customerservice@modernames.com modernames.com
o Bubble Level
o Drill/Impact Driver
o #2 Robertson (Square) Drive Bit
o #2 Phillips (Cross) Drive Bit
o Tape Measure
o Pencil/Marker
o Soft Face Mallet/Rubber Mallet
o #2 Phillips Screwdriver
(Fireplace install)
Assembly, Tools, Parts & Hardware List
TOOLS REQUIRED
#1 - Locate & prep wall for install, measure to verify best t.
• Main unit requires 6 foot wide by 8 foot high area
• Main unit plus 1 side shelf wall requires 8 foot wide by 8 foot high area
• Complete wall unit - Main plus 2 side shelf walls requires 10 foot wide by 8 foot high area
#2 - Locate center of wall where unit will be installed, MARK center point
• CENTER MARK @ 57"/58", from the oor, as your CENTER POINT for mounting and
securing unit (Fig A).
• Locate studs in wall for mounting
main unit & side shelf walls.
• Locate DEDICATED OUTLET(S) within
the highlighted area of main unit to
mount (Fig A).
Note: OUTLET POWER For replace only,
a dedicated 15 amp circuit is required.
OUTLET POWER For replace and television,
a dedicated 20 amp circuit is required.
Fig A
INSTALL PREP
