MovaNext MovaNext
10 11
Preferably fit the frame clamps as high as possible on the saddle or
frame tube of the bicycle for maximum stability.
When storing, place the bicycle carrier upright with the grip facing
upwards. You then avoid damage to the carrier.
The total length of the vehicle increases when the bicycle carrier is
assembled. The height and width can also increase. Remember this
when reversing, parking, etc.
Remove the bicycle carrier from the tow bar before you drive into a car
wash.
To save fuel it is advisable to not assemble the bicycle carrier on the
tow bar when no bicycles are being transported.
If your vehicle has a boot lid that automatically opens it is advised to
switch this function off. You then avoid damage to the bicycle carrier
and your vehicle.
Go to www.movanext.com for accessories and more information on
how to use the bicycle carrier in a more simple way.
The 13-pole plug socket works with a bayonet catch so the plug
turns a quarter turn and is firmly fixed. Should the plug not fit in the
connection on your car check if:
• the notch in the plug matches the recess in the socket on the car
(see figure).
• the 3 slots in the plug are correctly positioned for the notch in the
socket (see figure).
• the pins are correctly positioned
for the notch (see figure).
1.
2.
3.
4.
5.
6.
7.
8.
4 Tips 5 Fitting the bicycle carrier
1. Assembling the bicycle carrier on the
tow bar
Make sure that the tow ball is not dirty or greasy.
Fit the bicycle carrier slightly tilted towards you on
the tow bar then bring it upright.
2. Loosen the clip
The two blades are kept together by a clip. Loosen
the clip in order to fold the blades out. The two
blades are kept together by a clip. Loosen the clip
in order to fold the blades out.
3. Fold out the right-hand blade
Fold the right-hand blade downwards to make it
horizontal. Keep the central tube as vertical as
possible.
You can release the bicycle carrier; it is now
clamped on the tow bar.
4. Connect the plug
Take the plug from the holder and insert it in the
car’s plug socket. The plug has a 7- and a 13-pole
side. Cover the unused plug part with the cap
supplied.
