R60AFD1-Fall detection module using guide
501, West Block, Phase II, Tian 'an Innovation Technology Plaza, Futian District, Shenzhen
7. Radar Installation Instructions
7.1. Working range of radar module
The beam coverage of the R60AFD1 radar module is shown in the figure
below. The radar coverage is a three-dimensional sector of 100 °
horizontally and 100 ° vertically.
Schematic diagram of R60AFD1 radar coverage area
7.2. Radar installation direction and detection range
7.2.1 . Overhead installation
*To ensure the accuracy of radar detection, please install it on the
top!
radar is installed vertically, and the horizontal deviation angle
is ≤ 5 ° to ensure that the main beam of the radar covers the
detection area; the recommended installation height of the radar is 2
meters ≤ H ≤ 3 meters; there are no obvious obstructions and
coverings in front of the radar.
Affected by the installation height of the radar and the range of the
radar beam, in this installation mode, the maximum radius of moving
human detection is R3 ≈ 3 meters; the maximum radius of human
stationary detection is R 2 ≈ 2.25 meters ; the fall detection radius
R 1 ≤ 2 meters.
Detection range
When the overhead radar detects human activity, the trigger range is
about 4 meters * 6 meters, the detection range when the human body is
stationary is 4 meters * 4.5 meters , and the human fall detection range
is ≤ 2 meters.
