role is to
temporarily keep the mobile POS in suspension when the main battery is drained out so
data in DRAM will be retained. The backup battery takes approximately 4 hours to
charge to full by the main battery or power adapter.
The allowed battery charging ambient temperature is between 0°C to 40°C.It is
recommended to charge the battery at room temperature (18°C to 25°C) for optimal
performance.
Battery charging stops when ambient temperature drops below 0°C or exceeds 40°C.
In order to prevent system from shutting down after the battery is drained out, keep a
fresh battery for replacement at all times, or connect the mobile POS to an external
power.
If there are drippings or dust on the device or battery pack, wipe them away with a soft
clean cloth before battery replacement.
Turn off the power before battery replacement.
If you want to put away the mobile POS for a period of time, remove the battery pack
from the mobile POS’s battery compartment. Store the mobile POS and battery pack
separately.
Recycle batteries in a proper way for the green-environment issue.
SCANNER
Scan a 1D barcode
1)
Open ReaderConfig and tap Scan Test on the menu bar.
2)
Aim the scanning window at the barcode to read. Move the device, having the barcode
located in the center of the scanning area.
3)
Press any of the two side triggers. The scanning light beams to read the printed barcodes.
The buzzer beeps after scanning. The scanning light goes off once the data is decoded,
or when the decode timeout period has passed.
Scan a 2D barcode
1)
Open ReaderConfig and tap Scan Test on the menu bar.
2)
Aim the scanning window at the barcode to read. Move the device, having the barcode
located in the center of the scanning area.
3)
Press any of the two side triggers. The scanning light beams to read the printed barcodes.
The buzzer beeps after scanning. The scanning light goes off once the data is decoded,
or when the decode timeout period has passed. USA and Canada e-label
