Monstertech STAND Manual de usuario

STAND

Instruction Manual EN

STAND INSTRUCTION MANUAL

1 General information

Congrats on your brand new MONSTERTECH Stand!

This guide is meant to help you assemble your Stand as smoothly as possible. If you still have

questions about the assembly process, please contact [email protected] or support@

monstertechusa.com.

1.1 Before you start

Before you start the Stand assembly, we are going to look at some common assembly steps

and often used parts, as well as required tools.

1.1.1 Required Tools

For our Stand assembly, we need the following tools*:

- Hex key set with ball head with extension

- Rubber or plastic mallet

- Flat head screwdriver

- Tape measure w/ millimeters

*Tools are not included with the Sim Rig

STAND INSTRUCTION MANUAL

1.1.2 Inserting T-Nut into Profile

There are two ways to insert the M8 T-Nuts into the respective prole groove; refer to Figure 1

and 2 respectively.

Figure 1: Slide in from side

Figure 2: Rotate in from top

STAND INSTRUCTION MANUAL

1.1.3 Universal Fastener Assembly

The universal fastener assembly can be prepared the following way, so long as the T-Nut can

be slid in from the side. One Universal Fastener Assembly is made up from one (1) M8x30 Hex

Screw, one (1) T-Nut, and one (1) Universal Fastener.

Figure 3: Universal fastener assembly

If inserting the universal fastener assembly from the side is not possible, it is necessary to rota-

te the T-Nut into the prole groove rst, and then screw the M8x30 bolt (along with the univer-

sal fastener) into the T-Nut.

STAND INSTRUCTION MANUAL

1.1.4 Angle Bracket Stud Removal

Sometimes it might be necessary to break off the studs from angle brackets (if those are part

of the product). This is best achieved by:

1. Inserting a at-head screwdriver between the stud and the bracket, and then

2. Rotate the screwdriver for the stud to come off

STAND INSTRUCTION MANUAL

1.1.5 Angle Bracket Assembly

For some assemblies the use of angle brackets is required. These are prepared by using two

(2) M8x18 hex screws, two (2) washers, and two T-Nuts.

Figure 5: Angle bracket assembly

1.1.6 Adjustment of Profile Feet

The prole feet are installed on the MTX Base Stand, MTX Stand-Alone TV or Stand.

Figure 6: Prole feet

STAND INSTRUCTION MANUAL

2 Overview

2.1 Completed Stand

Stand - Overview

Figure 8: Complete Stand

Use the above image as reference for the following Stand assem-

bly instructions.

STAND INSTRUCTION MANUAL

3.1

Figure 9: Stand assembly - step 1

3.2

Figure 10: Stand assembly - step 2

STAND INSTRUCTION MANUAL

3.3

Figure 11: Stand assembly - step 3

3.4

Figure 12: Stand assembly - step 4

STAND INSTRUCTION MANUAL

3.5

Figure 13: Stand assembly - step 5

3.6

Figure 14: Stand assembly - step 6

Tabla de contenidos

Otros manuales de Rack y soporte de Monstertech

Monstertech

Monstertech MTS CENTER JOYSTICK Manual de usuario

Monstertech

Monstertech MTX HOTAS Manual de usuario

Monstertech

Monstertech MFD Manual de usuario

Monstertech

Monstertech JOYSTICK/HOTAS TABLE MOUNT Manual de usuario

Monstertech

Monstertech CHAIR MOUNT UNIVERSAL BASE Manual de usuario

Monstertech

Monstertech CHAIR MOUNT INSTRUMENT CARRIER Manual de usuario

Monstertech

Monstertech MFD/TABLET MOUNT CENTER Manual de usuario

Monstertech

Monstertech Wall Holder Manual de usuario

Monstertech

Monstertech CHAIR MOUNT KEYBOARD TRAY Manual de usuario

Monstertech

Monstertech FLIGHT STAND Manual de usuario

Manuales populares de Rack y soporte de otras marcas

Salamander

Salamander Acadia AC/W/L400/WH Manual de usuario

Fohhn

Fohhn VAT-09 Guía del usuario

ricoo

ricoo FS0522 Manual de usuario

AMSOIL

AMSOIL BMK-22 Guía rápida

Kargo Master

Kargo Master 48220 Manual de usuario

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manual de usuario

ricoo

ricoo S1222 Manual de usuario

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manual de usuario

VidaBox

VidaBox VB MNT FFS2 Manual de usuario

Welch Allyn

Welch Allyn 48960 Manual de usuario

Arkon

Arkon CM035-ST-2 Manual de usuario

PROEL

PROEL PLWIN60C Manual de usuario

Agilent Technologies

Agilent Technologies E2609B Manual de usuario

Mustang

Mustang MV-ARM4 Manual de usuario

Mounting Solutions

Mounting Solutions WRM-320 Manual de usuario

Pyle

Pyle PMKSPAD1 Manual de usuario

ShelterIt

ShelterIt 21208 Manual de usuario

SPL

SPL RackPack?4 1040 Manual de usuario