Miele KM 3464 Manual de usuario

Installation Instructions

KM 3464, KM 3465 en - CA

KM 3474, KM 3475

KM 3484, KM 3485

Installation, repair and maintenance work should be performed by

a Miele authorized service technician in accordance with national

and local safety regulations and the provided installation instructions.

Installation

The minimum distances given in

these Installation instructions are to

combustible surfaces, and must be

observed to ensure safe operation.

Failure to do so increases the risk of

fire.

The cabinetry and venting hood

should be installed first to prevent

damage to the cooktop.

~Gas appliances should only be

installed in a well ventilated area.

~The countertop must be bonded

with heat resistant (212 °F/100 °C)

adhesive to prevent distortion or

dissolving.

~The cooktop should only be installed

as shown in the illustrations while

maintaining the required safety

distances shown. Do not install the

cooktop between two tall cabinets, this

is a fire hazard.

a= indicates cooktop cut-out

b= minimum distance between

cut-out and a tall cabinet:

12" (305 mm)

~This appliance has not been

designed for maritime use or for use in

mobile installations such as recreational

vehicles or aircraft. However, under

certain conditions it may be possible for

installation in these applications. Please

contact the Miele Technical Service

Department with specific requirements.

recommended

not recommended

not allowed

IMPORTANT SAFETY INSTRUCTIONS

~The cooktop must not be installed

over a dishwasher, washer, dryer,

refrigerator or freezer. Heat radiated by

the cooktop may damage the

appliances.

~Deep fat fryers must not be installed

next to gas cooktops. Gas flames can

ignite splattering oil. A distance of at

least 12" (305 mm) should be

maintained between these two

appliances. The minimum distance

between two cooktops must be 4"

(100 mm).

~Install the appliance so that the

power cord or gas piping does not

come into contact with any portion of

the cooktop which may become hot

during use.

This appliance must be installed

with its own shut off valve and the

included gas pressure regulator.

Both the valve and the regulator

must be easily accessible to the

consumer after the appliance is

installed.

This appliance must be

disconnected from the gas supply

during any pressure testing of the

system performed in excess of

1/2psi (3.5 kPa). This appliance

must be isolated at test pressures

equal to or less than 1/2psi

(3.5 kPa).

Any pipe connections must be made

using a thread sealant approved for

gas connections. Failure to correctly

install these items could lead to a

gas leak and subsequent explosion.

Safety distances above the

appliance

There must be a safety distance of at

least 30" (760 mm), cbetween the

appliance and any objects above it.

The overhead cabinet depth, d,if

unprotected, must not exceed 13"

(330 mm). The minimum distance of

combustible surfaces located above

and to the sides of the cooktop, e,is

18" (457 mm).

If the cabinet manufacturer

recommends a greater distance, follow

that manufacturers recommendation.

When installing the cooktop under a

venting hood, always observe the

minimum distance recommended by

the hood manufacturer.

Keep this instruction book in a safe

place for reference and pass it on to

any future user.

IMPORTANT SAFETY INSTRUCTIONS

KM 3464 / KM 3465

aFront

bBuilt-in depth

cGas connection R ½" NPT

dMains connection box

Appliance dimensions

(762 mm)

(720 mm)

( 635mm)0

(542 mm)

5/16"

3/8"

R4mm)

(

3/16"

( 70mm)

3/4"

020mm)

(

13/16"

25"

(518 mm)

( mm)69

(190mm)

(58mm)

(83mm)

(78mm)

9mm

3/8"

1/16"

1/2"

11/16"

1/4"

(215mm)

7/16"

3/8"

7/8"

( 7mm)4

5/16"

1/16"

KM 3474 / KM 3475

aFront

bBuilt-in depth

cGas connection R ½" NPT

dMains connection box

Appliance dimensions

(58mm)

ß3/16"

(889 mm)

(542 mm)

(914 mm)

(9mm)

3/8"

5/16"

( R4mm)

( 47mm)

7/8"

-1

( 70mm)

3/4"

3/8"

(518 mm)

5/16"

( 635mm)

25"

13/16"

020mm)

(170mm)

(142mm)

(226mm)

(86mm)

3/8"

7/8"

11/16"

9/16"

(78mm)

1/16"

(185mm)

5/16"

1/16

1/16"

(80mm)

1/8"

KM 3484 / KM 3485

aFront

bBuilt-in depth

cGas connection R ½" NPT

dMains connection box

Appliance dimensions

ß3/16"

5/16"

(542 mm)

(1079 mm)

(9mm)

3/8"

1/2"

( R4mm)

( 635mm)

( 20mm)

13/16"

(87mm)

(307,5mm)

(228mm)

(1054 mm)

1/2"

70mm

3/8"

( 47mm)

(518 mm)

1/8"

7/16"

(83mm)

3/4"

(220mm)

11/16"

(86mm)

3/8"

1/16"

1/4"

(58mm)

5/16"

7/8"

(78mm)

1/16"

^Prepare the work top cut-out as

shown in the diagram.

Rember to maintain the minimum

safety distances to combustible

surfaces:

-23/4" (70 mm) between the cut-out

and the back wall and

- 12" (305 mm) between the cut-out

and a side wall or tall unit to the right

or left of the cut-out.

(See "Important Safety instructions").

^Seal the cut surfaces with a suitable

heat-resistant sealant to avoid

swelling caused by moisture.

If during installation, the corners of

the frame are not flush with the work

top surface, the corner radius (max.

3/16" [4 mm]) can be carefully filed to

fit.

Installation

Setting the cooktop into place

^After removing the protective

backing, d, stick the supplied seal,

c, under the edge of the cooktop.

^Screw the gas regulator onto the

nipple underneath the cooktop. (See

“Gas Connection - Gas pressure

regulator”.)

^Feed the power cord through the

cut-out to the power outlet.

^Set the cooktop in the cut-out and

center it.

Install the appliance so that the

power cord and gas piping does not

come in contact with any portion of

the cooktop which may become hot

during use.

Securing the cooktop

^Secure the cooktop with the included

fixing bracket.

Countertop 13/16" (20 mm)

Countertop 1 9/16" (40 mm)

Installation

The sealing strip under the edge of the

top part of the cooktop provides a

sufficient seal for the worktop.

Do not let sealant get in between the

cooktop frame and the worktop.

This could cause difficulties if the

cooktop ever needs to be taken out

for servicing and possibly result in

damage to the cooktop frame or the

worktop.

Installation

This appliance must be grounded

according to local or national codes.

All electrical work should be

performed by a qualified electrician

in accordance with local codes and

with the:

- National Electrical Code

ANSI / NFPA No. 70

for the USA

- Canadian Electrical Code Part I

for Canada

(CSA Standard C 22.1).

,WARNING

Disconnect the appliance from the

main power supply before

installation or service. To reduce the

risk of electric shock, make sure that

the appliance is properly grounded

after installation.

Power supply

The automatic ignition requires that the

cooktop be connected to a 120 VAC,

60 Hz power supply. The supply line

should be protected by a 15 A fuse.

Actual power consumption (during

ignition only) is 25 W.

This appliance is equipped witha4ft.

(1.2 m) long power cord that is ready

for connection to the appropriate outlet.

Place the power outlet so that it is

accessible after the appliance has

been installed in the countertop.

This appliance is equipped with a

three-prong grounding plug to

prevent shock hazards. It should be

plugged directly into a properly

grounded outlet. Do not cut or

remove the grounding prong from

the plug. If the plug does not fit the

outlet, have the proper outlet

installed by a licensed electrician.

To guarantee the electrical safety of

this appliance, continuity must exist

between the appliance and an

effective grounding system. It is

imperative that this basic safety

requirement be met. If there is any

doubt, have the electrical system of

the house checked by a qualified

electrician.

Note to the installer

Please leave these instructions with the

consumer or the appliance.

Electrical connection

Otros manuales para KM 3464

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Placa de cocina de Miele

Miele

Miele CS 1018 G Manual de usuario

Miele

Miele KM 6366-1 Manual de usuario

Miele

Miele GAS COMBISET CS 1011 Manual de usuario

Miele

Miele KM 362 G Manual de usuario

Miele

Miele KM 3010 Manual de usuario

Miele

Miele GAS COMBISET CS 1012 Manual de lista de piezas

Miele

Miele KM 5656 Manual de usuario

Miele

Miele CSAF 400 Manual de usuario

Miele

Miele KM 87-2 Manual de usuario

Miele

Miele KM 360 Manual de usuario

Miele

Miele KM 5676 Guía del usuario

Miele

Miele HR 1124 Manual de uso y cuidado

Miele

Miele MasterChef KM421 Manual de usuario

Miele

Miele CS 1112 Manual de usuario

Miele

Miele GAS COMBISET CS 1011 Manual de usuario

Miele

Miele CS 1028 Manual de usuario

Miele

Miele KM 400 Manual de usuario

Miele

Miele KM 7720 FR Manual de usuario

Miele

Miele KM 7404 FX Manual de usuario

Miele

Miele MasterChef KM342 Manual de usuario

Miele

Miele KM 6350 Manual de usuario

Miele

Miele KM 3474 Manual de usuario

Miele

Miele KM 404 Manual de usuario

Miele

Miele KM 6322 Manual de usuario

Manuales populares de Placa de cocina de otras marcas

Bonnet

Bonnet OPTIMUM 700 Manual del propietario

Jenn-Air

Jenn-Air JGCP430 Manual de usuario

Frigidaire

Frigidaire FES367FCC Guía de inicio rápido

Ztove

Ztove EZ2 DUO Manual de usuario

Kleenmaid

Kleenmaid cooking GCTK9011 Guía de instalación

Casselin

Casselin CSASRE24 Manual de usuario

Jenn-Air

Jenn-Air JGC2536EB00 Manual de usuario

Waldorf

Waldorf RN8603E-B Manual de instrucciones

Whirlpool

Whirlpool SMP658CNEIXL Manual de usuario

Wolf

Wolf CI243C/B Manual de usuario

Fulgor Milano

Fulgor Milano F5PGK305S1 Manual de usuario

GE JP389 Manual de usuario

Wells

Wells WV-2HFG Manual de usuario

IKEA

IKEA Lagan HGA4K Manual de usuario

Samsung

Samsung NA36N9755 Manual de usuario

Lacor

Lacor 69562 Hoja de especificaciones

Keating Of Chicago

Keating Of Chicago MG-2 Manual de usuario

Jenn-Air

Jenn-Air CCE1400 Manual de usuario