GETTING THE MOST OUT OF MORFIT
FIND THE BEST FIT
For your rst 10 trips, it’s a good idea to practice resetting Mort every time you go
on a drive. This will help you nd just the right t.
CHECK THE POSITION ON EVERY TRIP
We highly recommend that you take a second to place Mort into its exact sweet
spot, as it can move a bit when you get in and out of the vehicle.
WHEN TO RESET MORFIT
You will need to reset Mort every few weeks. If you can feel it softening, it needs
resetting.
TRANSFERRING MORFIT BETWEEN VEHICLES
Mort shapes and holds to t you and your seat. Every seat is a different shape so
you will need to reset Mort when you move it to another vehicle.
USING MORFIT IN CHAIRS
While Mort is designed to give you support in vehicles, it can be used in any type
of seat or chair. Remember to reset Mort when you move it from one seat to
another.
IF MORFIT FEELS TOO THICK
If you have an in-built lumbar support, make sure that this is as small as possible.
When Mort is taking the shape of your back (during “3. GOOD POSTURE”) wriggle
in and push rmly with your back where you want Mort to be thinner.
IF MORFIT FEELS LUMPY OR UNEVEN
Sometimes Mort can feel asymmetric or lumpy and will need a really good shake
to work properly again. If this happens, follow the steps for the ‘SOFTENING’ phase
(two lights), but this time give it a really good shake for a full 10 seconds.
If all else fails, remove Mort from the seat. Holding Mort from the top of the cover,
press ON. During the SOFTENING phase (two lights) give it a good shake. Let the
cycle nish, before putting it behind your back and following the normal set-up steps
again.
