Minuteman CPE 1000 Manual de usuario

CPE On-Line Series Quick Install Procedure

Please read all of the WARNINGS, CAUTIONS and the User’s Manual before attempting to

install or service the UPS.

WARNING: This UPS contains potentially hazardous voltages. Risk of Electrical shock. The internal batteries

energize hazardous live parts inside this UPS even when the AC input power is disconnected.

NOTE: Installing or Servicing of the UPS must be performed by Qualified Service Personnel ONLY. MINUTEMAN

accepts no liabilities and is not limited to: injury to the Service Personnel, or damages to; the UPS, or the connected

equipment caused by the incorrect installation or servicing of the UPS.

NOTE: These UPSs are shipped with the batteries disconnected. The batteries must be connected before putting these

UPSs into service.

CAUTION: Although battery system voltages are 36VDC, 72VDC and 96VDC the battery system can still present a risk

of electrical shock. These batteries produce sufficient current to burn wire or tools very rapidly, producing molten metal.

Observe these precautions when installing or servicing the batteries:

1. Remove watches, rings, or other metal objects.

2. Use hand tools with insulated handles.

3. Wear protective eye gear (goggles), rubber gloves and boots.

4. Do not lay tools or other metal parts on top of batteries.

5. Disconnect the charging source prior to connecting or disconnecting the battery terminals.

6. Determine if the battery is inadvertently grounded. If the battery is, remove the source of the grounding. Contact

with any part of a grounded battery can result in an electrical shock. The likelihood of such shock will be reduced, if

such grounds are removed during installation and maintenance.

INSTALLATION

Be sure to read the installation placement and all the cautions before installing the UPS. Place the UPS in the final

desired location and complete the rest of the installation procedure. These UPSs are shipped with the internal batteries

disconnected. The batteries must be connected before putting these UPSs into service. Follow the procedure below to

connect the batteries. USE CAUTION: The UPS is heavy. Use the appropriate number of personnel when installing the

UPS.

AC F U S E

1. Remove the UPS from the shipping box and set on the floor or a bench top.

2. Remove the cover screws.

3. Remove the cover.

4. Verify that the voltage and frequency ratings match that of the Utility power, and then connect the AC Input power

cord into a two-pole, three-wire grounded receptacle only. Do not use extension cords, adapter plugs, or surge strips.

5. Wait for approximately 10-seconds until the Green Utility LED (#6) on the front panel turns on.

6. Connect the Battery Negative (Black) wire to the Battery Negative terminal.

7. Disconnect the UPS’s AC Input power cord from the wall outlet.

8. Re-install the cover.

9. Re-install the cover screws.

10. Plug the equipment into the output receptacles on the rear panel of the UPS. Do not use extension cords, adapter

plugs or surge strips on the output of the UPS. Ensure that the load does not exceed the maximum output rating of

the UPS (refer to the information label on the UPS or the Electrical Specifications in the User’s Manual).

11. Plug the UPS’s AC Input power cord into the wall outlet.

12. Press the Main switch on the front panel to turn on the UPS. The fan on the rear panel will start.

13. After 7~10 seconds, the start-up of UPS will be completed, then the "Utility" LED and Inverter" LED will illuminate

simultaneously.

14. Turn on the connected equipment.

15. Press and hold the Test/Alarm Silencer Button for 10-seconds to perform a Self-Test to verify proper operation of the

UPS.

16. The installation is complete the UPS is ready for normal operation. See the UPS User’s Manual for more detailed

information.

CPE 1000, CPE 1000i, CPE 1000PP CPE 2000, CPE 2000i, CPE 2000j

2KVA

3KVA 1KVA

CPE 3000, CPE 3000i

34000268 R6

1. Main Switch This is to turn the UPS on/off.

2. Self-Test OK LED Green LED illuminates if the self-test is O.K.

3. Test/Silence a. Alarm Silence.

b.1.For Standard Unit: Self-Test. Press the

button over 10 sec.

b.2.For Unit with Manual Bypass

function(Special order required): Press the

button over 5 seconds, the UPS will be

switched to Bypass mode and vice versa.

c. Displays the percentage of output load

level in AC Mode, and the battery capacity in

the Battery Mode.

4. Fault LED Red LED illuminates if the UPS detects an

Internal Fault.

5. Bypass LED Amber LED illuminates when UPS is in

Bypass mode.

6. Utility LED a. AC normal: Green LED illuminates.

b. 100% for load levels & battery capacity.

7. Inverter LED a. Inverter On: Green LED illuminates.

b. 75% for load levels & battery capacity.

8. Low Battery

Warning LED

a. Battery Low: Red LED illuminates.

b. 50% for load levels & battery capacity.

9. Overload LED a. Overload condition: Red LED illuminates.

b. 25% for load levels & battery capacity.

Este manual sirve para los siguientes modelos

Otros manuales de Unión Postal Universal de Minuteman

Minuteman

Minuteman MCP-E Manual de usuario

Minuteman

Minuteman ED6200RM Manual de usuario

Minuteman

Minuteman SentryII UPS Manual de usuario

Minuteman

Minuteman Encompass EC1000RT2U Manual de usuario

Minuteman

Minuteman CPE 1000 On-Line Series Instrucciones de uso

Minuteman

Minuteman ED6000RMXFMR Manual de usuario

Minuteman

Minuteman Pro Series Manual de usuario

Minuteman

Minuteman Pro 2200r Manual de usuario

Minuteman

Minuteman AT300 Manual de usuario

Minuteman

Minuteman Endeavor ED1000RTXL2U Manual de usuario

Minuteman

Minuteman Entrust-LG Series Manual de usuario

Minuteman

Minuteman PRO-E Manual de usuario

Minuteman

Minuteman CPE 1000 On-Line Series Manual de usuario

Minuteman

Minuteman MCP 1000 Manual de usuario

Minuteman

Minuteman PARASHIELD 1224 Manual de usuario

Minuteman

Minuteman ETR550LCD Manual de usuario

Minuteman

Minuteman MN 325/MN 525 Manual de usuario

Minuteman

Minuteman EN750LCD Manual de usuario

Minuteman

Minuteman ERS1500RTNC Manual de usuario

Minuteman

Minuteman 6-10KVA Tower Manual de usuario

Minuteman

Minuteman MBK Series Manual de usuario

Minuteman

Minuteman MBK-E SERIES Manual de usuario

Minuteman

Minuteman PRO1100E Manual de usuario

Minuteman

Minuteman EN750 Manual de usuario

Manuales populares de Unión Postal Universal de otras marcas

Pylontech

Pylontech Victron & Pylontech US5000 Manual de usuario

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Manual de usuario

Mecer

Mecer ME-1000-WTU Manual de usuario

Mustek

Mustek PowerMust 530(B) Plus Manual de instalación y operación

Emerson

Emerson Liebert NXL series Manual de usuario

MAKELSAN

MAKELSAN BOXER SERIES Manual de usuario

Block

Block PC-0524-400-0 Manual de usuario

CyberPower

CyberPower CP585LCD Manual de usuario

Eaton

Eaton 3S Instrucciones de montaje

CyberPower

CyberPower Office Tower Series UPS 1000 Manual de usuario

CyberPower

CyberPower BM100 Manual de usuario

Best Power

Best Power 610 Manual de usuario

Best Power

Best Power Unity/I UT3K Manual de usuario

Mustek

Mustek PowerMust 400 Offline Manual de usuario

Xantrex

Xantrex Trace 512 UR-UPS Manual de usuario

Forza

Forza SL-1501UL Manual de usuario

LEGRAND

LEGRAND keor 310081 Manual de usuario

ABB

ABB Conceptpower DPA 500 Manual de usuario