Strada S. Caterina, 235
41122 Modena Italy
Tel. +39 059 420411
Fax +39 059 2539 3
www.microdetectors.com
COLUMN FOR LS LIGHT CURTAINS
LANGUAGE
Instruction manual ENGLISH
M.D. Micro Detectors CAT8BST1253901 5/8
COLUMN FOR LS LIGHT CURTAINS
These mo nting instr ctions contain information abo t:
•The correct mo nting of the light c rtains LS inside the ST CLS col mns.
•The assembly of the ST CLS stand for mo nting on the ST FLEX / ST FIX stand bottom.
•The correct mo nting of emitters and receives (with o r witho t mirror).
•Please find detailed information abo t the f nction of the light c rtains / light grids in the relevant mo nting and
wiring instr ctions.
Mounting on the ST FLEX/ST FIX stand bottom (Fig. 1)
•Mo nt the ST FLEX / ST FIX stand bottom on the floor (see mo nting instr ction for stand bottom).
Please note: For a correct alignment, please verify that the stand bottom pper s rface is even and horizontal ( sing
a circ lar spirit level).
To operate the reg lation, act on the three hexagonal n ts B (fig.4) ntil the perfect levelness is reached. (Maxim m
adj stment: 10mm). If the gro nd ro ghness is over 10mm, fl sh it adeq ately.
•Loosen the three allen screws and remove the washers.
•Assembly the col mn to the stand bottom, centering the ST CLS col mn rotation flange with the g ides of the ST
FLEX / ST FIX stand bottom pper plate.
•Fix the col mn tightening the three allen screws and the washers.
Figure 1
Mounting of LS light curtains
Remove the cover (with spirit level) from the top of the col mn;
Insert the hexagonal-head screws (A) in the holes of the col mn fig.2 step 1;
T rn the hexagonal-head screws once to inserts (B) fig.2 step 2;
Insert the barrier from the top into the col mn, (make s re that all the inserts slide in the slot on the back of the barrier,
fig.2 step 3);
When correct position achieved, (see table 1) lock the hexagonal-head screws to fix the barrier.
Fix the cover on the top of the col mn.
