molex HDAC .64 Series Manual de usuario
HDAC 0.64 User Manual 4
This instructions manual contains supplemental information pertaining to
the Molex HDAC 0.64 Product Line.
For product ordering information, please contact your Molex Inside Sales
Representative at (800)786-6539.
For electronic copies and future updates of this document, and the
Connector Reference Manual, refer to the Molex Website at
http://www.molex.com
Section 1: Product Introduction
Downloaded from Elcodis.com electronic components distributor
HDAC 0.64 User Manual 6
Section 2: Product Summary
Molex Receptacle Terminal
PN 34083-3001
•Base Material
9Copper Alloy
•Plating Options
9Tin, Gold
•Wire Sizes:
916,18,20,22 AWG
TYCO Blade Terminal
•Base Material
9Copper Alloy
•Plating Options
9Tin, Gold
•Wire Sizes:
916,18,20,22 AWG
Downloaded from Elcodis.com electronic components distributor
HDAC 0.64 User Manual 8
Section 3: Connector Assembly
B. Terminal Installation:
With TPA still in pre-lock position, orient terminal to rear of connector as shown below.
Grip the wire no less than 1.25 inches from the terminal insulation crimp and insert through appropriate
circuit opening.
If resistance is encountered, retract the terminal and adjust the angle of insertion.
Continue inserting the terminal until it stops and locks up on the lock finger with an audible click.
Correct Orientation Correct Orientation
Terminal orientation feature.
Cross section of proper
installation
Downloaded from Elcodis.com electronic components distributor
HDAC 0.64 User Manual 9
C. Seating the TPA
With the receptacle terminals fully installed, the TPA can be seated into its final lock position by applying
an even force to the TPA surface until it comes to a stop, with an audible click.
With the blade terminals fully installed, the TPA can be seated into its final lock position by applying an
even force to the TPA surface until it comes to a stop, with an audible click.
Section 3: Connector Assembly
Push uniformly on TPA main surface
only to fully seat – being careful not
to touch the blade terminals. It is
recommended that a non-metal tool
is use to seat the TPA. This will limit
the possibility of damaging the blade
terminals.
Downloaded from Elcodis.com electronic components distributor
HDAC 0.64 User Manual 10
Note and align connector keying
features, from receptacle
connector to blade connector.
Begin mating procedure by
sliding the receptacle connector
assembly and blade connector
assembly together, press firmly
until you hear an audible click.
Keying Features
Section 4: Connector Mating
CLICK
Downloaded from Elcodis.com electronic components distributor
Tabla de contenidos
Otros manuales de Cables y conectores de molex
molex
molex 62200-7700 Manual de usuario
molex
molex Milli-Grid Dual row 87568 Series Manual de usuario
molex
molex EXTreme PowerMass 75555 Series Manual de usuario
molex
molex Shielded DataGate Manual de usuario
molex
molex Pico-Lock 1.0 Manual del propietario
molex
molex MX150 Guía del usuario
molex
molex CLIK-Mate 1.5 SINGLE Series Manual de usuario
molex
molex Mini50 series Guía del usuario
molex
molex PicoBlade 1.25 DIP Guía del usuario
molex
molex MX123 Manual de usuario
